[PATCH] target: Make logs less verbose

[PATCH] target: Make logs less verbose

[Konstantin Shelekhin]

Change the log level of the following message to debug:

	Unsupported SCSI Opcode 0xXX, sending CHECK_CONDITION.

This message is mostly helpful during debugging sessions in order to
understand errors on the initiator side. But most of the time it's just
useless and makes reading logs much harder.

It gets particularly annoying if there are many initiators that come and
go or if an initiator runs a program that does not care whether the
command is supported and just keeps sending it.

Signed-off-by: Konstantin Shelekhin <k.shelekhin@yadro.com>
Reviewed-by: Roman Bolshakov <r.bolshakov@yadro.com>
---
 drivers/target/target_core_transport.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/target/target_core_transport.c b/drivers/target/target_core_transport.c
index 5ecb9f18a53d..5e1d2abf5efd 100644
--- a/drivers/target/target_core_transport.c
+++ b/drivers/target/target_core_transport.c
@@ -1488,10 +1488,10 @@ target_cmd_parse_cdb(struct se_cmd *cmd)
 
 	ret = dev->transport->parse_cdb(cmd);
 	if (ret == TCM_UNSUPPORTED_SCSI_OPCODE)
-		pr_warn_ratelimited("%s/%s: Unsupported SCSI Opcode 0x%02x, sending CHECK_CONDITION.\n",
-				    cmd->se_tfo->fabric_name,
-				    cmd->se_sess->se_node_acl->initiatorname,
-				    cmd->t_task_cdb[0]);
+		pr_debug_ratelimited("%s/%s: Unsupported SCSI Opcode 0x%02x, sending CHECK_CONDITION.\n",
+				     cmd->se_tfo->fabric_name,
+				     cmd->se_sess->se_node_acl->initiatorname,
+				     cmd->t_task_cdb[0]);
 	if (ret)
 		return ret;
 
-- 
2.30.2