[U-Boot] [PATCH 2/5] Enable booting of mx28 without battery

From: Marek Vasut <marex@denx.de>
To: u-boot@lists.denx.de
Subject: [U-Boot] [PATCH 2/5] Enable booting of mx28 without battery
Date: Thu, 22 Jan 2015 14:51:38 +0100	[thread overview]
Message-ID: <201501221451.39057.marex@denx.de> (raw)
In-Reply-To: <CAOMZO5ALWECLtnZxmbgRz7q36Z8waXSHuXfOTJF2YvCYUwMJ9g@mail.gmail.com>

On Thursday, January 22, 2015 at 01:42:10 PM, Fabio Estevam wrote:
> Hi Graeme,
> 
> On Wed, Jan 21, 2015 at 9:55 AM, Graeme Russ <gruss@tss-engineering.com> 
wrote:
> > Section 4.1.2 of Freescale Application Note AN4199 describes the
> > configuration required to operate the mx28 from a 5V source without a
> > battery. This patch implements the changes to the Freescale bootlets
> > which allow this configuration to properly boot the mx28 processor
> > 
> > Signed-off-by: Graeme Russ <gruss@tss-engineering.com>
> > ---
> > 
> >  arch/arm/cpu/arm926ejs/mxs/spl_power_init.c | 190
> >  +++++++++++++++++++++++++++- doc/README.mxs                            
> >   |  10 ++
> 
> Damien posted today a new version of this patch in the imx community,
> which is a lot simpler.

Guys, we have U-Boot mailing list for posting U-Boot patches. It'd be nice
if you could use it to prevent fragmentation of efforts ;-)

But of course, the effort is appreciated, just a rant.

Best regards,
Marek Vasut