[U-Boot] MX31 NAND Boot Patch - u-boot/next branch

[U-Boot] MX31 NAND Boot Patch - u-boot/next branch

[Ulrich Gerster]

Hello all,

I like to use u-boot to boot from NAND flash on a board with the i.MX31.

I found your posings about the patch series ([U-Boot] [PATCH v4 0/6] MX31: NAND boot for PDK boards.) which I gladly like to test for my board. You wrote that the patches apply to u-boot/next. My problem is that I can't find a branch with name "next" in the u-boot git. 
Can you help me to get this branch?

Thanks a lot, Ulrich Gerster

[U-Boot] MX31 NAND Boot Patch - u-boot/next branch

[Wolfgang Denk]

Dear "Ulrich Gerster",

In message <4A38DCEB0200004D0001477C@hochblauen.ba-loerrach.de> you wrote:
> 
> I found your posings about the patch series ([U-Boot] [PATCH v4 0/6] MX31: NAND boot for PDK boards.) which I gladly like to test for my board. You wrote that the patches apply to u-boot/next. My problem is that I can't find a branch with name "next" in
>  the u-boot git. 
> Can you help me to get this branch?

It does not exist any more. After the release of U-Boot v2009.06 last
Sunday the "next" branch was merged into mainline ("master" branch)
and ceased to exist.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Landing: a controlled mid-air collision with a planet.

[U-Boot] MX31 NAND Boot Patch - u-boot/next branch

[Magnus Lilja]

2009/6/17 Wolfgang Denk <wd@denx.de>:
> Dear "Ulrich Gerster",
>
> In message <4A38DCEB0200004D0001477C@hochblauen.ba-loerrach.de> you wrote:
>>
>> I found your posings about the patch series ([U-Boot] [PATCH v4 0/6] MX31: NAND boot for PDK boards.) which I gladly like to test for my board. You wrote that the patches apply to u-boot/next. My problem is that I can't find a branch with name "next" in
>> ?the u-boot git.
>> Can you help me to get this branch?
>
> It does not exist any more. After the release of U-Boot v2009.06 last
> Sunday the "next" branch was merged into mainline ("master" branch)
> and ceased to exist.

That patch series applies and compiles nicely on the current mainline
master branch, haven't tested it on hardware though.

Regards, Magnus

[U-Boot] MX31 NAND Boot Patch - u-boot/next branch

[Ulrich Gerster]

Hello,

I applied the patch series v4. That worked nicely.
But know I'm not sure if I have to apply the patches from previous versions too?

My main concern is the file "mx31_nand.c" in drivers/mtd/nand/. In previous versions of the patch you always worked with this file to add the NAND Flash Controller driver. Is this in the newer version implemented in an other way? Or do I have to apply part of the older patches aswell?

Thanks a lot,
Ulrich Gerster