Re: [PATCH v5] net: ethernet: add driver for Aurora VLSI NB8800 Ethernet controller

["Måns Rullgård" <mans@mansr.com>]

Måns Rullgård <mans@mansr.com> writes:

> Mason <slash.tmp@free.fr> writes:
>
>> [ CCing a few knowledgeable people ]
>>
>> Despite the subject, this is about an Atheros 8035 PHY :-)
>>
>> On 12/11/2015 15:04, Måns Rullgård wrote:
>>
>>> Mason wrote:
>>> 
>>>> BTW, you're not using the PHY IRQ, right? I think I remember you saying
>>>> it didn't work reliably?
>>> 
>>> It doesn't seem to be wired up on any of my boards, or there's some
>>> magic required to activate it that I'm unaware of.
>>
>> Weird. The board schematics for the 1172 show Tango ETH0_MDINT# pin
>> properly connected to AR8035 INT pin (pin 20).
>
> I have a different board.
>
>> <Thinking out loud>
>>
>> http://www.redeszone.net/app/uploads/2014/04/AR8035.pdf
>>
>> INT pin 20
>> I/O, D, PD
>> Interrupt Signal to System; default OD-gate, needs an external
>> 10Kohm pull-up, active low; can be configured to I/O by register,
>> active high.
>>
>> 4.1.17 Interrupt Enable
>> Offset: 0x12
>> Mode: Read/Write
>> Hardware Reset: 0
>>
>> Strange... it looks like AT803X_INER and AT803X_INTR_ENABLE refer to
>> the same "Interrupt Enable" register?
>
> Seems like someone missed that it was already defined.
>
>> In fact, AT803X_INER_INIT == 0xec00 makes sense for register 0x12:
>> link success/fail, speed/duplex changed, autoneg error
>>
>> Looks like at803x_config_intr() is used for 8031, but not for 8035...
>>
>> Relevant commit:
>> 77a9939426f7a "phy/at8031: enable at8031 to work on interrupt mode"
>>
>> If I add .config_intr and .ack_interrupt to the 8035 struct, then I get
>> (also added some traces)
>
> I tried that just now, and I get nothing.  What interrupt did you
> specify in your device tree?

It works with the interrupt set to trigger on rising edge.

-- 
Måns Rullgård
mans@mansr.com