[PATCH 7/9] arm64: allwinner: a64: enable ANX6345 bridge on Pinebook

[icenowy@aosc.io (Icenowy Zheng)]

Pinebook has an ANX6345 bridge connected to the RGB666 LCD output, and
the I2C controlling signals are connected to R_I2C bus.

Enable it in the device tree, and add a usable EDID from the panel's
datasheet (at least 14" Pinebook used a panel without EDID).

Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
---
 .../dts/allwinner/sun50i-a64-pinebook.dts     | 43 +++++++++++++++++++
 1 file changed, 43 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
index 77fac84797e9..d7c14d0d61f9 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
@@ -66,6 +66,10 @@
 	};
 };
 
+&de {
+	status = "okay";
+};
+
 &ehci0 {
 	phys = <&usbphy 0>;
 	phy-names = "usb";
@@ -76,6 +80,10 @@
 	status = "okay";
 };
 
+&mixer0 {
+	status = "okay";
+};
+
 &mmc0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc0_pins>;
@@ -127,6 +135,27 @@
 	status = "okay";
 };
 
+&r_i2c {
+	pinctrl-names = "default";
+	pinctrl-0 = <&r_i2c_pins_a>;
+	status = "okay";
+
+	anx6345: anx6345 at 38 {
+		compatible = "analogix,anx6345";
+		reg = <0x38>;
+		reset-gpios = <&pio 3 24 GPIO_ACTIVE_HIGH>; /* PD24 */
+		panel-supply = <&reg_dc1sw>;
+		dvdd25-supply = <&reg_dldo2>;
+		dvdd12-supply = <&reg_fldo1>;
+
+		port {
+			anx6345_in: endpoint {
+				remote-endpoint = <&tcon0_out_anx6345>;
+			};
+		};
+	};
+};
+
 &r_rsb {
 	status = "okay";
 
@@ -267,6 +296,20 @@
 	vcc-hdmi-supply = <&reg_dldo1>;
 };
 
+&tcon0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&lcd_rgb666_pins>;
+
+	status = "okay";
+};
+
+&tcon0_out {
+	tcon0_out_anx6345: endpoint at 0 {
+		reg = <0>;
+		remote-endpoint = <&anx6345_in>;
+	};
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_pb_pins>;
-- 
2.18.1