All of lore.kernel.org
 help / color / mirror / Atom feed
From: halli manjunatha <manjunatha_halli@ti.com>
To: Mauro Carvalho Chehab <mchehab@redhat.com>
Cc: linux-media <linux-media@vger.kernel.org>,
	linux-kernel <linux-kernel@vger.kernel.org>,
	"Matti J. Aaltonen" <matti.j.aaltonen@nokia.com>
Subject: Re: [GIT PULL] TI WL 128x FM V4L2 driver
Date: Mon, 28 Feb 2011 18:42:34 +0530	[thread overview]
Message-ID: <AANLkTikfyVfxUX3LXnpOPZWNmG7zSpDY9itn+BHxhdo6@mail.gmail.com> (raw)
In-Reply-To: <4D6A2E73.6070806@redhat.com>

On Sun, Feb 27, 2011 at 4:28 PM, Mauro Carvalho Chehab
<mchehab@redhat.com> wrote:
>
> Em 25-01-2011 03:48, halli manjunatha escreveu:
> > Hi Mauro,
> >
> > Please pull the WL128x FM V4L2 driver from
> > http://dev.omapzoom.org/pub/scm/manju/L24x-btfm.git fm_v4l2_upstream
> >
> > This is TI WL128x FM V4L2 driver and it introduces ‘wl128x’ folder
> > under the ‘drivers/media/radio’. This driver enables support for FM RX
> > and TX for Texas Instrument's WL128x (also compatible with WL127x)
> > WiLink chip sets. The V4L2 FM driver can work in either Rx or Tx mode,
> > and V4L2 interfaces are provided for both.
> >
> > Texas Instrument's WL128x chip set packs BT, FM, GPS and WLAN in a
> > single die with BT, FM and GPS being interfaced over a single UART.
> > This driver works on top of the shared transport line discipline
> > driver. This driver can also be made use for the WL127x version of the
> > chip which packs BT, FM and WLAN only.
> >
> > This driver has been reviewed by various folks within TI and also in
> > Linux media community. The driver has been tested extensively on TI
> > platforms and we believe that it is ready for merge into mainline.
>
> Applied, thanks.
>
> From what I understood from your comments, this driver will also cover
> wl127x chips. As such, it would be better to double check if all functionalities
> present at drivers/media/radio/radio-wl1273.c (assuming that wl1273 is covered)
> are also on the new driver, and, if not, merge the remaining ones and deprecate
> the wl1273-specific driver.
>
> Cheers,
> Mauro

Yes, this driver supports all the functionalities which are supported
by radio-wl1273.c [But our driver is on UART while wl1273 is based on
i2c..]

NOTE: V4L2 FM driver depend upon an underlying TI_ST driver which is
the core transport driver [based on UART, it is a ldisc driver]

Updates to TI-ST driver happen on linux-next tree on kernel.org and
are planned to be released in 2.6.39.

Since your tree
@[http://git.linuxtv.org/media_tree.git?a=shortlog;h=refs/heads/staging/for_v2.6.39]

lags behind the linux-next tree, the recent updates to TI-ST driver
are missing on your tree.

Unfortunately these would cause a build failure for the V4L2 driver,
since the APIs have changed on the TI-ST driver.


So, I will provide you one patch to make the present driver to work
with latest ST driver once your tree moves to 2.6.38-rc6+ kernel.

Regards
Manju
> >
> > The following changes since commit db309d3d54c2f721dd1176ce86c63b0381c0a258:
> >   Mauro Carvalho Chehab (1):
> >         [media] add support for Encore FM3
> >
> > are available in the git repository at:
> >
> >   http://dev.omapzoom.org/pub/scm/manju/L24x-btfm.git fm_v4l2_upstream
> >
> > Manjunatha Halli (7):
> >       drivers:media:radio: wl128x: FM Driver common header file
> >       drivers:media:radio: wl128x: FM Driver V4L2 sources
> >       drivers:media:radio: wl128x: FM Driver Common sources
> >       drivers:media:radio: wl128x: FM driver RX sources
> >       drivers:media:radio: wl128x: FM driver TX sources
> >       drivers:media:radio: wl128x: Kconfig & Makefile for wl128x driver
> >       drivers:media:radio: Update Kconfig and Makefile for wl128x FM driver
> >
> >  drivers/media/radio/Kconfig               |    3 +
> >  drivers/media/radio/Makefile              |    1 +
> >  drivers/media/radio/wl128x/Kconfig        |   17 +
> >  drivers/media/radio/wl128x/Makefile       |    6 +
> >  drivers/media/radio/wl128x/fmdrv.h        |  244 +++++
> >  drivers/media/radio/wl128x/fmdrv_common.c | 1677 +++++++++++++++++++++++++++++
> >  drivers/media/radio/wl128x/fmdrv_common.h |  402 +++++++
> >  drivers/media/radio/wl128x/fmdrv_rx.c     |  847 +++++++++++++++
> >  drivers/media/radio/wl128x/fmdrv_rx.h     |   59 +
> >  drivers/media/radio/wl128x/fmdrv_tx.c     |  425 ++++++++
> >  drivers/media/radio/wl128x/fmdrv_tx.h     |   37 +
> >  drivers/media/radio/wl128x/fmdrv_v4l2.c   |  580 ++++++++++
> >  drivers/media/radio/wl128x/fmdrv_v4l2.h   |   33 +
> >  13 files changed, 4331 insertions(+), 0 deletions(-)
> >  create mode 100644 drivers/media/radio/wl128x/Kconfig
> >  create mode 100644 drivers/media/radio/wl128x/Makefile
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv.h
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_common.c
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_common.h
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_rx.c
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_rx.h
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_tx.c
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_tx.h
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_v4l2.c
> >  create mode 100644 drivers/media/radio/wl128x/fmdrv_v4l2.h
> >
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-media" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html

      reply	other threads:[~2011-02-28 13:14 UTC|newest]

Thread overview: 8+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2011-01-25  5:48 [GIT PULL] TI WL 128x FM V4L2 driver halli manjunatha
2011-01-25 15:04 ` Mark Brown
2011-01-27  9:32   ` halli manjunatha
2011-01-27  9:54     ` Mark Brown
2011-01-27 11:43       ` Ohad Ben-Cohen
     [not found] ` <AANLkTingOYyEs4ZZrcaV0NOhiuGzSpvkATPRFjhFMCmE@mail.gmail.com>
2011-02-14 12:28   ` halli manjunatha
2011-02-27 10:58 ` Mauro Carvalho Chehab
2011-02-28 13:12   ` halli manjunatha [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=AANLkTikfyVfxUX3LXnpOPZWNmG7zSpDY9itn+BHxhdo6@mail.gmail.com \
    --to=manjunatha_halli@ti.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-media@vger.kernel.org \
    --cc=matti.j.aaltonen@nokia.com \
    --cc=mchehab@redhat.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.