All of lore.kernel.org
 help / color / mirror / Atom feed
* [PATCH] omap-rng: Change RNG_CONFIG_REG to RNG_CONTROL_REG when checking and disabling TRNG
@ 2015-03-11  4:29 Andre Wolokita
  2015-03-13 10:07 ` Herbert Xu
  0 siblings, 1 reply; 4+ messages in thread
From: Andre Wolokita @ 2015-03-11  4:29 UTC (permalink / raw)
  To: herbert; +Cc: linux-crypto, Andre Wolokita

In omap4_rng_init(), a check of bit 10 of the RNG_CONFIG_REG is done to determine
whether the RNG is running. This is suspicious firstly due to the use of
RNG_CONTROL_ENABLE_TRNG_MASK and secondly because the same mask is written to
RNG_CONTROL_REG after configuration of the FROs. Similar suspicious logic is
repeated in omap4_rng_cleanup() when RNG_CONTROL_REG masked with
RNG_CONTROL_ENABLE_TRNG_MASK is read, the same mask bit is cleared, and then
written to RNG_CONFIG_REG. Unless the TRNG is enabled with one bit in RNG_CONTROL
and disabled with another in RNG_CONFIG and these bits are mirrored in some way,
I believe that the TRNG is not really shutting off.

Apart from the strange logic, I have reason to suspect that the OMAP4 related
code in this driver is driving an Inside Secure IP hardware RNG and strongly
suspect that bit 10 of RNG_CONFIG_REG is one of the bits configuring the
sampling rate of the FROs. This option is by default set to 0 and is not being
set anywhere in omap-rng.c. Reading this bit during omap4_rng_init() will
always return 0. It will remain 0 because ~(value of TRNG_MASK in control) will
always be 0, because the TRNG is never shut off. This is of course presuming
that the OMAP4 features the Inside Secure IP.

I'm interested in knowing what the guys at TI think about this, as only they
can confirm or deny the detailed structure of these registers.
---
 drivers/char/hw_random/omap-rng.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/char/hw_random/omap-rng.c b/drivers/char/hw_random/omap-rng.c
index d14dcf7..67151cb 100644
--- a/drivers/char/hw_random/omap-rng.c
+++ b/drivers/char/hw_random/omap-rng.c
@@ -236,7 +236,7 @@ static int omap4_rng_init(struct omap_rng_dev *priv)
 	u32 val;
 
 	/* Return if RNG is already running. */
-	if (omap_rng_read(priv, RNG_CONFIG_REG) & RNG_CONTROL_ENABLE_TRNG_MASK)
+	if (omap_rng_read(priv, RNG_CONTROL_REG) & RNG_CONTROL_ENABLE_TRNG_MASK)
 		return 0;
 
 	val = RNG_CONFIG_MIN_REFIL_CYCLES << RNG_CONFIG_MIN_REFIL_CYCLES_SHIFT;
@@ -262,7 +262,7 @@ static void omap4_rng_cleanup(struct omap_rng_dev *priv)
 
 	val = omap_rng_read(priv, RNG_CONTROL_REG);
 	val &= ~RNG_CONTROL_ENABLE_TRNG_MASK;
-	omap_rng_write(priv, RNG_CONFIG_REG, val);
+	omap_rng_write(priv, RNG_CONTROL_REG, val);
 }
 
 static irqreturn_t omap4_rng_irq(int irq, void *dev_id)
-- 
1.7.9.5

^ permalink raw reply related	[flat|nested] 4+ messages in thread

* Re: [PATCH] omap-rng: Change RNG_CONFIG_REG to RNG_CONTROL_REG when checking and disabling TRNG
  2015-03-11  4:29 [PATCH] omap-rng: Change RNG_CONFIG_REG to RNG_CONTROL_REG when checking and disabling TRNG Andre Wolokita
@ 2015-03-13 10:07 ` Herbert Xu
  0 siblings, 0 replies; 4+ messages in thread
From: Herbert Xu @ 2015-03-13 10:07 UTC (permalink / raw)
  To: Andre Wolokita; +Cc: linux-crypto

