Re: [PATCH 7/16] Early serial debug support for PPC44x

[David Gibson <dwg@au1.ibm.com>]

On Wed, Feb 14, 2007 at 12:30:12PM +1030, Alan Modra wrote:
> On Wed, Feb 14, 2007 at 12:00:44PM +1100, David Gibson wrote:
> > On Tue, Feb 13, 2007 at 07:02:36PM -0600, Josh Boyer wrote:
> > > On Wed, Feb 14, 2007 at 11:16:22AM +1100, David Gibson wrote:
> > > > I'm using a 64-bit constant there, but for me at least the assembler
> > > > is able to handle manipulating it in constant expressions.
> > > 
> > > [jwboyer@zod ~]$ powerpc-440-linux-gnu-as --version
> > > GNU assembler 2.15
> > > 
> > > This is a crosstool built toolchain with binutils 2.15 and gcc 3.4.1.
> > > Which versions are you using?
> > 
> > Hmm.. I appear to have binutils-2.17.  That could be it.
> > 
> > It would be nice to support the older binutils too, but I'm not sure
> > how to get around this without considerable inconvenience.
> 
> I would guess that this isn't a matter of how old the assembler is,
> but how the assembler was built.  If built on a 32-bit host with no
> 64-bit targets supported, then most internal assembler variables
> are 32-bit and 64-bit constants are not handled very well.
> 
> You probably should avoid 64-bit expressions on a 32-bit target.

Well, yes, but how.  This 32-bit target has 36-bit physical
addresses.  All those expressions do is pull the high and low 32-bit
words from literals.

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson