[GIT PULL] ARM: aspeed: defconfig changes for 5.10

* [GIT PULL] ARM: aspeed: defconfig changes for 5.10
@ 2020-09-11  6:33 Joel Stanley
  0 siblings, 0 replies; only message in thread
From: Joel Stanley @ 2020-09-11  6:33 UTC (permalink / raw)
  To: arm, SoC Team; +Cc: Andrew Jeffery, linux-aspeed, Linux ARM

Hello Soc maintainers,

Here are some ASPEED defconfig changes for 5.10. Please pull them!

The following changes since commit 74976e861309e4bf7f3e7e93f56ca3a6e0e1eca9:

  ARM: config: aspeed_g5: Enable IBM OP Panel driver (2020-09-11 15:25:24 +0930)

are available in the Git repository at:

  git://git.kernel.org/pub/scm/linux/kernel/git/joel/aspeed.git
tags/aspeed-5.10-defconfig

for you to fetch changes up to 74976e861309e4bf7f3e7e93f56ca3a6e0e1eca9:

  ARM: config: aspeed_g5: Enable IBM OP Panel driver (2020-09-11 15:25:24 +0930)

----------------------------------------------------------------
ASPEED defconfig updates for 5.10

 - Fix an issue with unwanted media drivers being enabled

 - New driver: IBM OP Panel, used on ast2600 systems. This requires
   enabling I2C slave mode

 - Enable I2C MUX GPIO driver

----------------------------------------------------------------
Joel Stanley (3):
      ARM: config: aspeed: Fix selection of media drivers
      ARM: config: aspeed-g5: Enable I2C GPIO mux driver
      ARM: config: aspeed_g5: Enable IBM OP Panel driver

 arch/arm/configs/aspeed_g5_defconfig | 15 +++++----------
 1 file changed, 5 insertions(+), 10 deletions(-)

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

^ permalink raw reply	[flat|nested] only message in thread