[PATCH AUTOSEL 4.9 01/35] pinctrl: meson: fix pull enable register calculation

[PATCH AUTOSEL 4.9 01/35] pinctrl: meson: fix pull enable register calculation

[Sasha Levin]

From: Jerome Brunet <jbrunet@baylibre.com>

[ Upstream commit 614b1868a125a0ba24be08f3a7fa832ddcde6bca ]

We just changed the code so we apply bias disable on the correct
register but forgot to align the register calculation. The result
is that we apply the change on the correct register, but possibly
at the incorrect offset/bit

This went undetected because offsets tends to be the same between
REG_PULL and REG_PULLEN for a given pin the EE controller. This
is not true for the AO controller.

Fixes: e39f9dd8206a ("pinctrl: meson: fix pinconf bias disable")
Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
Acked-by: Neil Armstrong <narmstrong@baylibre.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/pinctrl/meson/pinctrl-meson.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/meson/pinctrl-meson.c b/drivers/pinctrl/meson/pinctrl-meson.c
index df61a71420b1..8e73641bd823 100644
--- a/drivers/pinctrl/meson/pinctrl-meson.c
+++ b/drivers/pinctrl/meson/pinctrl-meson.c
@@ -274,7 +274,8 @@ static int meson_pinconf_set(struct pinctrl_dev *pcdev, unsigned int pin,
 		case PIN_CONFIG_BIAS_DISABLE:
 			dev_dbg(pc->dev, "pin %u: disable bias\n", pin);
 
-			meson_calc_reg_and_bit(bank, pin, REG_PULL, &reg, &bit);
+			meson_calc_reg_and_bit(bank, pin, REG_PULLEN, &reg,
+					       &bit);
 			ret = regmap_update_bits(pc->reg_pullen, reg,
 						 BIT(bit), 0);
 			if (ret)
-- 
2.19.1


_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic