* [PATCH 1/3] ARM: configs: at91: sama5: add support for KSZ ethernet switches
@ 2020-07-23 16:24 ` Codrin Ciubotariu
0 siblings, 0 replies; 8+ messages in thread
From: Codrin Ciubotariu @ 2020-07-23 16:24 UTC (permalink / raw)
To: linux-arm-kernel, linux-kernel
Cc: alexandre.belloni, arnd, ludovic.desroches, Razvan Stefanescu,
Codrin Ciubotariu, cristian.birsan
From: Razvan Stefanescu <razvan.stefanescu@microchip.com>
Enable DSA and KSZ9477 support as modules. Ethernet switches are used by
the SAMA5D2-ICP board.
Signed-off-by: Razvan Stefanescu <razvan.stefanescu@microchip.com>
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---
arch/arm/configs/sama5_defconfig | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm/configs/sama5_defconfig b/arch/arm/configs/sama5_defconfig
index f688443fe7bf..123b95c1447a 100644
--- a/arch/arm/configs/sama5_defconfig
+++ b/arch/arm/configs/sama5_defconfig
@@ -49,6 +49,7 @@ CONFIG_IP_PNP_RARP=y
# CONFIG_INET6_XFRM_MODE_TUNNEL is not set
# CONFIG_INET6_XFRM_MODE_BEET is not set
CONFIG_IPV6_SIT_6RD=y
+CONFIG_NET_DSA=m
CONFIG_CAN=y
CONFIG_CAN_AT91=y
CONFIG_CAN_M_CAN=y
@@ -80,6 +81,8 @@ CONFIG_SCSI=y
CONFIG_BLK_DEV_SD=y
# CONFIG_SCSI_LOWLEVEL is not set
CONFIG_NETDEVICES=y
+CONFIG_NET_DSA_MICROCHIP_KSZ9477=m
+CONFIG_NET_DSA_MICROCHIP_KSZ9477_SPI=m
CONFIG_MACB=y
# CONFIG_NET_VENDOR_BROADCOM is not set
# CONFIG_NET_VENDOR_CIRRUS is not set
--
2.25.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply related [flat|nested] 8+ messages in thread
* [PATCH 2/3] ARM: configs: at91: sama5: enable bridge and VLAN filtering
2020-07-23 16:24 ` Codrin Ciubotariu
@ 2020-07-23 16:24 ` Codrin Ciubotariu
-1 siblings, 0 replies; 8+ messages in thread
From: Codrin Ciubotariu @ 2020-07-23 16:24 UTC (permalink / raw)
To: linux-arm-kernel, linux-kernel
Cc: alexandre.belloni, cristian.birsan, nicolas.ferre, arnd,
ludovic.desroches, Razvan Stefanescu, Codrin Ciubotariu
From: Razvan Stefanescu <razvan.stefanescu@microchip.com>
These modules are needed to configure bridges in Linux, to take full
advantage of the KSZ switch capabilities.
Signed-off-by: Razvan Stefanescu <razvan.stefanescu@microchip.com>
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---
arch/arm/configs/sama5_defconfig | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm/configs/sama5_defconfig b/arch/arm/configs/sama5_defconfig
index 123b95c1447a..f4d71ffcb6e9 100644
--- a/arch/arm/configs/sama5_defconfig
+++ b/arch/arm/configs/sama5_defconfig
@@ -49,7 +49,10 @@ CONFIG_IP_PNP_RARP=y
# CONFIG_INET6_XFRM_MODE_TUNNEL is not set
# CONFIG_INET6_XFRM_MODE_BEET is not set
CONFIG_IPV6_SIT_6RD=y
+CONFIG_BRIDGE=m
+CONFIG_BRIDGE_VLAN_FILTERING=y
CONFIG_NET_DSA=m
+CONFIG_VLAN_8021Q=m
CONFIG_CAN=y
CONFIG_CAN_AT91=y
CONFIG_CAN_M_CAN=y
--
2.25.1
^ permalink raw reply related [flat|nested] 8+ messages in thread
* [PATCH 2/3] ARM: configs: at91: sama5: enable bridge and VLAN filtering
@ 2020-07-23 16:24 ` Codrin Ciubotariu
0 siblings, 0 replies; 8+ messages in thread
From: Codrin Ciubotariu @ 2020-07-23 16:24 UTC (permalink / raw)
To: linux-arm-kernel, linux-kernel
Cc: alexandre.belloni, arnd, ludovic.desroches, Razvan Stefanescu,
Codrin Ciubotariu, cristian.birsan
From: Razvan Stefanescu <razvan.stefanescu@microchip.com>
These modules are needed to configure bridges in Linux, to take full
advantage of the KSZ switch capabilities.
