[PATCH v2 00/10]

[Alexandre Belloni <alexandre.belloni@bootlin.com>]

This series add support for the sam9x60 clocks handled by the PMC.

The first four patches are preparatory patches to handle register layout
and offset differences. Then, a driver for the new interface for PLLs is
added and the final patch is the driver for the sam9x60 PMC.

changes in v2:
 - rebased on v5.1-rc1
 - changed the PLL_ACR handling to conform to the datasheet errata

Alexandre Belloni (7):
  clk: at91: allow configuring peripheral PCR layout
  clk: at91: allow configuring generated PCR layout
  clk: at91: usb: Add sam9x60 support
  clk: at91: master: Add sam9x60 support
  clk: at91: add sam9x60 PLL driver
  dt-bindings: clk: at91: add bindings for SAM9X60 pmc
  clk: at91: add sam9x60 pmc driver

Claudiu Beznea (3):
  clk: at91: sckc: add support to specify registers bit offsets
  clk: at91: sckc: add support for SAM9X60
  dt-bindings: clk: at91: add bindings for SAM9X60's slow clock
    controller

 .../devicetree/bindings/clock/at91-clock.txt  |   6 +-
 drivers/clk/at91/Makefile                     |   2 +
 drivers/clk/at91/at91sam9x5.c                 |   9 +
 drivers/clk/at91/clk-generated.c              |  48 +--
 drivers/clk/at91/clk-master.c                 |   8 +-
 drivers/clk/at91/clk-peripheral.c             |  46 +--
 drivers/clk/at91/clk-sam9x60-pll.c            | 330 ++++++++++++++++++
 drivers/clk/at91/clk-usb.c                    |  33 +-
 drivers/clk/at91/dt-compat.c                  |  12 +-
 drivers/clk/at91/pmc.h                        |  23 ++
 drivers/clk/at91/sam9x60.c                    | 307 ++++++++++++++++
 drivers/clk/at91/sama5d2.c                    |  10 +
 drivers/clk/at91/sama5d4.c                    |   8 +
 drivers/clk/at91/sckc.c                       | 142 ++++++--
 include/linux/clk/at91_pmc.h                  |  12 +-
 15 files changed, 895 insertions(+), 101 deletions(-)
 create mode 100644 drivers/clk/at91/clk-sam9x60-pll.c
 create mode 100644 drivers/clk/at91/sam9x60.c

-- 
2.20.1