* Re: [PATCH 1/2] extcon: usbc-tusb320: Add support for TUSB320L
2021-07-14 17:43 ` [PATCH 1/2] extcon: usbc-tusb320: Add support for TUSB320L Yassine Oudjana
@ 2021-07-23 5:45 ` Chanwoo Choi
0 siblings, 0 replies; 2+ messages in thread
From: Chanwoo Choi @ 2021-07-23 5:45 UTC (permalink / raw)
To: Yassine Oudjana, Michael Auchter
Cc: MyungJoo Ham, Rob Herring, linux-kernel, devicetree
Hi Yassine,
It seems that this patch has the two role.
Firstly, it has the some refactoring code and print the more information
Secondly, add support for TUSB320L new device.
So that you better need to make two patches separately in order to split out
two roles.
On 7/15/21 2:43 AM, Yassine Oudjana wrote:
> TUSB320L is a newer chip with additional features. Add support for resetting
> and setting its and TUSB320's mode, and reset it during probe to make sure it starts in the
> default mode (maintain mode according to PORT pin selection).
>
> Signed-off-by: Yassine Oudjana <y.oudjana@protonmail.com>
> ---
> drivers/extcon/extcon-usbc-tusb320.c | 172 ++++++++++++++++++++++++---
> 1 file changed, 156 insertions(+), 16 deletions(-)
>
> diff --git a/drivers/extcon/extcon-usbc-tusb320.c b/drivers/extcon/extcon-usbc-tusb320.c
> index 805af73b4152..a6741eff60cc 100644
> --- a/drivers/extcon/extcon-usbc-tusb320.c
> +++ b/drivers/extcon/extcon-usbc-tusb320.c
> @@ -13,21 +13,47 @@
> #include <linux/kernel.h>
> #include <linux/module.h>
> #include <linux/regmap.h>
> -
> +
> #define TUSB320_REG9 0x9
> #define TUSB320_REG9_ATTACHED_STATE_SHIFT 6
> #define TUSB320_REG9_ATTACHED_STATE_MASK 0x3
> #define TUSB320_REG9_CABLE_DIRECTION BIT(5)
> #define TUSB320_REG9_INTERRUPT_STATUS BIT(4)
> -#define TUSB320_ATTACHED_STATE_NONE 0x0
> -#define TUSB320_ATTACHED_STATE_DFP 0x1
> -#define TUSB320_ATTACHED_STATE_UFP 0x2
> -#define TUSB320_ATTACHED_STATE_ACC 0x3
> +
> +#define TUSB320_REGA 0xa
> +#define TUSB320L_REGA_DISABLE_TERM BIT(0)
> +#define TUSB320_REGA_I2C_SOFT_RESET BIT(3)
> +#define TUSB320_REGA_MODE_SELECT_SHIFT 4
> +#define TUSB320_REGA_MODE_SELECT_MASK 0x3
> +
> +#define TUSB320L_REGA0_REVISION 0xa0
> +
> +enum tusb320_attached_state {
> + TUSB320_ATTACHED_STATE_NONE,
> + TUSB320_ATTACHED_STATE_DFP,
> + TUSB320_ATTACHED_STATE_UFP,
> + TUSB320_ATTACHED_STATE_ACC,
> +};
> +
> +enum tusb320_mode {
> + TUSB320_MODE_PORT,
> + TUSB320_MODE_UFP,
> + TUSB320_MODE_DFP,
> + TUSB320_MODE_DRP,
> +};
> +
> +enum tusb320_type {
> + TYPE_TUSB320,
> + TYPE_TUSB320L,
> +};
>
> struct tusb320_priv {
> struct device *dev;
> struct regmap *regmap;
> + enum tusb320_type type;
> struct extcon_dev *edev;
> +
> + enum tusb320_attached_state state;
> };
>
> static const char * const tusb_attached_states[] = {
> @@ -37,6 +63,13 @@ static const char * const tusb_attached_states[] = {
> [TUSB320_ATTACHED_STATE_ACC] = "accessory",
> };
>
> +static const char * const tusb_modes[] = {
> + [TUSB320_MODE_PORT] = "maintain mode set by PORT pin",
