From: Alexandre Ghiti <alexghiti@rivosinc.com> To: Paul Walmsley <paul.walmsley@sifive.com>, Palmer Dabbelt <palmer@dabbelt.com>, Albert Ou <aou@eecs.berkeley.edu>, Rob Herring <robh+dt@kernel.org>, Frank Rowand <frowand.list@gmail.com>, Andrew Jones <ajones@ventanamicro.com>, Anup Patel <anup@brainfault.org>, linux-riscv@lists.infradead.org, linux-kernel@vger.kernel.org, devicetree@vger.kernel.org Cc: Alexandre Ghiti <alexghiti@rivosinc.com> Subject: [PATCH v9 2/3] riscv: Move the linear mapping creation in its own function Date: Fri, 24 Mar 2023 16:54:20 +0100 [thread overview] Message-ID: <20230324155421.271544-3-alexghiti@rivosinc.com> (raw) In-Reply-To: <20230324155421.271544-1-alexghiti@rivosinc.com> No change intended, it just splits the linear mapping creation from setup_vm_final: this prepares for upcoming additions to the linear mapping creation. Signed-off-by: Alexandre Ghiti <alexghiti@rivosinc.com> --- arch/riscv/mm/init.c | 42 ++++++++++++++++++++++++++++-------------- 1 file changed, 28 insertions(+), 14 deletions(-) diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c index cc558d94559a..3b37d8606920 100644 --- a/arch/riscv/mm/init.c +++ b/arch/riscv/mm/init.c @@ -1086,16 +1086,25 @@ asmlinkage void __init setup_vm(uintptr_t dtb_pa) pt_ops_set_fixmap(); } -static void __init setup_vm_final(void) +static void __init create_linear_mapping_range(phys_addr_t start, + phys_addr_t end) { + phys_addr_t pa; uintptr_t va, map_size; - phys_addr_t pa, start, end; - u64 i; - /* Setup swapper PGD for fixmap */ - create_pgd_mapping(swapper_pg_dir, FIXADDR_START, - __pa_symbol(fixmap_pgd_next), - PGDIR_SIZE, PAGE_TABLE); + for (pa = start; pa < end; pa += map_size) { + va = (uintptr_t)__va(pa); + map_size = best_map_size(pa, end - pa); + + create_pgd_mapping(swapper_pg_dir, va, pa, map_size, + pgprot_from_va(va)); + } +} + +static void __init create_linear_mapping_page_table(void) +{ + phys_addr_t start, end; + u64 i; /* Map all memory banks in the linear mapping */ for_each_mem_range(i, &start, &end) { @@ -1107,14 +1116,19 @@ static void __init setup_vm_final(void) if (end >= __pa(PAGE_OFFSET) + memory_limit) end = __pa(PAGE_OFFSET) + memory_limit; - for (pa = start; pa < end; pa += map_size) { - va = (uintptr_t)__va(pa); - map_size = best_map_size(pa, end - pa); - - create_pgd_mapping(swapper_pg_dir, va, pa, map_size, - pgprot_from_va(va)); - } + create_linear_mapping_range(start, end); } +} + +static void __init setup_vm_final(void) +{ + /* Setup swapper PGD for fixmap */ + create_pgd_mapping(swapper_pg_dir, FIXADDR_START, + __pa_symbol(fixmap_pgd_next), + PGDIR_SIZE, PAGE_TABLE); + + /* Map the linear mapping */ + create_linear_mapping_page_table(); /* Map the kernel */ if (IS_ENABLED(CONFIG_64BIT)) -- 2.37.2
WARNING: multiple messages have this Message-ID (diff)
From: Alexandre Ghiti <alexghiti@rivosinc.com> To: Paul Walmsley <paul.walmsley@sifive.com>, Palmer Dabbelt <palmer@dabbelt.com>, Albert Ou <aou@eecs.berkeley.edu>, Rob Herring <robh+dt@kernel.org>, Frank Rowand <frowand.list@gmail.com>, Andrew Jones <ajones@ventanamicro.com>, Anup Patel <anup@brainfault.org>, linux-riscv@lists.infradead.org, linux-kernel@vger.kernel.org, devicetree@vger.kernel.org Cc: Alexandre Ghiti <alexghiti@rivosinc.com> Subject: [PATCH v9 2/3] riscv: Move the linear mapping creation in its own function Date: Fri, 24 Mar 2023 16:54:20 +0100 [thread overview] Message-ID: <20230324155421.271544-3-alexghiti@rivosinc.com> (raw) In-Reply-To: <20230324155421.271544-1-alexghiti@rivosinc.com> No change intended, it just splits the linear mapping creation from setup_vm_final: this prepares for upcoming additions to the linear mapping creation. Signed-off-by: Alexandre Ghiti <alexghiti@rivosinc.com> --- arch/riscv/mm/init.c | 42 ++++++++++++++++++++++++++++-------------- 