Re: [PATCH v3 00/13] phy: usb: Updates to Broadcom STB USB PHY driver

From: Florian Fainelli <f.fainelli@gmail.com>
To: Al Cooper <alcooperx@gmail.com>, linux-kernel@vger.kernel.org
Cc: bcm-kernel-feedback-list@broadcom.com,
	devicetree@vger.kernel.org,
	Kishon Vijay Abraham I <kishon@ti.com>,
	linux-arm-kernel@lists.infradead.org,
	Mark Rutland <mark.rutland@arm.com>,
	Rob Herring <robh+dt@kernel.org>,
	Srinath Mannam <srinath.mannam@broadcom.com>
Subject: Re: [PATCH v3 00/13] phy: usb: Updates to Broadcom STB USB PHY driver
Date: Fri, 13 Dec 2019 11:25:49 -0800	[thread overview]
Message-ID: <ec0e50c6-b226-70b4-0f1b-51d5cb0a71c5@gmail.com> (raw)
In-Reply-To: <20191210132132.41509-1-alcooperx@gmail.com>

On 12/10/19 5:21 AM, Al Cooper wrote:
> This patchset contains various updates to the Broadcom STB USB Driver.
> The updates include:
> - Add support for 7216 and 7211 Broadcom SoCs which use the new
>   Synopsis USB Controller.
> - Add support for USB Wake
> - Add various bug fixes.
> 
> v3 - Rebase to v5.5-rc1
> 
> v2 - Changes based on review feedback
> - Add vendor prefix to DT property "syscon-piarbctl"
> - Use standard "wakeup" instead of "wake" for DT "interrupt-names"

This entire series:

Tested-by: Florian Fainelli <f.fainelli@gmail.com>

> 
> Al Cooper (13):
>   phy: usb: EHCI DMA may lose a burst of DMA data for 7255xA0 family
>   phy: usb: Get all drivers that use USB clks using correct
>     enable/disable
>   phy: usb: Put USB phys into IDDQ on suspend to save power in S2 mode
>   phy: usb: Add "wake on" functionality
>   phy: usb: Restructure in preparation for adding 7216 USB support
>   dt-bindings: Add Broadcom STB USB PHY binding document
>   phy: usb: Add support for new Synopsis USB controller on the 7216
>   phy: usb: Add support for new Synopsis USB controller on the 7211b0
>   phy: usb: fix driver to defer on clk_get defer
>   phy: usb: PHY's MDIO registers not accessible without device installed
>   phy: usb: bdc: Fix occasional failure with BDC on 7211
>   phy: usb: USB driver is crashing during S3 resume on 7216
>   phy: usb: Add support for wake and USB low power mode for 7211 S2/S5
> 
>  .../bindings/phy/brcm,brcmstb-usb-phy.txt     |  69 ++-
>  drivers/phy/broadcom/Makefile                 |   2 +-
>  .../phy/broadcom/phy-brcm-usb-init-synopsis.c | 414 ++++++++++++++++++
>  drivers/phy/broadcom/phy-brcm-usb-init.c      | 226 +++++-----
>  drivers/phy/broadcom/phy-brcm-usb-init.h      | 148 ++++++-
>  drivers/phy/broadcom/phy-brcm-usb.c           | 269 ++++++++++--
>  6 files changed, 943 insertions(+), 185 deletions(-)
>  create mode 100644 drivers/phy/broadcom/phy-brcm-usb-init-synopsis.c
> 

-- 
Florian