Alsa-Devel Archive on lore.kernel.org
 help / color / Atom feed
* [alsa-devel] how to use DPCM to alter audio path between headphones and speaker
@ 2020-01-14 17:52 Tim Harvey
  0 siblings, 0 replies; only message in thread
From: Tim Harvey @ 2020-01-14 17:52 UTC (permalink / raw)
  To: Linux-ALSA

Greetings,

I'm working with a board that has a TI TLV320AIC3105 codec connected
to an IMX6 SSI with a headphone jack and a TS3A227E headphone detect
chip (HPROUT/HPLOUT), mono speaker amp output (RIGHT_LOP/RIGHT_LOM),
and mic in (MIC1L). It seems that Dynamic PCM allows for the automatic
routing of audio to change between headphone out and speaker out
depending on jack insertion/removal event but I'm not clear how to
configure that. Can this be done via simple-audio-card bindings or
does it require a modified machine driver?

Any pointers or references are greatly appreciated!

Best Regards,

Tim
_______________________________________________
Alsa-devel mailing list
Alsa-devel@alsa-project.org
https://mailman.alsa-project.org/mailman/listinfo/alsa-devel

^ permalink raw reply	[flat|nested] only message in thread

only message in thread, back to index

Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2020-01-14 17:52 [alsa-devel] how to use DPCM to alter audio path between headphones and speaker Tim Harvey

Alsa-Devel Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/alsa-devel/0 alsa-devel/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 alsa-devel alsa-devel/ https://lore.kernel.org/alsa-devel \
		alsa-devel@alsa-project.org
	public-inbox-index alsa-devel

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.alsa-project.alsa-devel


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git