From: Benjamin Gaignard <benjamin.gaignard@linaro.org> To: Benjamin Gaignard <benjamin.gaignard@st.com> Cc: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>, Maxime Ripard <mripard@kernel.org>, Sean Paul <sean@poorly.run>, David Airlie <airlied@linux.ie>, Daniel Vetter <daniel@ffwll.ch>, Linux Kernel Mailing List <linux-kernel@vger.kernel.org>, ML dri-devel <dri-devel@lists.freedesktop.org> Subject: Re: [PATCH] drm/modes: remove unused variables Date: Tue, 3 Dec 2019 17:50:00 +0100 [thread overview] Message-ID: <CA+M3ks7gN7kpau1hN94vq0nhOfdc=9KFoSrM4TJE_2diyMMiRA@mail.gmail.com> (raw) In-Reply-To: <20191119134706.10893-1-benjamin.gaignard@st.com> Le mer. 20 nov. 2019 à 00:29, Benjamin Gaignard <benjamin.gaignard@st.com> a écrit : > > When compiling with W=1 few warnings about unused variables show up. > This patch removes all the involved variables. > Gentle ping to reviewers. Thanks, Benjamin > Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com> > --- > drivers/gpu/drm/drm_modes.c | 22 +++------------------- > 1 file changed, 3 insertions(+), 19 deletions(-) > > diff --git a/drivers/gpu/drm/drm_modes.c b/drivers/gpu/drm/drm_modes.c > index 88232698d7a0..aca901aff042 100644 > --- a/drivers/gpu/drm/drm_modes.c > +++ b/drivers/gpu/drm/drm_modes.c > @@ -233,7 +233,7 @@ struct drm_display_mode *drm_cvt_mode(struct drm_device *dev, int hdisplay, > /* 3) Nominal HSync width (% of line period) - default 8 */ > #define CVT_HSYNC_PERCENTAGE 8 > unsigned int hblank_percentage; > - int vsyncandback_porch, vback_porch, hblank; > + int vsyncandback_porch, hblank; > > /* estimated the horizontal period */ > tmp1 = HV_FACTOR * 1000000 - > @@ -249,7 +249,6 @@ struct drm_display_mode *drm_cvt_mode(struct drm_device *dev, int hdisplay, > else > vsyncandback_porch = tmp1; > /* 10. Find number of lines in back porch */ > - vback_porch = vsyncandback_porch - vsync; > drm_mode->vtotal = vdisplay_rnd + 2 * vmargin + > vsyncandback_porch + CVT_MIN_V_PORCH; > /* 5) Definition of Horizontal blanking time limitation */ > @@ -386,9 +385,8 @@ drm_gtf_mode_complex(struct drm_device *dev, int hdisplay, int vdisplay, > int top_margin, bottom_margin; > int interlace; > unsigned int hfreq_est; > - int vsync_plus_bp, vback_porch; > - unsigned int vtotal_lines, vfieldrate_est, hperiod; > - unsigned int vfield_rate, vframe_rate; > + int vsync_plus_bp; > + unsigned int vtotal_lines; > int left_margin, right_margin; > unsigned int total_active_pixels, ideal_duty_cycle; > unsigned int hblank, total_pixels, pixel_freq; > @@ -451,23 +449,9 @@ drm_gtf_mode_complex(struct drm_device *dev, int hdisplay, int vdisplay, > /* [V SYNC+BP] = RINT(([MIN VSYNC+BP] * hfreq_est / 1000000)) */ > vsync_plus_bp = MIN_VSYNC_PLUS_BP * hfreq_est / 1000; > vsync_plus_bp = (vsync_plus_bp + 500) / 1000; > - /* 9. Find the number of lines in V back porch alone: */ > - vback_porch = vsync_plus_bp - V_SYNC_RQD; > /* 10. Find the total number of lines in Vertical field period: */ > vtotal_lines = vdisplay_rnd + top_margin + bottom_margin + > vsync_plus_bp + GTF_MIN_V_PORCH; > - /* 11. Estimate the Vertical field frequency: */ > - vfieldrate_est = hfreq_est / vtotal_lines; > - /* 12. Find the actual horizontal period: */ > - hperiod = 1000000 / (vfieldrate_rqd * vtotal_lines); > - > - /* 13. Find the actual Vertical field frequency: */ > - vfield_rate = hfreq_est / vtotal_lines; > - /* 14. Find the Vertical frame frequency: */ > - if (interlaced) > - vframe_rate = vfield_rate / 2; > - else > - vframe_rate = vfield_rate; > /* 15. Find number of pixels in left margin: */ > if (margins) > left_margin = (hdisplay_rnd * GTF_MARGIN_PERCENTAGE + 500) / > -- > 2.15.0 > > _______________________________________________ > dri-devel mailing list > dri-devel@lists.freedesktop.org > https://lists.freedesktop.org/mailman/listinfo/dri-devel
WARNING: multiple messages have this Message-ID (diff)
