From: Jagan Teki <jagan@amarulasolutions.com> To: Kever Yang <kever.yang@rock-chips.com>, Philipp Tomsich <philipp.tomsich@theobroma-systems.com>, Simon Glass <sjg@chromium.org> Cc: Suniel Mahesh <sunil@amarulasolutions.com>, U-Boot-Denx <u-boot@lists.denx.de>, linux-rockchip@lists.infradead.org, linux-amarula <linux-amarula@amarulasolutions.com>, Jagan Teki <jagan@amarulasolutions.com>, Tom Cubie <tom@radxa.com> Subject: [PATCH v3 1/6] rock-pi-4: Enable USB3 Host Date: Tue, 7 Jul 2020 19:20:44 +0530 [thread overview] Message-ID: <20200707135049.9521-1-jagan@amarulasolutions.com> (raw) Enable USB3.0 Host support for RockPI-4 boards. Note that the Upper USB3.0 port is marked as otg and lower USB3.0 port marked as host, so this below log capture when USB3.0 mass storage plug in at lower USB 3.0 port. Log: Bus usb@fe380000: USB EHCI 1.00 Bus usb@fe3c0000: USB EHCI 1.00 Bus dwc3: usb maximum-speed not found Register 2000140 NbrPorts 2 Starting the controller USB XHCI 1.10 Bus dwc3: usb maximum-speed not found Register 2000140 NbrPorts 2 Starting the controller USB XHCI 1.10 scanning bus usb@fe380000 for devices... 1 USB Device(s) found scanning bus usb@fe3c0000 for devices... 1 USB Device(s) found scanning bus dwc3 for devices... 1 USB Device(s) found scanning bus dwc3 for devices... cannot reset port 1!? 2 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found => usb tree USB device tree: 1 Hub (480 Mb/s, 0mA) u-boot EHCI Host Controller 1 Hub (480 Mb/s, 0mA) u-boot EHCI Host Controller 1 Hub (5 Gb/s, 0mA) U-Boot XHCI Host Controller 1 Hub (5 Gb/s, 0mA) | U-Boot XHCI Host Controller | +-2 Mass Storage (5 Gb/s, 224mA) SanDisk Dual Drive 040130e3ee554b7078843f4eb331646 Cc: Tom Cubie <tom@radxa.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> Reviewed-by: Kever Yang <kever.yang@rock-chips.com> --- Changes for v3: - collect kever review tag configs/rock-pi-4-rk3399_defconfig | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig index 0d86fdc895..2487872219 100644 --- a/configs/rock-pi-4-rk3399_defconfig +++ b/configs/rock-pi-4-rk3399_defconfig @@ -28,6 +28,7 @@ CONFIG_ENV_IS_IN_MMC=y CONFIG_SYS_RELOC_GD_ENV_ADDR=y CONFIG_ROCKCHIP_GPIO=y CONFIG_SYS_I2C_ROCKCHIP=y +CONFIG_MISC=y CONFIG_MMC_DW=y CONFIG_MMC_DW_ROCKCHIP=y CONFIG_MMC_SDHCI=y @@ -35,11 +36,14 @@ CONFIG_MMC_SDHCI_ROCKCHIP=y CONFIG_DM_ETH=y CONFIG_ETH_DESIGNWARE=y CONFIG_GMAC_ROCKCHIP=y +CONFIG_PHY_ROCKCHIP_INNO_USB2=y +CONFIG_PHY_ROCKCHIP_TYPEC=y CONFIG_PMIC_RK8XX=y CONFIG_REGULATOR_PWM=y CONFIG_REGULATOR_RK8XX=y CONFIG_PWM_ROCKCHIP=y CONFIG_RAM_RK3399_LPDDR4=y +CONFIG_DM_RESET=y CONFIG_BAUDRATE=1500000 CONFIG_DEBUG_UART_SHIFT=2 CONFIG_SYSRESET=y @@ -48,6 +52,8 @@ CONFIG_USB_XHCI_HCD=y CONFIG_USB_XHCI_DWC3=y CONFIG_USB_EHCI_HCD=y CONFIG_USB_EHCI_GENERIC=y +CONFIG_USB_DWC3=y +CONFIG_USB_DWC3_GENERIC=y CONFIG_USB_HOST_ETHER=y CONFIG_USB_ETHER_ASIX=y CONFIG_USB_ETHER_ASIX88179=y -- 2.25.1
WARNING: multiple messages have this Message-ID (diff)