1 file changed, 28 insertions(+), 14 deletions(-) diff --git a/arch/riscv/mm/init.c b/arch/riscv/mm/init.c index cc558d94559a..3b37d8606920 100644 --- a/arch/riscv/mm/init.c +++ b/arch/riscv/mm/init.c @@ -1086,16 +1086,25 @@ asmlinkage void __init setup_vm(uintptr_t dtb_pa) pt_ops_set_fixmap(); } -static void __init setup_vm_final(void) +static void __init create_linear_mapping_range(phys_addr_t start, + phys_addr_t end) { + phys_addr_t pa; uintptr_t va, map_size; - phys_addr_t pa, start, end; - u64 i; - /* Setup swapper PGD for fixmap */ - create_pgd_mapping(swapper_pg_dir, FIXADDR_START, - __pa_symbol(fixmap_pgd_next), - PGDIR_SIZE, PAGE_TABLE); + for (pa = start; pa < end; pa += map_size) { + va = (uintptr_t)__va(pa); + map_size = best_map_size(pa, end - pa); + + create_pgd_mapping(swapper_pg_dir, va, pa, map_size, + pgprot_from_va(va)); + } +} + +static void __init create_linear_mapping_page_table(void) +{ + phys_addr_t start, end; + u64 i; /* Map all memory banks in the linear mapping */ for_each_mem_range(i, &start, &end) { @@ -1107,14 +1116,19 @@ static void __init setup_vm_final(void) if (end >= __pa(PAGE_OFFSET) + memory_limit) end = __pa(PAGE_OFFSET) + memory_limit; - for (pa = start; pa < end; pa += map_size) { - va = (uintptr_t)__va(pa); - map_size = best_map_size(pa, end - pa); - - create_pgd_mapping(swapper_pg_dir, va, pa, map_size, - pgprot_from_va(va)); - } + create_linear_mapping_range(start, end); } +} + +static void __init setup_vm_final(void) +{ + /* Setup swapper PGD for fixmap */ + create_pgd_mapping(swapper_pg_dir, FIXADDR_START, + __pa_symbol(fixmap_pgd_next), + PGDIR_SIZE, PAGE_TABLE); + + /* Map the linear mapping */ + create_linear_mapping_page_table(); /* Map the kernel */ if (IS_ENABLED(CONFIG_64BIT)) -- 2.37.2 _______________________________________________ linux-riscv mailing list linux-riscv@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-riscv
next prev parent reply other threads:[~2023-03-24 15:56 UTC|newest] Thread overview: 28+ messages / expand[flat|nested] mbox.gz Atom feed top 2023-03-24 15:54 [PATCH v9 0/3] riscv: Use PUD/P4D/PGD pages for the linear mapping Alexandre Ghiti 2023-03-24 15:54 ` Alexandre Ghiti 2023-03-24 15:54 ` [PATCH v9 1/3] riscv: Get rid of riscv_pfn_base variable Alexandre Ghiti 2023-03-24 15:54 ` Alexandre Ghiti 2023-03-24 15:54 ` Alexandre Ghiti [this message] 2023-03-24 15:54 ` [PATCH v9 2/3] riscv: Move the linear mapping creation in its own function Alexandre Ghiti 2023-03-27 9:39 ` Andrew Jones 2023-03-27 9:39 ` Andrew Jones 2023-03-27 12:14 ` Anup Patel 2023-03-27 12:14 ` Anup Patel 2023-03-24 15:54 ` [PATCH v9 3/3] riscv: Use PUD/P4D/PGD pages for the linear mapping Alexandre Ghiti 2023-03-24 15:54 ` Alexandre Ghiti 2023-03-27 9:39 ` Andrew Jones 2023-03-27 9:39 ` Andrew Jones 2023-03-27 11:15 ` Alexandre Ghiti 2023-03-27 11:15 ` Alexandre Ghiti 2023-03-27 11:37 ` Andrew Jones 2023-03-27 11:37 ` Andrew Jones 2023-03-27 11:37 ` Andrew Jones 2023-03-27 11:37 ` Andrew Jones 2023-03-27 12:13 ` Anup Patel 2023-03-27 12:13 ` Anup Patel 2023-03-27 12:12 ` [PATCH v9 0/3] " Anup Patel 2023-03-27 12:12 ` Anup Patel 2023-04-19 14:22 ` Palmer Dabbelt 2023-04-19 14:22 ` Palmer Dabbelt 2023-04-19 14:30 ` patchwork-bot+linux-riscv 2023-04-19 14:30 ` patchwork-bot+linux-riscv
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20230324155421.271544-3-alexghiti@rivosinc.com \ --to=alexghiti@rivosinc.com \ --cc=ajones@ventanamicro.com \ --cc=anup@brainfault.org \ --cc=aou@eecs.berkeley.edu \ --cc=devicetree@vger.kernel.org \ --cc=frowand.list@gmail.com \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-riscv@lists.infradead.org \ --cc=palmer@dabbelt.com \ --cc=paul.walmsley@sifive.com \ --cc=robh+dt@kernel.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.