> + [TUSB320_MODE_UFP] = "upstream facing port",
> + [TUSB320_MODE_DFP] = "downstream facing port",
> + [TUSB320_MODE_DRP] = "dual role port",
> +};
> +
> static const unsigned int tusb320_extcon_cable[] = {
> EXTCON_USB,
> EXTCON_USB_HOST,
> @@ -62,26 +95,106 @@ static int tusb320_check_signature(struct tusb320_priv *priv)
> return 0;
> }
>
> +static int tusb320_set_mode(struct tusb320_priv *priv, enum tusb320_mode mode)
> +{
> + int ret;
> +
> + if(priv->type == TYPE_TUSB320)
> + goto write_mode;
> +
> + /* Disable CC state machine */
> + ret = regmap_write_bits(priv->regmap, TUSB320_REGA,
> + TUSB320L_REGA_DISABLE_TERM, 1);
> + if(ret) {
> + dev_err(priv->dev,
> + "failed to disable CC state machine: %d\n", ret);
> + return ret;
> + }
> +
> +write_mode:
> + /* Mode cannot be changed on TUSB320 while cable is attached */
> + if(priv->type == TYPE_TUSB320 && priv->state != TUSB320_ATTACHED_STATE_NONE)
> + return -EBUSY;
> +
> + /* Write mode */
> + ret = regmap_write_bits(priv->regmap, TUSB320_REGA,
> + TUSB320_REGA_MODE_SELECT_MASK << TUSB320_REGA_MODE_SELECT_SHIFT,
> + mode << TUSB320_REGA_MODE_SELECT_SHIFT);
> + if(ret) {
> + dev_err(priv->dev, "failed to write mode: %d\n", ret);
> + return ret;
> + }
> +
> + if(priv->type == TYPE_TUSB320)
> + return 0;
> +
> + msleep(5);
> +
> + /* Re-enable CC state machine */
> + ret = regmap_write_bits(priv->regmap, TUSB320_REGA,
> + TUSB320L_REGA_DISABLE_TERM, 0);
> + if(ret) {
> + dev_err(priv->dev,
> + "failed to re-enable CC state machine: %d\n", ret);
> + return ret;
> + }
> +
> + return 0;
> +}
> +
> +static int tusb320_reset(struct tusb320_priv *priv)
> +{
> + int ret;
> +
> + /* Set mode to default (follow PORT pin) */
> + ret = tusb320_set_mode(priv, TUSB320_MODE_PORT);
> + if(ret && ret != -EBUSY) {
> + dev_err(priv->dev,
> + "failed to set mode to PORT: %d\n", ret);
> + return ret;
> + }
> +
> + /* Perform soft reset */
> + ret = regmap_write_bits(priv->regmap, TUSB320_REGA,
> + TUSB320_REGA_I2C_SOFT_RESET, 1);
> + if(ret) {
> + dev_err(priv->dev,
> + "failed to write soft reset bit: %d\n", ret);
> + return ret;
> + }
> +
> + return 0;
> +}
> +
> static irqreturn_t tusb320_irq_handler(int irq, void *dev_id)
> {
> struct tusb320_priv *priv = dev_id;
> - int state, polarity;
> - unsigned reg;
> + int state, polarity, mode;
> + unsigned reg9, rega;
>
> - if (regmap_read(priv->regmap, TUSB320_REG9, ®)) {
> - dev_err(priv->dev, "error during i2c read!\n");
> + if (regmap_read(priv->regmap, TUSB320_REG9, ®9)) {
> + dev_err(priv->dev, "error during register 0x9 i2c read!\n");
> return IRQ_NONE;
> }
>
> - if (!(reg & TUSB320_REG9_INTERRUPT_STATUS))
> + if (regmap_read(priv->regmap, TUSB320_REGA, ®a)) {
> + dev_err(priv->dev, "error during register 0xa i2c read!\n");
> return IRQ_NONE;
> + }
>
> - state = (reg >> TUSB320_REG9_ATTACHED_STATE_SHIFT) &
> + if (!(reg9 & TUSB320_REG9_INTERRUPT_STATUS))
> + return IRQ_NONE;
> +
> + state = (reg9 >> TUSB320_REG9_ATTACHED_STATE_SHIFT) &
> TUSB320_REG9_ATTACHED_STATE_MASK;
> - polarity = !!(reg & TUSB320_REG9_CABLE_DIRECTION);
> + polarity = !!(reg9 & TUSB320_REG9_CABLE_DIRECTION);
> +
> + mode = (rega >> TUSB320_REGA_MODE_SELECT_SHIFT) &
> + TUSB320_REGA_MODE_SELECT_MASK;
>
> - dev_dbg(priv->dev, "attached state: %s, polarity: %d\n",
> - tusb_attached_states[state], polarity);
> + dev_dbg(priv->dev, "mode: %s, attached state: %s, polarity: %d\n",
> + tusb_modes[mode], tusb_attached_states[state], polarity);
>
> extcon_set_state(priv->edev, EXTCON_USB,
> state == TUSB320_ATTACHED_STATE_UFP);
> @@ -96,7 +209,10 @@ static irqreturn_t tusb320_irq_handler(int irq, void *dev_id)
> extcon_sync(priv->edev, EXTCON_USB);
> extcon_sync(priv->edev, EXTCON_USB_HOST);
>
> - regmap_write(priv->regmap, TUSB320_REG9, reg);
> + priv->state = state;
> +
> + regmap_write(priv->regmap, TUSB320_REG9, reg9);
> + regmap_write(priv->regmap, TUSB320_REGA, rega);
>
> return IRQ_HANDLED;
> }
> @@ -110,6 +226,8 @@ static int tusb320_extcon_probe(struct i2c_client *client,
> const struct i2c_device_id *id)
> {
> struct tusb320_priv *priv;
> + const void *match_data;
> + unsigned int revision;
> int ret;
>
> priv = devm_kzalloc(&client->dev, sizeof(*priv), GFP_KERNEL);
> @@ -125,6 +243,22 @@ static int tusb320_extcon_probe(struct i2c_client *client,
> if (ret)
> return ret;
>
> + match_data = device_get_match_data(&client->dev);
> + if (!match_data)
> + return -EINVAL;
> +
> + priv->type = (enum tusb320_type)match_data;
> +
> + if(priv->type == TYPE_TUSB320L) {
> + ret = regmap_read(priv->regmap, TUSB320L_REGA0_REVISION, &revision);
> +
> + if(ret < 0)
> + dev_warn(priv->dev,
> + "failed to read revision register: %d\n", ret);
> + else
> + dev_info(priv->dev, "chip revision %d\n", revision);
> + }
> +
> priv->edev = devm_extcon_dev_allocate(priv->dev, tusb320_extcon_cable);
> if (IS_ERR(priv->edev)) {
> dev_err(priv->dev, "failed to allocate extcon device\n");
> @@ -137,6 +271,11 @@ static int tusb320_extcon_probe(struct i2c_client *client,
> return ret;
> }
>
> + /* Reset chip to its default state */
> + ret = tusb320_reset(priv);
> + if(ret)
> + dev_warn(priv->dev, "failed to reset chip: %d\n", ret);
> +
If you want to reset the h/w device, need to be reset before registering extcon device.
Please move it before
> extcon_set_property_capability(priv->edev, EXTCON_USB,
> EXTCON_PROP_USB_TYPEC_POLARITY);
> extcon_set_property_capability(priv->edev, EXTCON_USB_HOST,
> @@ -154,7 +293,8 @@ static int tusb320_extcon_probe(struct i2c_client *client,
> }
>
> static const struct of_device_id tusb320_extcon_dt_match[] = {
> - { .compatible = "ti,tusb320", },
> + { .compatible = "ti,tusb320", .data = (void *)TYPE_TUSB320, },
> + { .compatible = "ti,tusb320l", .data = (void *)TYPE_TUSB320L, },
> { }
> };
> MODULE_DEVICE_TABLE(of, tusb320_extcon_dt_match);
>
--
Best Regards,
Chanwoo Choi
Samsung Electronics
^ permalink raw reply [flat|nested] 2+ messages in thread