linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: miquel.raynal@bootlin.com (Miquel Raynal)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 00/12] Bring suspend to RAM support to PCIe Aardvark driver
Date: Fri, 23 Nov 2018 15:18:19 +0100	[thread overview]
Message-ID: <20181123141831.8214-1-miquel.raynal@bootlin.com> (raw)

Hello,

As part of an effort to bring suspend to RAM support to Armada 3700
SoCs (main target: ESPRESSObin), this series handles the work around
the PCIe IP.

First, more configuration is done in the 'setup' helper as inspired
from the U-Boot driver. This is needed to entirely initialize the IP
during future resume operation (patch 1).

Then, reset GPIO, PHY and clock support are introduced (patch 2-4). As
current device trees do not provide the corresponding properties, not
finding one of these properties is not an error and just produces a
warning. However, if the property is present, an error during PHY
initialization will fail the probe of the driver.

Note: To be sure the clock will be resumed before this driver, a first
series adding links between clocks and consumers has been submitted,
see [1].

Patch 5 adds suspend/resume hooks, re-using all the above.

Finally, bindings and device trees are updated to reflect the hardware
(patch 6-12). While the clock depends on the SoC, the reset GPIO and
the PHY depends on the board so the clock is added in the
armada-37xx.dtsi file while the two other properties are added in
armada-3720-espressobin.dts.

[1] http://lists.infradead.org/pipermail/linux-arm-kernel/2018-November/614527.html

Thanks,
Miqu?l


Miquel Raynal (12):
  PCI: aardvark: configure more registers in the configuration helper
  PCI: aardvark: add reset GPIO support
  PCI: aardvark: add PHY support
  PCI: aardvark: add clock support
  PCI: aardvark: add suspend to RAM support
  dt-bindings: PCI: aardvark: describe the reset-gpios property
  dt-bindings: PCI: aardvark: describe the clocks property
  dt-bindings: PCI: aardvark: describe the PHY property
  ARM64: dts: marvell: armada-37xx: declare PCIe reset pin
  ARM64: dts: marvell: armada-3720-espressobin: declare PCIe reset GPIO
  ARM64: dts: marvell: armada-37xx: declare PCIe clock
  ARM64: dts: marvell: armada-3720-espressobin: declare PCIe PHY

 .../devicetree/bindings/pci/aardvark-pci.txt  |   9 +
 .../dts/marvell/armada-3720-espressobin.dts   |   4 +
 arch/arm64/boot/dts/marvell/armada-37xx.dtsi  |   5 +
 drivers/pci/controller/pci-aardvark.c         | 214 ++++++++++++++++++
 4 files changed, 232 insertions(+)

-- 
2.19.1

             reply	other threads:[~2018-11-23 14:18 UTC|newest]

Thread overview: 36+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-11-23 14:18 Miquel Raynal [this message]
2018-11-23 14:18 ` [PATCH 01/12] PCI: aardvark: configure more registers in the configuration helper Miquel Raynal
2018-11-23 14:18 ` [PATCH 02/12] PCI: aardvark: add reset GPIO support Miquel Raynal
2018-11-23 14:18 ` [PATCH 03/12] PCI: aardvark: add PHY support Miquel Raynal
2018-11-23 14:18 ` [PATCH 04/12] PCI: aardvark: add clock support Miquel Raynal
2018-11-23 14:18 ` [PATCH 05/12] PCI: aardvark: add suspend to RAM support Miquel Raynal
2018-12-03 10:27   ` Lorenzo Pieralisi
2018-12-03 15:38     ` Miquel Raynal
2018-12-03 17:18       ` Lorenzo Pieralisi
2018-12-03 19:19         ` Stephen Boyd
2018-12-03 22:00       ` Rafael J. Wysocki
2018-12-03 22:18         ` Miquel Raynal
2018-12-04  9:45         ` Lorenzo Pieralisi
2018-12-04 21:42           ` Rafael J. Wysocki
2018-12-05 11:00             ` Lorenzo Pieralisi
2018-12-11 14:16             ` Lorenzo Pieralisi
2018-12-13  9:00               ` Stephen Boyd
2018-12-13 10:53                 ` Lorenzo Pieralisi
2018-12-13 14:30                   ` Miquel Raynal
2018-12-13 14:52                     ` Lorenzo Pieralisi
2018-12-13 21:50                     ` Rafael J. Wysocki
2018-12-17 14:54                       ` Miquel Raynal
2018-12-18 10:54                         ` Rafael J. Wysocki
2018-12-18 14:14                           ` Miquel Raynal
2018-11-23 14:18 ` [PATCH 06/12] dt-bindings: PCI: aardvark: describe the reset-gpios property Miquel Raynal
2018-12-11 21:44   ` Rob Herring
2018-11-23 14:18 ` [PATCH 07/12] dt-bindings: PCI: aardvark: describe the clocks property Miquel Raynal
2018-12-11 21:44   ` Rob Herring
2018-11-23 14:18 ` [PATCH 08/12] dt-bindings: PCI: aardvark: describe the PHY property Miquel Raynal
2018-12-11 21:44   ` Rob Herring
2018-11-23 14:18 ` [PATCH 09/12] ARM64: dts: marvell: armada-37xx: declare PCIe reset pin Miquel Raynal
2018-11-23 14:18 ` [PATCH 10/12] ARM64: dts: marvell: armada-3720-espressobin: declare PCIe reset GPIO Miquel Raynal
2018-11-23 14:18 ` [PATCH 11/12] ARM64: dts: marvell: armada-37xx: declare PCIe clock Miquel Raynal
2018-11-23 14:18 ` [PATCH 12/12] ARM64: dts: marvell: armada-3720-espressobin: declare PCIe PHY Miquel Raynal
2018-11-26 14:50 ` [PATCH 00/12] Bring suspend to RAM support to PCIe Aardvark driver Bjorn Helgaas
2018-11-30 13:12   ` Miquel Raynal

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20181123141831.8214-1-miquel.raynal@bootlin.com \
    --to=miquel.raynal@bootlin.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).