Re: [PATCH v2 1/2] dt-bindings: spi: Add schema for Cadence QSPI Controller driver

["Ramuthevar, Vadivel MuruganX" <vadivel.muruganx.ramuthevar@linux.intel.com>]

Hi Vignesh,

On 5/11/2019 12:30 PM, Vignesh Raghavendra wrote:
> Hi,
>
> On 30/10/19 1:41 PM, Ramuthevar,Vadivel MuruganX wrote:
>> From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@linux.intel.com>
>>
>> Add dt-bindings documentation for Cadence-QSPI controller to support
>> spi based flash memories.
>>
> The new driver being added in patch 2/2 is supposed to replace
> drivers/mtd/spi-nor/cadence-quadspi.c. Therefore the bindings should be
> exactly same as
> Documentation/devicetree/bindings/mtd/cadence-quadspi.txt. Otherwise, it
> breaks DT backward compatibility. There cannot be two different sets of
> bindings for same HW IP.
>
> Therefore please rewrite yaml schema to match existing bindings at
> Documentation/devicetree/bindings/mtd/cadence-quadspi.txt.
> And then include a patch dropping older bindings.
sure, I will create dt-schema for the below file

Documentation/devicetree/bindings/mtd/cadence-quadspi.txt

---
With Best Regards
Vadivel

>
>> Signed-off-by: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@linux.intel.com>
>> ---
>>   .../devicetree/bindings/spi/cadence,qspi.yaml      | 65 ++++++++++++++++++++++
>>   1 file changed, 65 insertions(+)
>>   create mode 100644 Documentation/devicetree/bindings/spi/cadence,qspi.yaml
>>
>> diff --git a/Documentation/devicetree/bindings/spi/cadence,qspi.yaml b/Documentation/devicetree/bindings/spi/cadence,qspi.yaml
>> new file mode 100644
>> index 000000000000..295501f01e5e
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/spi/cadence,qspi.yaml
>> @@ -0,0 +1,65 @@
>> +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
>> +%YAML 1.2
>> +---
>> +$id: "http://devicetree.org/schemas/spi/cadence,qspi.yaml#"
>> +$schema: "http://devicetree.org/meta-schemas/core.yaml#"
>> +
>> +title: Cadence QSPI Flash Controller support
>> +
>> +maintainers:
>> +  - Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@linux.intel.com>
>> +
>> +allOf:
>> +  - $ref: "spi-controller.yaml#"
>> +
>> +description: |
>> +  Add support for the Cadence QSPI controller,This controller is
>> +  present in the Intel LGM, Altera SoCFPGA and TI SoCs and this driver
>> +  has been tested On Intel's LGM SoC.
>> +
>> +properties:
>> +  compatible:
>> +    const: cadence,qspi
>> +
>> +  reg:
>> +    maxItems: 1
>> +
>> +  clocks:
>> +    maxItems: 1
>> +
>> +  clocks-names:
>> +    maxItems: 1
>> +
>> +  resets:
>> +    maxItems: 1
>> +
>> +  reset-names:
>> +    maxItems: 1
>> +
>> +required:
>> +  - compatible
>> +  - reg
>> +  - clocks
>> +  - clock-names
>> +  - resets
>> +  - reset-names
>> +
>> +examples:
>> +  - |
>> +    spi@ec000000 {
>> +          compatible = "cadence,qspi";
>> +          reg = <0xec000000 0x100>;
>> +          clocks = <&cgu0 LGM_CLK_QSPI>, <&cgu0 LGM_GCLK_QSPI>;
>> +          clock-names = "qspi";
>> +          resets = <&rcu0 0x10 1>;
>> +          reset-names = "qspi";
>> +          #address-cells = <1>;
>> +          #size-cells = <0>;
>> +
>> +          flash: flash@1 {
>> +              compatible = "spi-nand", "jedec, spi-nor";
> s/"jedec, spi-nor"/"jedec,spi-nor" (i.e no space after comma)
>
>> +              reg = <1>;
>> +              spi-max-frequency = <10000000>;
>> +          };
>> +    };
>> +
>>