On Wed, Mar 11, 2015 at 03:29:35PM +1100, Andre Wolokita wrote:
> In omap4_rng_init(), a check of bit 10 of the RNG_CONFIG_REG is done to determine
> whether the RNG is running. This is suspicious firstly due to the use of
> RNG_CONTROL_ENABLE_TRNG_MASK and secondly because the same mask is written to
> RNG_CONTROL_REG after configuration of the FROs. Similar suspicious logic is
> repeated in omap4_rng_cleanup() when RNG_CONTROL_REG masked with
> RNG_CONTROL_ENABLE_TRNG_MASK is read, the same mask bit is cleared, and then
> written to RNG_CONFIG_REG. Unless the TRNG is enabled with one bit in RNG_CONTROL
> and disabled with another in RNG_CONFIG and these bits are mirrored in some way,
> I believe that the TRNG is not really shutting off.
> 
> Apart from the strange logic, I have reason to suspect that the OMAP4 related
> code in this driver is driving an Inside Secure IP hardware RNG and strongly
> suspect that bit 10 of RNG_CONFIG_REG is one of the bits configuring the
> sampling rate of the FROs. This option is by default set to 0 and is not being
> set anywhere in omap-rng.c. Reading this bit during omap4_rng_init() will
> always return 0. It will remain 0 because ~(value of TRNG_MASK in control) will
> always be 0, because the TRNG is never shut off. This is of course presuming
> that the OMAP4 features the Inside Secure IP.
> 
> I'm interested in knowing what the guys at TI think about this, as only they
> can confirm or deny the detailed structure of these registers.

Where is the sign-off?
-- 
Email: Herbert Xu <herbert@gondor.apana.org.au>
Home Page: http://gondor.apana.org.au/~herbert/
PGP Key: http://gondor.apana.org.au/~herbert/pubkey.txt

^ permalink raw reply	[flat|nested] 4+ messages in thread

* Re: [PATCH] omap-rng: Change RNG_CONFIG_REG to RNG_CONTROL_REG when checking and disabling TRNG
  2015-03-15 23:19 Andre Wolokita
@ 2015-03-17 11:33 ` Herbert Xu
  0 siblings, 0 replies; 4+ messages in thread
From: Herbert Xu @ 2015-03-17 11:33 UTC (permalink / raw)
  To: Andre Wolokita; +Cc: linux-crypto

On Mon, Mar 16, 2015 at 10:19:11AM +1100, Andre Wolokita wrote:
> In omap4_rng_init(), a check of bit 10 of the RNG_CONFIG_REG is done to determine
> whether the RNG is running. This is suspicious firstly due to the use of
> RNG_CONTROL_ENABLE_TRNG_MASK and secondly because the same mask is written to
> RNG_CONTROL_REG after configuration of the FROs. Similar suspicious logic is
> repeated in omap4_rng_cleanup() when RNG_CONTROL_REG masked with
> RNG_CONTROL_ENABLE_TRNG_MASK is read, the same mask bit is cleared, and then
> written to RNG_CONFIG_REG. Unless the TRNG is enabled with one bit in RNG_CONTROL
> and disabled with another in RNG_CONFIG and these bits are mirrored in some way,
> I believe that the TRNG is not really shutting off.
> 
> Apart from the strange logic, I have reason to suspect that the OMAP4 related
> code in this driver is driving an Inside Secure IP hardware RNG and strongly
> suspect that bit 10 of RNG_CONFIG_REG is one of the bits configuring the
> sampling rate of the FROs. This option is by default set to 0 and is not being
> set anywhere in omap-rng.c. Reading this bit during omap4_rng_init() will
> always return 0. It will remain 0 because ~(value of TRNG_MASK in control) will
> always be 0, because the TRNG is never shut off. This is of course presuming
> that the OMAP4 features the Inside Secure IP.
> 
> I'm interested in knowing what the guys at TI think about this, as only they
> can confirm or deny the detailed structure of these registers.
> 
> Signed-off-by: Andre Wolokita <Andre.Wolokita@analog.com>

