[PATCH v3 5/6] x86/vpic: issue dpci EOI for cleared pins at ICW1

[Roger Pau Monne <roger.pau@citrix.com>]

When pins are cleared from either ISR or IRR as part of the
initialization sequence forward the clearing of those pins to the dpci
EOI handler, as it is equivalent to an EOI. Not doing so can bring the
interrupt controller state out of sync with the dpci handling logic,
that expects a notification when a pin has been EOI'ed.

Fixes: 7b3cb5e5416 ('IRQ injection changes for HVM PCI passthru.')
Signed-off-by: Roger Pau Monné <roger.pau@citrix.com>
---
Changes since v2:
 - Remove the unmask label.
---
 xen/arch/x86/hvm/vpic.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/xen/arch/x86/hvm/vpic.c b/xen/arch/x86/hvm/vpic.c
index 795a76768d..f465b7f997 100644
--- a/xen/arch/x86/hvm/vpic.c
+++ b/xen/arch/x86/hvm/vpic.c
@@ -197,6 +197,8 @@ static void vpic_ioport_write(
     {
         if ( val & 0x10 )
         {
+            unsigned int pending = vpic->isr | (vpic->irr & ~vpic->elcr);
+
             /* ICW1 */
             /* Clear edge-sensing logic. */
             vpic->irr &= vpic->elcr;
@@ -220,6 +222,24 @@ static void vpic_ioport_write(
             }
 
             vpic->init_state = ((val & 3) << 2) | 1;
+            vpic_update_int_output(vpic);
+            vpic_unlock(vpic);
+
+            /*
+             * Forward the EOI of any pending or in service interrupt that has
+             * been cleared from IRR or ISR, or else the dpci logic will get
+             * out of sync with the state of the interrupt controller.
+             */
+            while ( pending )
+            {
+                unsigned int pin = __scanbit(pending, 8);
+
+                ASSERT(pin < 8);
+                hvm_dpci_eoi(current->domain,
+                             hvm_isa_irq_to_gsi((addr >> 7) ? (pin | 8) : pin));
+                __clear_bit(pin, &pending);
+            }
+            return;
         }
         else if ( val & 0x08 )
         {
-- 
2.29.2