[U-Boot] [PATCH] powerpc: do not fixup NULL ptrs

[Schwarz,Andre <andre.schwarz@matrix-vision.de>]

Wolfgang,



Wolfgang Denk <wd@denx.de> hat am 24. Oktober 2010 um 22:18 geschrieben:

> Dear "Schwarz,Andre",
>
> In message <1702240919.111.1287950899754.JavaMail.open-xchange@proteus> you
> wrote:
> >
> > Since I assume Wolfgang won't accept a board specific "add 4 nops after
> > _start"-patch I'd like to solve this without trial and error.
>
> To the best of my knowledge no board made use f this "warmboot" entry
> point. OK, I wasn't aware that Jocke obviously did something lioke
> this, so there might be other boards as well - but it's unlikely.
>
> > Of course digging into this is beyond my knowledge and any help would be
> > appreciated.
> > I simply can't think of being the only one having this issue...
>
> Check how your board implements the "reset" command - I cannot see any
> specific code for that in your sources, so it looks mostly harmless to
> me.?
this is what I don't understand :
?
The broken boards are *dead*, i.e. no single character on the serial line.
To me this means even the initial code running from flash isn't executed
properly.
IMHO this doesn't look like something like a problem after relocation ... it's
something more fundamental.
?
The boards in question are using low boot, i.e. reset vector @ 0x100.
There's normal power-on-reset sequencing and no such thing like a reboot or
"warm" reset.
?
Without that patch the boards are running fine.

I can see no obvious difference between working and broken boards.

I'd be happy to hear that the error is caused by something hidden within board
specific code.

Reards,
Andr?

MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner