From: Alex Elder <elder@linaro.org> To: Randy Dunlap <rdunlap@infradead.org>, davem@davemloft.net, arnd@arndb.de, bjorn.andersson@linaro.org, ilias.apalodimas@linaro.org Cc: netdev@vger.kernel.org, devicetree@vger.kernel.org, linux-arm-msm@vger.kernel.org, linux-soc@vger.kernel.org, linux-arm-kernel@lists.infradead.org, linux-kernel@vger.kernel.org, syadagir@codeaurora.org, mjavid@codeaurora.org, robh+dt@kernel.org, mark.rutland@arm.com Subject: Re: [RFC PATCH 12/12] soc: qcom: ipa: build and "ipa_i.h" Date: Thu, 8 Nov 2018 10:22:12 -0600 [thread overview] Message-ID: <dd788545-a369-684e-3d57-b0b8a98b407a@linaro.org> (raw) In-Reply-To: <cebe0d3c-4a24-60a4-88c8-5195a5d0da4b@infradead.org> On 11/6/18 6:40 PM, Randy Dunlap wrote: > Hi- Thanks Randy, I've fixed this in my own tree. -Alex > > On 11/6/18 4:32 PM, Alex Elder wrote: >> diff --git a/drivers/net/ipa/Kconfig b/drivers/net/ipa/Kconfig >> new file mode 100644 >> index 000000000000..f8ea9363f532 >> --- /dev/null >> +++ b/drivers/net/ipa/Kconfig >> @@ -0,0 +1,30 @@ >> +config IPA >> + tristate "Qualcomm IPA support" >> + depends on NET >> + select QCOM_QMI_HELPERS >> + select QCOM_MDT_LOADER >> + default n >> + help >> + Choose Y here to include support for the Qualcomm IP >> + Accelerator (IPA), a hardware block present in some >> + Qualcomm SoCs. The IPA is a programmable protocol >> + processor that is capable of generic hardware handling >> + of IP packets, including routing, filtering, and NAT. >> + Currently the IPA driver supports only basic transport >> + of network traffic between the AP and modem, on the >> + Qualcomm SDM845 SoC. >> + >> + If unsure, say N. >> + >> +config IPA_ASSERT >> + bool "Enable IPA assertions" >> + depends on IPA >> + default y >> + help >> + Incorporate IPA assertion verification in the build. This >> + cause various design assumptions to be checked at runtime, > > causes > >> + generating a report (and a crash) if any assumed condition >> + does not hold. You may wish to disable this to avoid the >> + overhead of checking. >> + >> + If unsure doubt, say "Y" here. > >
WARNING: multiple messages have this Message-ID (diff)
From: elder@linaro.org (Alex Elder) To: linux-arm-kernel@lists.infradead.org Subject: [RFC PATCH 12/12] soc: qcom: ipa: build and "ipa_i.h" Date: Thu, 8 Nov 2018 10:22:12 -0600 [thread overview] Message-ID: <dd788545-a369-684e-3d57-b0b8a98b407a@linaro.org> (raw) In-Reply-To: <cebe0d3c-4a24-60a4-88c8-5195a5d0da4b@infradead.org> On 11/6/18 6:40 PM, Randy Dunlap wrote: > Hi- Thanks Randy, I've fixed this in my own tree. -Alex > > On 11/6/18 4:32 PM, Alex Elder wrote: >> diff --git a/drivers/net/ipa/Kconfig b/drivers/net/ipa/Kconfig >> new file mode 100644 >> index 000000000000..f8ea9363f532 >> --- /dev/null >> +++ b/drivers/net/ipa/Kconfig >> @@ -0,0 +1,30 @@ >> +config IPA >> + tristate "Qualcomm IPA support" >> + depends on NET >> + select QCOM_QMI_HELPERS >> + select QCOM_MDT_LOADER >> + default n >> + help >> + Choose Y here to include support for the Qualcomm IP >> + Accelerator (IPA), a hardware block present in some >> + Qualcomm SoCs. The IPA is a programmable protocol >> + processor that is capable of generic hardware handling >> + of IP packets, including routing, filtering, and NAT. >> + Currently the IPA driver supports only basic transport >> + of network traffic between the AP and modem, on the >> + Qualcomm SDM845 SoC. >> + >> + If unsure, say N. >> + >> +config IPA_ASSERT >> + bool "Enable IPA assertions" >> + depends on IPA >> + default y >> + help >> + Incorporate IPA assertion verification in the build. This >> + cause various design assumptions to be checked at runtime, > > causes > >> + generating a report (and a crash) if any assumed condition >> + does not hold. You may wish to disable this to avoid the >> + overhead of checking. >> + >> + If unsure doubt, say "Y" here. > >
