[PATCH v2] ARM: dts: sun8i-h3: Fix wifi in Beelink X2 DT

* [PATCH v2] ARM: dts: sun8i-h3: Fix wifi in Beelink X2 DT
@ 2019-05-18 15:40 ` Jernej Skrabec
  0 siblings, 0 replies; 5+ messages in thread
From: Jernej Skrabec @ 2019-05-18 15:40 UTC (permalink / raw)
  To: maxime.ripard, wens
  Cc: robh+dt, mark.rutland, devicetree, linux-arm-kernel, linux-kernel

mmc1 node where wifi module is connected doesn't have properly defined
power supplies so wifi module is never powered up. Fix that by
specifying additional power supplies.

Additionally, this STB may have either Realtek or Broadcom based wifi
module. One based on Broadcom module also needs external clock to work
properly. Fix that by adding clock property to wifi_pwrseq node.

Fixes: e582b47a9252 ("ARM: dts: sun8i-h3: Add dts for the Beelink X2 STB")
Signed-off-by: Jernej Skrabec <jernej.skrabec@siol.net>
---
Changes from v1:
- removed unneeded pinctrl-names node

 arch/arm/boot/dts/sun8i-h3-beelink-x2.dts | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts b/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
index 6277f13f3eb3..ac9e26b1d906 100644
--- a/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
+++ b/arch/arm/boot/dts/sun8i-h3-beelink-x2.dts
@@ -90,6 +90,8 @@
 	wifi_pwrseq: wifi_pwrseq {
 		compatible = "mmc-pwrseq-simple";
 		reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
+		clocks = <&rtc 1>;
+		clock-names = "ext_clock";
 	};
 
 	sound_spdif {
@@ -155,6 +157,8 @@
 
 &mmc1 {
 	vmmc-supply = <&reg_vcc3v3>;
+	vqmmc-supply = <&reg_vcc3v3>;
+	mmc-pwrseq = <&wifi_pwrseq>;
 	bus-width = <4>;
 	non-removable;
 	status = "okay";
-- 
2.21.0


^ permalink raw reply related	[flat|nested] 5+ messages in thread