Signed-off-by: Razvan Stefanescu <razvan.stefanescu@microchip.com>
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---
arch/arm/configs/sama5_defconfig | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm/configs/sama5_defconfig b/arch/arm/configs/sama5_defconfig
index 123b95c1447a..f4d71ffcb6e9 100644
--- a/arch/arm/configs/sama5_defconfig
+++ b/arch/arm/configs/sama5_defconfig
@@ -49,7 +49,10 @@ CONFIG_IP_PNP_RARP=y
# CONFIG_INET6_XFRM_MODE_TUNNEL is not set
# CONFIG_INET6_XFRM_MODE_BEET is not set
CONFIG_IPV6_SIT_6RD=y
+CONFIG_BRIDGE=m
+CONFIG_BRIDGE_VLAN_FILTERING=y
CONFIG_NET_DSA=m
+CONFIG_VLAN_8021Q=m
CONFIG_CAN=y
CONFIG_CAN_AT91=y
CONFIG_CAN_M_CAN=y
--
2.25.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply related [flat|nested] 8+ messages in thread
* [PATCH 3/3] ARM: configs: at91: sama5: enable CAN PLATFORM driver
2020-07-23 16:24 ` Codrin Ciubotariu
@ 2020-07-23 16:24 ` Codrin Ciubotariu
-1 siblings, 0 replies; 8+ messages in thread
From: Codrin Ciubotariu @ 2020-07-23 16:24 UTC (permalink / raw)
To: linux-arm-kernel, linux-kernel
Cc: alexandre.belloni, cristian.birsan, nicolas.ferre, arnd,
ludovic.desroches, Codrin Ciubotariu
From: Cristian Birsan <cristian.birsan@microchip.com>
CAN_M_CAN_PLATFORM is needed to probe the driver on sama5 platforms
after the driver was split into multiple files.
Signed-off-by: Cristian Birsan <cristian.birsan@microchip.com>
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---
arch/arm/configs/sama5_defconfig | 1 +
1 file changed, 1 insertion(+)
diff --git a/arch/arm/configs/sama5_defconfig b/arch/arm/configs/sama5_defconfig
index f4d71ffcb6e9..7b7e333157fe 100644
--- a/arch/arm/configs/sama5_defconfig
+++ b/arch/arm/configs/sama5_defconfig
@@ -56,6 +56,7 @@ CONFIG_VLAN_8021Q=m
CONFIG_CAN=y
CONFIG_CAN_AT91=y
CONFIG_CAN_M_CAN=y
+CONFIG_CAN_M_CAN_PLATFORM=y
CONFIG_CFG80211=y
CONFIG_MAC80211=y
CONFIG_MAC80211_LEDS=y
--
2.25.1
^ permalink raw reply related [flat|nested] 8+ messages in thread
* [PATCH 3/3] ARM: configs: at91: sama5: enable CAN PLATFORM driver
@ 2020-07-23 16:24 ` Codrin Ciubotariu
0 siblings, 0 replies; 8+ messages in thread
From: Codrin Ciubotariu @ 2020-07-23 16:24 UTC (permalink / raw)
To: linux-arm-kernel, linux-kernel
Cc: alexandre.belloni, arnd, ludovic.desroches, Codrin Ciubotariu,
cristian.birsan
From: Cristian Birsan <cristian.birsan@microchip.com>
CAN_M_CAN_PLATFORM is needed to probe the driver on sama5 platforms
after the driver was split into multiple files.
