From: Hans de Goede <hdegoede@redhat.com> To: Coiby Xu <coiby.xu@gmail.com> Cc: Linus Walleij <linus.walleij@linaro.org>, "open list:GPIO SUBSYSTEM" <linux-gpio@vger.kernel.org>, Nehal Shah <Nehal-bakulchandra.Shah@amd.com>, Shyam Sundar S K <Shyam-sundar.S-k@amd.com>, linux-kernel-mentees@lists.linuxfoundation.org Subject: Re: Any other ways to debug GPIO interrupt controller (pinctrl-amd) for broken touchpads of a new laptop model? Date: Fri, 2 Oct 2020 21:44:54 +0200 [thread overview] Message-ID: <eed704f5-4210-788c-37b7-06d65b58d3de@redhat.com> (raw) In-Reply-To: <20201002145133.a43ypm2z7ofgtt7u@Rk> Hi, On 10/2/20 4:51 PM, Coiby Xu wrote: > On Fri, Oct 02, 2020 at 03:36:29PM +0200, Hans de Goede wrote: <snip> >>>> So are you seeing these 7 interrupts / second for the touchpad irq or for >>>> the GPIO controllers parent irq ? >>>> >>>> Also to these 7 interrupts/sec stop happening when you do not touch the >>>> touchpad ? >>>> >>> I see these 7 interrupts / second for the GPIO controller's parent irq. >>> And they stop happening when I don't touch the touchpad. >> >> Only from the parent irq, or also on the touchpad irq itself ? >> >> If this only happens on the parent irq, then I would start looking at the >> amd-pinctrl code which determines which of its "child" irqs to fire. > > This only happens on the parent irq. The input's pin#130 of the GIPO > chip is low most of the time and pin#130. Right, but it is a low-level triggered IRQ, so when it is low it should be executing the i2c-hid interrupt-handler. If it is not executing that then it is time to look at amd-pinctrl's irq-handler and figure out why that is not triggering the child irq handler for the touchpad. Regards, Hans
WARNING: multiple messages have this Message-ID (diff)
From: Hans de Goede <hdegoede@redhat.com> To: Coiby Xu <coiby.xu@gmail.com> Cc: "open list:GPIO SUBSYSTEM" <linux-gpio@vger.kernel.org>, Linus Walleij <linus.walleij@linaro.org>, Shyam Sundar S K <Shyam-sundar.S-k@amd.com>, Nehal Shah <Nehal-bakulchandra.Shah@amd.com>, linux-kernel-mentees@lists.linuxfoundation.org Subject: Re: [Linux-kernel-mentees] Any other ways to debug GPIO interrupt controller (pinctrl-amd) for broken touchpads of a new laptop model? Date: Fri, 2 Oct 2020 21:44:54 +0200 [thread overview] Message-ID: <eed704f5-4210-788c-37b7-06d65b58d3de@redhat.com> (raw) In-Reply-To: <20201002145133.a43ypm2z7ofgtt7u@Rk> Hi, On 10/2/20 4:51 PM, Coiby Xu wrote: > On Fri, Oct 02, 2020 at 03:36:29PM +0200, Hans de Goede wrote: <snip> >>>> So are you seeing these 7 interrupts / second for the touchpad irq or for >>>> the GPIO controllers parent irq ? >>>> >>>> Also to these 7 interrupts/sec stop happening when you do not touch the >>>> touchpad ? >>>> >>> I see these 7 interrupts / second for the GPIO controller's parent irq. >>> And they stop happening when I don't touch the touchpad. >> >> Only from the parent irq, or also on the touchpad irq itself ? >> >> If this only happens on the parent irq, then I would start looking at the >> amd-pinctrl code which determines which of its "child" irqs to fire. > > This only happens on the parent irq. The input's pin#130 of the GIPO > chip is low most of the time and pin#130. Right, but it is a low-level triggered IRQ, so when it is low it should be executing the i2c-hid interrupt-handler. If it is not executing that then it is time to look at amd-pinctrl's irq-handler and figure out why that is not triggering the child irq handler for the touchpad. Regards, Hans _______________________________________________ Linux-kernel-mentees mailing list Linux-kernel-mentees@lists.linuxfoundation.org https://lists.linuxfoundation.org/mailman/listinfo/linux-kernel-mentees
next prev parent reply other threads:[~2020-10-02 19:45 UTC|newest] Thread overview: 84+ messages / expand[flat|nested] mbox.gz Atom feed top 2020-10-01 13:22 Any other ways to debug GPIO interrupt controller (pinctrl-amd) for broken touchpads of a new laptop model? Coiby Xu 2020-10-01 13:22 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-01 20:57 ` Linus Walleij 2020-10-01 20:57 ` [Linux-kernel-mentees] " Linus Walleij 2020-10-02 9:40 ` Hans de Goede 2020-10-02 9:40 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-02 12:42 ` Coiby Xu 2020-10-02 12:42 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-02 13:36 ` Hans de Goede 2020-10-02 13:36 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-02 14:51 ` Coiby Xu 2020-10-02 14:51 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-02 19:44 ` Hans de Goede [this message] 2020-10-02 19:44 ` Hans de Goede 2020-10-02 22:45 ` Coiby Xu 2020-10-02 22:45 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-03 13:22 ` Hans de Goede 2020-10-03 13:22 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-03 23:03 ` Coiby Xu 2020-10-03 23:03 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-04 5:16 ` Coiby Xu 2020-10-04 5:16 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-06 4:49 ` Coiby Xu 2020-10-06 4:49 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-06 6:28 ` Hans de Goede 2020-10-06 6:28 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-06 8:31 ` Coiby Xu 2020-10-06 8:31 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-06 8:55 ` Hans de Goede 2020-10-06 8:55 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-06 9:28 ` Hans de Goede 2020-10-06 9:28 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-06 9:29 ` Hans de Goede 2020-10-06 9:29 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-08 16:32 ` Coiby Xu 2020-10-08 16:32 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-14 4:24 ` Coiby Xu 2020-10-14 4:24 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-14 11:34 ` Coiby Xu 2020-10-14 11:34 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-14 11:46 ` Hans de Goede 2020-10-14 11:46 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-15 3:27 ` Coiby Xu 2020-10-15 3:27 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-15 4:06 ` Coiby Xu 2020-10-15 4:06 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-26 22:54 ` Coiby Xu 2020-10-26 22:54 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-27 9:52 ` Andy Shevchenko 2020-10-27 9:52 ` [Linux-kernel-mentees] " Andy Shevchenko 2020-10-30 4:58 ` Coiby Xu 2020-10-30 4:58 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-27 10:09 ` Hans de Goede 2020-10-27 10:09 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-27 15:13 ` Andy Shevchenko 2020-10-27 15:13 ` [Linux-kernel-mentees] " Andy Shevchenko 2020-10-27 16:00 ` Hans de Goede 2020-10-27 16:00 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-27 16:09 ` Andy Shevchenko 2020-10-27 16:09 ` [Linux-kernel-mentees] " Andy Shevchenko 2020-10-29 8:04 ` Mika Westerberg 2020-10-29 8:04 ` [Linux-kernel-mentees] " Mika Westerberg 2020-10-30 4:54 ` Coiby Xu 2020-10-30 4:54 ` [Linux-kernel-mentees] " Coiby Xu 2020-11-02 19:06 ` Andy Shevchenko 2020-11-02 19:06 ` [Linux-kernel-mentees] " Andy Shevchenko 2020-11-02 22:56 ` Coiby Xu 2020-11-02 22:56 ` [Linux-kernel-mentees] " Coiby Xu 2020-11-03 0:05 ` Coiby Xu 2020-11-03 0:05 ` [Linux-kernel-mentees] " Coiby Xu 2020-11-03 10:12 ` Hans de Goede 2020-11-03 10:12 ` [Linux-kernel-mentees] " Hans de Goede 2020-11-03 10:49 ` Andy Shevchenko 2020-11-03 10:49 ` [Linux-kernel-mentees] " Andy Shevchenko 2020-11-03 11:00 ` Hans de Goede 2020-11-03 11:00 ` [Linux-kernel-mentees] " Hans de Goede 2020-10-08 16:26 ` Coiby Xu 2020-10-08 16:26 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-06 9:16 ` Linus Walleij 2020-10-06 9:16 ` [Linux-kernel-mentees] " Linus Walleij 2020-10-08 16:40 ` Coiby Xu 2020-10-08 16:40 ` [Linux-kernel-mentees] " Coiby Xu 2020-10-02 10:59 ` Coiby Xu 2020-10-02 10:59 ` [Linux-kernel-mentees] " Coiby Xu
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=eed704f5-4210-788c-37b7-06d65b58d3de@redhat.com \ --to=hdegoede@redhat.com \ --cc=Nehal-bakulchandra.Shah@amd.com \ --cc=Shyam-sundar.S-k@amd.com \ --cc=coiby.xu@gmail.com \ --cc=linus.walleij@linaro.org \ --cc=linux-gpio@vger.kernel.org \ --cc=linux-kernel-mentees@lists.linuxfoundation.org \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.