Both patches applied.  Thanks!
-- 
Email: Herbert Xu <herbert@gondor.apana.org.au>
Home Page: http://gondor.apana.org.au/~herbert/
PGP Key: http://gondor.apana.org.au/~herbert/pubkey.txt

^ permalink raw reply	[flat|nested] 4+ messages in thread

* [PATCH] omap-rng: Change RNG_CONFIG_REG to RNG_CONTROL_REG when checking and disabling TRNG
@ 2015-03-15 23:19 Andre Wolokita
  2015-03-17 11:33 ` Herbert Xu
  0 siblings, 1 reply; 4+ messages in thread
From: Andre Wolokita @ 2015-03-15 23:19 UTC (permalink / raw)
  To: herbert; +Cc: linux-crypto, Andre Wolokita

In omap4_rng_init(), a check of bit 10 of the RNG_CONFIG_REG is done to determine
whether the RNG is running. This is suspicious firstly due to the use of
RNG_CONTROL_ENABLE_TRNG_MASK and secondly because the same mask is written to
RNG_CONTROL_REG after configuration of the FROs. Similar suspicious logic is
repeated in omap4_rng_cleanup() when RNG_CONTROL_REG masked with
RNG_CONTROL_ENABLE_TRNG_MASK is read, the same mask bit is cleared, and then
written to RNG_CONFIG_REG. Unless the TRNG is enabled with one bit in RNG_CONTROL
and disabled with another in RNG_CONFIG and these bits are mirrored in some way,
I believe that the TRNG is not really shutting off.

Apart from the strange logic, I have reason to suspect that the OMAP4 related
code in this driver is driving an Inside Secure IP hardware RNG and strongly
suspect that bit 10 of RNG_CONFIG_REG is one of the bits configuring the
sampling rate of the FROs. This option is by default set to 0 and is not being
set anywhere in omap-rng.c. Reading this bit during omap4_rng_init() will
always return 0. It will remain 0 because ~(value of TRNG_MASK in control) will
always be 0, because the TRNG is never shut off. This is of course presuming
that the OMAP4 features the Inside Secure IP.

I'm interested in knowing what the guys at TI think about this, as only they
can confirm or deny the detailed structure of these registers.

Signed-off-by: Andre Wolokita <Andre.Wolokita@analog.com>
---
 drivers/char/hw_random/omap-rng.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/char/hw_random/omap-rng.c b/drivers/char/hw_random/omap-rng.c
index ff74e5d..67151cb 100644
--- a/drivers/char/hw_random/omap-rng.c
+++ b/drivers/char/hw_random/omap-rng.c
@@ -262,7 +262,7 @@ static void omap4_rng_cleanup(struct omap_rng_dev *priv)
 
 	val = omap_rng_read(priv, RNG_CONTROL_REG);
 	val &= ~RNG_CONTROL_ENABLE_TRNG_MASK;
-	omap_rng_write(priv, RNG_CONFIG_REG, val);
+	omap_rng_write(priv, RNG_CONTROL_REG, val);
 }
 
 static irqreturn_t omap4_rng_irq(int irq, void *dev_id)
-- 
1.7.9.5

^ permalink raw reply related	[flat|nested] 4+ messages in thread

end of thread, other threads:[~2015-03-17 11:33 UTC | newest]

Thread overview: 4+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2015-03-11  4:29 [PATCH] omap-rng: Change RNG_CONFIG_REG to RNG_CONTROL_REG when checking and disabling TRNG Andre Wolokita
2015-03-13 10:07 ` Herbert Xu
2015-03-15 23:19 Andre Wolokita
2015-03-17 11:33 ` Herbert Xu

This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.