[PATCH] PCI: mediatek-gen3: Disable DVFSRC voltage request

[Jianjun Wang <jianjun.wang@mediatek.com>]

When the DVFSRC feature is not implemented, the MAC layer will
assert a voltage request signal when exit from the L1ss state,
but cannot receive the voltage ready signal, which will cause
the link to fail to exit the L1ss state correctly.

Disable DVFSRC voltage request by default, we need to find
a common way to enable it in the future.

Signed-off-by: Jianjun Wang <jianjun.wang@mediatek.com>
---
 drivers/pci/controller/pcie-mediatek-gen3.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/pci/controller/pcie-mediatek-gen3.c b/drivers/pci/controller/pcie-mediatek-gen3.c
index f3aeb8d4eaca..79fb12fca6a9 100644
--- a/drivers/pci/controller/pcie-mediatek-gen3.c
+++ b/drivers/pci/controller/pcie-mediatek-gen3.c
@@ -79,6 +79,9 @@
 #define PCIE_ICMD_PM_REG		0x198
 #define PCIE_TURN_OFF_LINK		BIT(4)
 
+#define PCIE_MISC_CTRL_REG		0x348
+#define PCIE_DISABLE_DVFSRC_VLT_REQ	BIT(1)
+
 #define PCIE_TRANS_TABLE_BASE_REG	0x800
 #define PCIE_ATR_SRC_ADDR_MSB_OFFSET	0x4
 #define PCIE_ATR_TRSL_ADDR_LSB_OFFSET	0x8
@@ -297,6 +300,11 @@ static int mtk_pcie_startup_port(struct mtk_pcie_port *port)
 	val &= ~PCIE_INTX_ENABLE;
 	writel_relaxed(val, port->base + PCIE_INT_ENABLE_REG);
 
+	/* Disable DVFSRC voltage request */
+	val = readl_relaxed(port->base + PCIE_MISC_CTRL_REG);
+	val |= PCIE_DISABLE_DVFSRC_VLT_REQ;
+	writel_relaxed(val, port->base + PCIE_MISC_CTRL_REG);
+
 	/* Assert all reset signals */
 	val = readl_relaxed(port->base + PCIE_RST_CTRL_REG);
 	val |= PCIE_MAC_RSTB | PCIE_PHY_RSTB | PCIE_BRG_RSTB | PCIE_PE_RSTB;
-- 
2.18.0