From: Benjamin Gaignard <benjamin.gaignard@linaro.org> To: Benjamin Gaignard <benjamin.gaignard@st.com> Cc: David Airlie <airlied@linux.ie>, Linux Kernel Mailing List <linux-kernel@vger.kernel.org>, ML dri-devel <dri-devel@lists.freedesktop.org>, Sean Paul <sean@poorly.run> Subject: Re: [PATCH] drm/modes: remove unused variables Date: Tue, 3 Dec 2019 17:50:00 +0100 [thread overview] Message-ID: <CA+M3ks7gN7kpau1hN94vq0nhOfdc=9KFoSrM4TJE_2diyMMiRA@mail.gmail.com> (raw) In-Reply-To: <20191119134706.10893-1-benjamin.gaignard@st.com> Le mer. 20 nov. 2019 à 00:29, Benjamin Gaignard <benjamin.gaignard@st.com> a écrit : > > When compiling with W=1 few warnings about unused variables show up. > This patch removes all the involved variables. > Gentle ping to reviewers. Thanks, Benjamin > Signed-off-by: Benjamin Gaignard <benjamin.gaignard@st.com> > --- > drivers/gpu/drm/drm_modes.c | 22 +++------------------- > 1 file changed, 3 insertions(+), 19 deletions(-) > > diff --git a/drivers/gpu/drm/drm_modes.c b/drivers/gpu/drm/drm_modes.c > index 88232698d7a0..aca901aff042 100644 > --- a/drivers/gpu/drm/drm_modes.c > +++ b/drivers/gpu/drm/drm_modes.c > @@ -233,7 +233,7 @@ struct drm_display_mode *drm_cvt_mode(struct drm_device *dev, int hdisplay, > /* 3) Nominal HSync width (% of line period) - default 8 */ > #define CVT_HSYNC_PERCENTAGE 8 > unsigned int hblank_percentage; > - int vsyncandback_porch, vback_porch, hblank; > + int vsyncandback_porch, hblank; > > /* estimated the horizontal period */ > tmp1 = HV_FACTOR * 1000000 - > @@ -249,7 +249,6 @@ struct drm_display_mode *drm_cvt_mode(struct drm_device *dev, int hdisplay, > else > vsyncandback_porch = tmp1; > /* 10. Find number of lines in back porch */ > - vback_porch = vsyncandback_porch - vsync; > drm_mode->vtotal = vdisplay_rnd + 2 * vmargin + > vsyncandback_porch + CVT_MIN_V_PORCH; > /* 5) Definition of Horizontal blanking time limitation */ > @@ -386,9 +385,8 @@ drm_gtf_mode_complex(struct drm_device *dev, int hdisplay, int vdisplay, > int top_margin, bottom_margin; > int interlace; > unsigned int hfreq_est; > - int vsync_plus_bp, vback_porch; > - unsigned int vtotal_lines, vfieldrate_est, hperiod; > - unsigned int vfield_rate, vframe_rate; > + int vsync_plus_bp; > + unsigned int vtotal_lines; > int left_margin, right_margin; > unsigned int total_active_pixels, ideal_duty_cycle; > unsigned int hblank, total_pixels, pixel_freq; > @@ -451,23 +449,9 @@ drm_gtf_mode_complex(struct drm_device *dev, int hdisplay, int vdisplay, > /* [V SYNC+BP] = RINT(([MIN VSYNC+BP] * hfreq_est / 1000000)) */ > vsync_plus_bp = MIN_VSYNC_PLUS_BP * hfreq_est / 1000; > vsync_plus_bp = (vsync_plus_bp + 500) / 1000; > - /* 9. Find the number of lines in V back porch alone: */ > - vback_porch = vsync_plus_bp - V_SYNC_RQD; > /* 10. Find the total number of lines in Vertical field period: */ > vtotal_lines = vdisplay_rnd + top_margin + bottom_margin + > vsync_plus_bp + GTF_MIN_V_PORCH; > - /* 11. Estimate the Vertical field frequency: */ > - vfieldrate_est = hfreq_est / vtotal_lines; > - /* 12. Find the actual horizontal period: */ > - hperiod = 1000000 / (vfieldrate_rqd * vtotal_lines); > - > - /* 13. Find the actual Vertical field frequency: */ > - vfield_rate = hfreq_est / vtotal_lines; > - /* 14. Find the Vertical frame frequency: */ > - if (interlaced) > - vframe_rate = vfield_rate / 2; > - else > - vframe_rate = vfield_rate; > /* 15. Find number of pixels in left margin: */ > if (margins) > left_margin = (hdisplay_rnd * GTF_MARGIN_PERCENTAGE + 500) / > -- > 2.15.0 > > _______________________________________________ > dri-devel mailing list > dri-devel@lists.freedesktop.org > https://lists.freedesktop.org/mailman/listinfo/dri-devel _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel
next prev parent reply other threads:[~2019-12-03 16:50 UTC|newest] Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top 2019-11-19 13:47 [PATCH] drm/modes: remove unused variables Benjamin Gaignard 2019-11-19 13:47 ` Benjamin Gaignard 2019-11-19 13:47 ` Benjamin Gaignard 2019-12-03 16:50 ` Benjamin Gaignard [this message] 2019-12-03 16:50 ` Benjamin Gaignard 2019-12-04 9:35 ` Thomas Zimmermann 2019-12-04 9:35 ` Thomas Zimmermann 2019-12-04 10:07 ` Benjamin GAIGNARD 2019-12-04 10:07 ` Benjamin GAIGNARD 2019-12-05 9:55 ` Jani Nikula 2019-12-05 9:55 ` Jani Nikula 2019-12-05 10:23 ` Benjamin GAIGNARD 2019-12-05 10:23 ` Benjamin GAIGNARD 2019-12-10 9:52 ` Daniel Vetter 2019-12-10 9:52 ` Daniel Vetter
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to='CA+M3ks7gN7kpau1hN94vq0nhOfdc=9KFoSrM4TJE_2diyMMiRA@mail.gmail.com' \ --to=benjamin.gaignard@linaro.org \ --cc=airlied@linux.ie \ --cc=benjamin.gaignard@st.com \ --cc=daniel@ffwll.ch \ --cc=dri-devel@lists.freedesktop.org \ --cc=linux-kernel@vger.kernel.org \ --cc=maarten.lankhorst@linux.intel.com \ --cc=mripard@kernel.org \ --cc=sean@poorly.run \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.