Signed-off-by: Cristian Birsan <cristian.birsan@microchip.com>
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---
arch/arm/configs/sama5_defconfig | 1 +
1 file changed, 1 insertion(+)
diff --git a/arch/arm/configs/sama5_defconfig b/arch/arm/configs/sama5_defconfig
index f4d71ffcb6e9..7b7e333157fe 100644
--- a/arch/arm/configs/sama5_defconfig
+++ b/arch/arm/configs/sama5_defconfig
@@ -56,6 +56,7 @@ CONFIG_VLAN_8021Q=m
CONFIG_CAN=y
CONFIG_CAN_AT91=y
CONFIG_CAN_M_CAN=y
+CONFIG_CAN_M_CAN_PLATFORM=y
CONFIG_CFG80211=y
CONFIG_MAC80211=y
CONFIG_MAC80211_LEDS=y
--
2.25.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply related [flat|nested] 8+ messages in thread
* Re: [PATCH 1/3] ARM: configs: at91: sama5: add support for KSZ ethernet switches
2020-07-23 16:24 ` Codrin Ciubotariu
@ 2020-07-24 22:24 ` Alexandre Belloni
-1 siblings, 0 replies; 8+ messages in thread
From: Alexandre Belloni @ 2020-07-24 22:24 UTC (permalink / raw)
To: Codrin Ciubotariu, linux-arm-kernel, linux-kernel
Cc: Alexandre Belloni, ludovic.desroches, cristian.birsan, arnd,
Razvan Stefanescu
On Thu, 23 Jul 2020 19:24:32 +0300, Codrin Ciubotariu wrote:
> Enable DSA and KSZ9477 support as modules. Ethernet switches are used by
> the SAMA5D2-ICP board.
Applied, thanks!
[1/3] ARM: configs: at91: sama5: add support for KSZ ethernet switches
commit: 6dadeab7d260eaa410649a48d8368e4d3237377d
[2/3] ARM: configs: at91: sama5: enable bridge and VLAN filtering
commit: 33d8c87ef47f5303dca851f320611552bc84e32f
[3/3] ARM: configs: at91: sama5: enable CAN PLATFORM driver
commit: c12b539787efff5b4fc5abac1debf3ea1901348e
Best regards,
--
Alexandre Belloni <alexandre.belloni@bootlin.com>
^ permalink raw reply [flat|nested] 8+ messages in thread* Re: [PATCH 1/3] ARM: configs: at91: sama5: add support for KSZ ethernet switches
@ 2020-07-24 22:24 ` Alexandre Belloni
0 siblings, 0 replies; 8+ messages in thread
From: Alexandre Belloni @ 2020-07-24 22:24 UTC (permalink / raw)
To: Codrin Ciubotariu, linux-arm-kernel, linux-kernel
Cc: Alexandre Belloni, arnd, ludovic.desroches, cristian.birsan,
Razvan Stefanescu
On Thu, 23 Jul 2020 19:24:32 +0300, Codrin Ciubotariu wrote:
> Enable DSA and KSZ9477 support as modules. Ethernet switches are used by
> the SAMA5D2-ICP board.
Applied, thanks!
[1/3] ARM: configs: at91: sama5: add support for KSZ ethernet switches
commit: 6dadeab7d260eaa410649a48d8368e4d3237377d
[2/3] ARM: configs: at91: sama5: enable bridge and VLAN filtering
commit: 33d8c87ef47f5303dca851f320611552bc84e32f
[3/3] ARM: configs: at91: sama5: enable CAN PLATFORM driver
commit: c12b539787efff5b4fc5abac1debf3ea1901348e
Best regards,
--
Alexandre Belloni <alexandre.belloni@bootlin.com>
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply [flat|nested] 8+ messages in thread