next prev parent reply other threads:[~2018-11-08 16:22 UTC|newest] Thread overview: 76+ messages / expand[flat|nested] mbox.gz Atom feed top 2018-11-07 0:32 [RFC PATCH 00/12] net: introduce Qualcomm IPA driver Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 01/12] dt-bindings: soc: qcom: add IPA bindings Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 11:50 ` Arnd Bergmann 2018-11-07 11:50 ` Arnd Bergmann 2018-11-09 22:38 ` Alex Elder 2018-11-09 22:38 ` Alex Elder 2018-11-07 14:59 ` Rob Herring 2018-11-07 14:59 ` Rob Herring 2018-11-09 22:38 ` Alex Elder 2018-11-09 22:38 ` Alex Elder 2018-11-11 1:40 ` Rob Herring 2018-11-11 1:40 ` Rob Herring 2018-11-11 1:40 ` Rob Herring 2018-11-13 16:28 ` Alex Elder 2018-11-13 16:28 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 02/12] soc: qcom: ipa: DMA helpers Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 12:17 ` Arnd Bergmann 2018-11-07 12:17 ` Arnd Bergmann 2018-11-13 16:33 ` Alex Elder 2018-11-13 16:33 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 03/12] soc: qcom: ipa: generic software interface Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 04/12] soc: qcom: ipa: immediate commands Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 14:36 ` Arnd Bergmann 2018-11-07 14:36 ` Arnd Bergmann 2018-11-13 16:58 ` Alex Elder 2018-11-13 16:58 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 05/12] soc: qcom: ipa: IPA interrupts and the microcontroller Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 06/12] soc: qcom: ipa: QMI modem communication Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 07/12] soc: qcom: ipa: IPA register abstraction Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 15:00 ` Arnd Bergmann 2018-11-07 15:00 ` Arnd Bergmann 2018-11-15 2:48 ` Alex Elder 2018-11-15 2:48 ` Alex Elder 2018-11-15 14:42 ` Arnd Bergmann 2018-11-15 14:42 ` Arnd Bergmann 2018-11-07 0:32 ` [RFC PATCH 08/12] soc: qcom: ipa: utility functions Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 09/12] soc: qcom: ipa: main IPA source file Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 14:08 ` Arnd Bergmann 2018-11-07 14:08 ` Arnd Bergmann 2018-11-15 3:11 ` Alex Elder 2018-11-15 3:11 ` Alex Elder 2018-11-07 0:32 ` [RFC PATCH 10/12] soc: qcom: ipa: data path Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 14:55 ` Arnd Bergmann 2018-11-07 14:55 ` Arnd Bergmann 2018-11-15 3:31 ` Alex Elder 2018-11-15 3:31 ` Alex Elder 2018-11-15 14:48 ` Arnd Bergmann 2018-11-15 14:48 ` Arnd Bergmann 2018-11-07 0:32 ` [RFC PATCH 11/12] soc: qcom: ipa: IPA rmnet interface Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 13:30 ` Arnd Bergmann 2018-11-07 13:30 ` Arnd Bergmann 2018-11-07 15:26 ` Dan Williams 2018-11-07 15:26 ` Dan Williams 2018-11-07 0:32 ` [RFC PATCH 12/12] soc: qcom: ipa: build and "ipa_i.h" Alex Elder 2018-11-07 0:32 ` Alex Elder 2018-11-07 0:40 ` Randy Dunlap 2018-11-07 0:40 ` Randy Dunlap 2018-11-07 0:40 ` Randy Dunlap 2018-11-08 16:22 ` Alex Elder [this message] 2018-11-08 16:22 ` Alex Elder 2018-11-07 12:34 ` Arnd Bergmann 2018-11-07 12:34 ` Arnd Bergmann 2018-11-07 15:46 ` [RFC PATCH 00/12] net: introduce Qualcomm IPA driver Arnd Bergmann 2018-11-07 15:46 ` Arnd Bergmann
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=dd788545-a369-684e-3d57-b0b8a98b407a@linaro.org \ --to=elder@linaro.org \ --cc=arnd@arndb.de \ --cc=bjorn.andersson@linaro.org \ --cc=davem@davemloft.net \ --cc=devicetree@vger.kernel.org \ --cc=ilias.apalodimas@linaro.org \ --cc=linux-arm-kernel@lists.infradead.org \ --cc=linux-arm-msm@vger.kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=linux-soc@vger.kernel.org \ --cc=mark.rutland@arm.com \ --cc=mjavid@codeaurora.org \ --cc=netdev@vger.kernel.org \ --cc=rdunlap@infradead.org \ --cc=robh+dt@kernel.org \ --cc=syadagir@codeaurora.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.