From: dillon min <dillon.minfei@gmail.com> To: Alexandre Torgue <alexandre.torgue@st.com> Cc: robh+dt@kernel.org, mcoquelin.stm32@gmail.com, Mark Brown <broonie@kernel.org>, p.zabel@pengutronix.de, devicetree@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, linux-spi@vger.kernel.org, linux-stm32@st-md-mailman.stormreply.com, Hua Dillon <dillonhua@gmail.com> Subject: Re: [PATCH 2/3] ARM: dts: stm32: enable l3gd20 on stm32429-disco board Date: Mon, 11 May 2020 17:05:23 +0800 [thread overview] Message-ID: <CAL9mu0+5T3q8V8Ng_1jfPGfBxDWzgd7T1hzcdUXj23-rEtOgfg@mail.gmail.com> (raw) In-Reply-To: <404e7f47-9c0f-44b1-aedb-a8d3af832d40@st.com> Hi, Alexandre, Thanks for review. On Mon, May 11, 2020 at 3:17 PM Alexandre Torgue <alexandre.torgue@st.com> wrote: > > Hi > > On 5/9/20 8:58 AM, dillon.minfei@gmail.com wrote: > > From: dillon min <dillon.minfei@gmail.com> > > > > Enable l3gd20 on stm32429-disco board. > > You could add some words about l3gd20 ok, thanks, i will add some description about l3gd20. > > > > > Signed-off-by: dillon min <dillon.minfei@gmail.com> > > --- > > arch/arm/boot/dts/stm32f429-disco.dts | 24 ++++++++++++++++++++++++ > > 1 file changed, 24 insertions(+) > > > > diff --git a/arch/arm/boot/dts/stm32f429-disco.dts b/arch/arm/boot/dts/stm32f429-disco.dts > > index 30c0f67..d365358 100644 > > --- a/arch/arm/boot/dts/stm32f429-disco.dts > > +++ b/arch/arm/boot/dts/stm32f429-disco.dts > > @@ -49,6 +49,8 @@ > > #include "stm32f429.dtsi" > > #include "stm32f429-pinctrl.dtsi" > > #include <dt-bindings/input/input.h> > > +#include <dt-bindings/interrupt-controller/irq.h> > > +#include <dt-bindings/gpio/gpio.h> > > > > / { > > model = "STMicroelectronics STM32F429i-DISCO board"; > > @@ -127,3 +129,25 @@ > > pinctrl-names = "default"; > > status = "okay"; > > }; > > + > > +&spi5 { > > + status = "okay"; > > + pinctrl-0 = <&spi5_pins>; > > + pinctrl-names = "default"; > > + #address-cells = <1>; > > + #size-cells = <0>; > > + cs-gpios = <&gpioc 1 GPIO_ACTIVE_LOW>; > > + dmas = <&dma2 3 2 0x400 0x0>, > > + <&dma2 4 2 0x400 0x0>; > > + dma-names = "rx", "tx"; > > Insert blank line here. ok > > > + l3gd20: l3gd20@0 { > > + compatible = "st,l3gd20-gyro"; > > + spi-max-frequency = <10000000>; > > + st,drdy-int-pin = <2>; > > + interrupt-parent = <&gpioa>; > > + interrupts = <1 IRQ_TYPE_EDGE_RISING>, > > + <2 IRQ_TYPE_EDGE_RISING>; > > + reg = <0>; > > + status = "okay"; > > + }; > > +}; > >
WARNING: multiple messages have this Message-ID (diff)
From: dillon min <dillon.minfei@gmail.com> To: Alexandre Torgue <alexandre.torgue@st.com> Cc: devicetree@vger.kernel.org, Hua Dillon <dillonhua@gmail.com>, mcoquelin.stm32@gmail.com, linux-kernel@vger.kernel.org, robh+dt@kernel.org, linux-spi@vger.kernel.org, Mark Brown <broonie@kernel.org>, p.zabel@pengutronix.de, linux-stm32@st-md-mailman.stormreply.com, linux-arm-kernel@lists.infradead.org Subject: Re: [PATCH 2/3] ARM: dts: stm32: enable l3gd20 on stm32429-disco board Date: Mon, 11 May 2020 17:05:23 +0800 [thread overview] Message-ID: <CAL9mu0+5T3q8V8Ng_1jfPGfBxDWzgd7T1hzcdUXj23-rEtOgfg@mail.gmail.com> (raw) In-Reply-To: <404e7f47-9c0f-44b1-aedb-a8d3af832d40@st.com> Hi, Alexandre, Thanks for review. On Mon, May 11, 2020 at 3:17 PM Alexandre Torgue <alexandre.torgue@st.com> wrote: > > Hi > > On 5/9/20 8:58 AM, dillon.minfei@gmail.com wrote: > > From: dillon min <dillon.minfei@gmail.com> > > > > Enable l3gd20 on stm32429-disco board. > > You could add some words about l3gd20 ok, thanks, i will add some description about l3gd20. > > > > > Signed-off-by: dillon min <dillon.minfei@gmail.com> > > --- > > arch/arm/boot/dts/stm32f429-disco.dts | 24 ++++++++++++++++++++++++ > > 1 file changed, 24 insertions(+) > > > > diff --git a/arch/arm/boot/dts/stm32f429-disco.dts b/arch/arm/boot/dts/stm32f429-disco.dts > > index 30c0f67..d365358 100644 > > --- a/arch/arm/boot/dts/stm32f429-disco.dts > > +++ b/arch/arm/boot/dts/stm32f429-disco.dts > > @@ -49,6 +49,8 @@ > > #include "stm32f429.dtsi" > > #include "stm32f429-pinctrl.dtsi" > > #include <dt-bindings/input/input.h> > > +#include <dt-bindings/interrupt-controller/irq.h> > > +#include <dt-bindings/gpio/gpio.h> > > > > / { > > model = "STMicroelectronics STM32F429i-DISCO board"; > > @@ -127,3 +129,25 @@ > > pinctrl-names = "default"; > > status = "okay"; > > }; > > + > > +&spi5 { > > + status = "okay"; > > + pinctrl-0 = <&spi5_pins>; > > + pinctrl-names = "default"; > > + #address-cells = <1>; > > + #size-cells = <0>; > > + cs-gpios = <&gpioc 1 GPIO_ACTIVE_LOW>; > > + dmas = <&dma2 3 2 0x400 0x0>, > > + <&dma2 4 2 0x400 0x0>; > > + dma-names = "rx", "tx"; > > Insert blank line here. ok > > > + l3gd20: l3gd20@0 { > > + compatible = "st,l3gd20-gyro"; > > + spi-max-frequency = <10000000>; > > + st,drdy-int-pin = <2>; > > + interrupt-parent = <&gpioa>; > > + interrupts = <1 IRQ_TYPE_EDGE_RISING>, > > + <2 IRQ_TYPE_EDGE_RISING>; > > + reg = <0>; > > + status = "okay"; > > + }; > > +}; > > _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2020-05-11 9:06 UTC|newest] Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top 2020-05-09 6:58 [PATCH 0/3] Enable l3gd20 on stm32f429-disco board dillon.minfei 2020-05-09 6:58 ` dillon.minfei 2020-05-09 6:58 ` [PATCH 1/3] ARM: dts: stm32: Add pin map for spi5 " dillon.minfei 2020-05-09 6:58 ` dillon.minfei 2020-05-09 6:58 ` [PATCH 2/3] ARM: dts: stm32: enable l3gd20 on stm32429-disco board dillon.minfei 2020-05-09 6:58 ` dillon.minfei 2020-05-11 7:16 ` Alexandre Torgue 2020-05-11 7:16 ` Alexandre Torgue 2020-05-11 9:05 ` dillon min [this message] 2020-05-11 9:05 ` dillon min 2020-05-09 6:58 ` [PATCH 3/3] spi: stm32: Add SPI_SIMPLEX_RX, SPI_3WIRE_RX support for stm32f4 dillon.minfei 2020-05-09 6:58 ` dillon.minfei
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=CAL9mu0+5T3q8V8Ng_1jfPGfBxDWzgd7T1hzcdUXj23-rEtOgfg@mail.gmail.com \ --to=dillon.minfei@gmail.com \ --cc=alexandre.torgue@st.com \ --cc=broonie@kernel.org \ --cc=devicetree@vger.kernel.org \ --cc=dillonhua@gmail.com \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-spi@vger.kernel.org \ --cc=linux-stm32@st-md-mailman.stormreply.com \ --cc=mcoquelin.stm32@gmail.com \ --cc=p.zabel@pengutronix.de \ --cc=robh+dt@kernel.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.