From: Jagan Teki <jagan@amarulasolutions.com> To: u-boot@lists.denx.de Subject: [PATCH v3 1/6] rock-pi-4: Enable USB3 Host Date: Tue, 7 Jul 2020 19:20:44 +0530 [thread overview] Message-ID: <20200707135049.9521-1-jagan@amarulasolutions.com> (raw) Enable USB3.0 Host support for RockPI-4 boards. Note that the Upper USB3.0 port is marked as otg and lower USB3.0 port marked as host, so this below log capture when USB3.0 mass storage plug in at lower USB 3.0 port. Log: Bus usb at fe380000: USB EHCI 1.00 Bus usb at fe3c0000: USB EHCI 1.00 Bus dwc3: usb maximum-speed not found Register 2000140 NbrPorts 2 Starting the controller USB XHCI 1.10 Bus dwc3: usb maximum-speed not found Register 2000140 NbrPorts 2 Starting the controller USB XHCI 1.10 scanning bus usb at fe380000 for devices... 1 USB Device(s) found scanning bus usb at fe3c0000 for devices... 1 USB Device(s) found scanning bus dwc3 for devices... 1 USB Device(s) found scanning bus dwc3 for devices... cannot reset port 1!? 2 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found => usb tree USB device tree: 1 Hub (480 Mb/s, 0mA) u-boot EHCI Host Controller 1 Hub (480 Mb/s, 0mA) u-boot EHCI Host Controller 1 Hub (5 Gb/s, 0mA) U-Boot XHCI Host Controller 1 Hub (5 Gb/s, 0mA) | U-Boot XHCI Host Controller | +-2 Mass Storage (5 Gb/s, 224mA) SanDisk Dual Drive 040130e3ee554b7078843f4eb331646 Cc: Tom Cubie <tom@radxa.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> Reviewed-by: Kever Yang <kever.yang@rock-chips.com> --- Changes for v3: - collect kever review tag configs/rock-pi-4-rk3399_defconfig | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig index 0d86fdc895..2487872219 100644 --- a/configs/rock-pi-4-rk3399_defconfig +++ b/configs/rock-pi-4-rk3399_defconfig @@ -28,6 +28,7 @@ CONFIG_ENV_IS_IN_MMC=y CONFIG_SYS_RELOC_GD_ENV_ADDR=y CONFIG_ROCKCHIP_GPIO=y CONFIG_SYS_I2C_ROCKCHIP=y +CONFIG_MISC=y CONFIG_MMC_DW=y CONFIG_MMC_DW_ROCKCHIP=y CONFIG_MMC_SDHCI=y @@ -35,11 +36,14 @@ CONFIG_MMC_SDHCI_ROCKCHIP=y CONFIG_DM_ETH=y CONFIG_ETH_DESIGNWARE=y CONFIG_GMAC_ROCKCHIP=y +CONFIG_PHY_ROCKCHIP_INNO_USB2=y +CONFIG_PHY_ROCKCHIP_TYPEC=y CONFIG_PMIC_RK8XX=y CONFIG_REGULATOR_PWM=y CONFIG_REGULATOR_RK8XX=y CONFIG_PWM_ROCKCHIP=y CONFIG_RAM_RK3399_LPDDR4=y +CONFIG_DM_RESET=y CONFIG_BAUDRATE=1500000 CONFIG_DEBUG_UART_SHIFT=2 CONFIG_SYSRESET=y @@ -48,6 +52,8 @@ CONFIG_USB_XHCI_HCD=y CONFIG_USB_XHCI_DWC3=y CONFIG_USB_EHCI_HCD=y CONFIG_USB_EHCI_GENERIC=y +CONFIG_USB_DWC3=y +CONFIG_USB_DWC3_GENERIC=y CONFIG_USB_HOST_ETHER=y CONFIG_USB_ETHER_ASIX=y CONFIG_USB_ETHER_ASIX88179=y -- 2.25.1
next reply other threads:[~2020-07-07 13:50 UTC|newest] Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top 2020-07-07 13:50 Jagan Teki [this message] 2020-07-07 13:50 ` [PATCH v3 1/6] rock-pi-4: Enable USB3 Host Jagan Teki 2020-07-07 13:50 ` [PATCH v3 2/6] rock-pi-4: Enable PCI/NVME Jagan Teki 2020-07-07 13:50 ` Jagan Teki 2020-07-07 13:50 ` [PATCH v3 3/6] rock-pi-4: Enable USB Gadget Jagan Teki 2020-07-07 13:50 ` Jagan Teki 2020-07-07 13:50 ` [PATCH v3 4/6] rock-pi-4: Enable HDMI output Jagan Teki 2020-07-07 13:50 ` Jagan Teki 2020-07-18 3:28 ` Kever Yang 2020-07-18 3:28 ` Kever Yang 2020-07-07 13:50 ` [PATCH v3 5/6] roc-rk3399-pc: Enable USB Gadget Jagan Teki 2020-07-07 13:50 ` Jagan Teki 2020-07-07 13:50 ` [PATCH v3 6/6] roc-rk3399-pc: Update ENV offset, size Jagan Teki 2020-07-07 13:50 ` Jagan Teki 2020-07-18 3:20 ` Kever Yang 2020-07-18 3:20 ` Kever Yang 2020-07-18 13:28 ` Kever Yang 2020-07-18 13:28 ` Kever Yang
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20200707135049.9521-1-jagan@amarulasolutions.com \ --to=jagan@amarulasolutions.com \ --cc=kever.yang@rock-chips.com \ --cc=linux-amarula@amarulasolutions.com \ --cc=linux-rockchip@lists.infradead.org \ --cc=philipp.tomsich@theobroma-systems.com \ --cc=sjg@chromium.org \ --cc=sunil@amarulasolutions.com \ --cc=tom@radxa.com \ --cc=u-boot@lists.denx.de \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.