[PATCH v2 16/20] lpfc: Fix bad sgl reposting after 2nd adapter reset

[James Smart <jsmart2021@gmail.com>]

From: Dick Kennedy <dick.kennedy@broadcom.com>

Fix bad sgl reposting after 2nd adapter reset

port issue was fixed, the hbacmd reset would take
more than 8 minutes to complete.

There were conflicting NVME SGL posting/reposting responsibilities
between lpfc_online()/lpfc_sli4_hba_setup() and
lpfc_nvme_create_localport().  The lpfc_online() causes a REPOST
on existing NVME SGLs which is not released during the fc port reset.
However, lpfc_nvme_create_localport() wants to allocate new NVME
buffers and post them. Both cancelled out each other which had a side
effect of hosing the mailbox handling that was used to remove the sgl
lists - causing multiple 60s mbx timeouts.

Fix by preserving all SGL lists over the fc port reset.

Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <james.smart@broadcom.com>
---
 drivers/scsi/lpfc/lpfc_nvme.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/scsi/lpfc/lpfc_nvme.c b/drivers/scsi/lpfc/lpfc_nvme.c
index 87e0743c4ace..8e7cdbd5d7d3 100644
--- a/drivers/scsi/lpfc/lpfc_nvme.c
+++ b/drivers/scsi/lpfc/lpfc_nvme.c
@@ -2181,8 +2181,15 @@ lpfc_nvme_create_localport(struct lpfc_vport *vport)
 		vport->localport = localport;
 		lport->vport = vport;
 		vport->nvmei_support = 1;
-		len  = lpfc_new_nvme_buf(vport, phba->sli4_hba.nvme_xri_max);
-		vport->phba->total_nvme_bufs += len;
+
+		/* Don't post more new bufs if repost already recovered
+		 * the nvme sgls.
+		 */
+		if (phba->sli4_hba.nvme_xri_cnt == 0) {
+			len  = lpfc_new_nvme_buf(vport,
+						 phba->sli4_hba.nvme_xri_max);
+			vport->phba->total_nvme_bufs += len;
+		}
 	}
 
 	return ret;
-- 
2.13.1