Re: [PATCH v7 9/9] arm64: dts: qcom: sa8540-ride: Enable first port of tertiary usb controller

[Krishna Kurapati PSSNV <quic_kriskura@quicinc.com>]

On 5/2/2023 4:37 PM, Konrad Dybcio wrote:
> 
> 
> On 1.05.2023 16:34, Krishna Kurapati wrote:
>> There is now support for the multiport USB controller this uses so
>> enable it.
>>
>> The board only has a single port hooked up (despite it being wired up to
>> the multiport IP on the SoC). There's also a USB 2.0 mux hooked up,
>> which by default on boot is selected to mux properly. Grab the gpio
>> controlling that and ensure it stays in the right position so USB 2.0
>> continues to be routed from the external port to the SoC.
>>
>> Signed-off-by: Andrew Halaney <ahalaney@redhat.com>
>> Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
>> ---
> same comments as patch 8
> 
> Konrad

Hi Konrad,

   Sure, will add a default value for drive-strength for this pinctrl node.

Hi Andrew Halaney,

  I currently don't have a Ride device with me to test this change. Can 
you help test this patch on SA8540-Ride including (drive-strength = 
<2>;) property (which I believe is the default value).

I can test the same on SA8295-ADP and can push the next version quickly.

Regards,
Krishna,

>>   arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 22 ++++++++++++++++++++++
>>   1 file changed, 22 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
>> index 24fa449d48a6..53d47593306e 100644
>> --- a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
>> +++ b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
>> @@ -309,6 +309,19 @@ &usb_2_qmpphy0 {
>>   	status = "okay";
>>   };
>>   
>> +&usb_2 {
>> +	pinctrl-names = "default";
>> +	pinctrl-0 = <&usb2_en_state>;
>> +
>> +	status = "okay";
>> +};
>> +
>> +&usb_2_dwc3 {
>> +	dr_mode = "host";
>> +	phy-names = "usb2-port0", "usb3-port0";
>> +	phys = <&usb_2_hsphy0>, <&usb_2_qmpphy0>;
>> +};
>> +
>>   &xo_board_clk {
>>   	clock-frequency = <38400000>;
>>   };
>> @@ -401,4 +414,13 @@ wake-pins {
>>   			bias-pull-up;
>>   		};
>>   	};
>> +
>> +	usb2_en_state: usb2-en-state {
>> +		/* TS3USB221A USB2.0 mux select */
>> +		pins = "gpio24";
>> +		function = "gpio";
>> +		drive-strength = <2>;
>> +		bias-disable;
>> +		output-low;
>> +	};
>>   };