linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: miquel.raynal@bootlin.com (Miquel Raynal)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 05/12] PCI: aardvark: add suspend to RAM support
Date: Fri, 23 Nov 2018 15:18:24 +0100	[thread overview]
Message-ID: <20181123141831.8214-6-miquel.raynal@bootlin.com> (raw)
In-Reply-To: <20181123141831.8214-1-miquel.raynal@bootlin.com>

Add suspend and resume callbacks. The priority of these are
"_noirq()", to workaround early access to the registers done by the
PCI core through the ->read()/->write() callbacks at resume time.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/pci/controller/pci-aardvark.c | 52 +++++++++++++++++++++++++++
 1 file changed, 52 insertions(+)

diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
index 108b3f15c410..7ecf1ac4036b 100644
--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -1108,6 +1108,55 @@ static int advk_pcie_setup_clk(struct advk_pcie *pcie)
 	return ret;
 }
 
+static int __maybe_unused advk_pcie_suspend(struct device *dev)
+{
+	struct advk_pcie *pcie = dev_get_drvdata(dev);
+
+	advk_pcie_disable_phy(pcie);
+
+	clk_disable_unprepare(pcie->clk);
+
+	return 0;
+}
+
+static int __maybe_unused advk_pcie_resume(struct device *dev)
+{
+	struct advk_pcie *pcie = dev_get_drvdata(dev);
+	int ret;
+
+	ret = clk_prepare_enable(pcie->clk);
+	if (ret)
+		return ret;
+
+	/*
+	 * Empirical delay needed after enabling the clock and before
+	 * accessing any register.
+	 */
+	msleep(10);
+
+	ret = advk_pcie_enable_phy(pcie);
+	if (ret)
+		return ret;
+
+	advk_pcie_hard_reset(pcie);
+
+	advk_pcie_setup_hw(pcie);
+
+	advk_sw_pci_bridge_init(pcie);
+
+	return 0;
+}
+
+/*
+ * The PCI core will try to reconfigure the bus quite early in the resume path.
+ * We must use the _noirq() alternatives to ensure the controller is ready when
+ * the core uses the ->read()/->write() callbacks.
+ */
+static const struct dev_pm_ops advk_pcie_dev_pm_ops = {
+	SET_NOIRQ_SYSTEM_SLEEP_PM_OPS(advk_pcie_suspend,
+				      advk_pcie_resume)
+};
+
 static int advk_pcie_probe(struct platform_device *pdev)
 {
 	struct device *dev = &pdev->dev;
@@ -1188,6 +1237,8 @@ static int advk_pcie_probe(struct platform_device *pdev)
 		return ret;
 	}
 
+	dev_set_drvdata(dev, pcie);
+
 	return 0;
 }
 
@@ -1200,6 +1251,7 @@ static struct platform_driver advk_pcie_driver = {
 	.driver = {
 		.name = "advk-pcie",
 		.of_match_table = advk_pcie_of_match_table,
+		.pm = &advk_pcie_dev_pm_ops,
 		/* Driver unloading/unbinding currently not supported */
 		.suppress_bind_attrs = true,
 	},
-- 
2.19.1

  parent reply	other threads:[~2018-11-23 14:18 UTC|newest]

Thread overview: 36+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-11-23 14:18 [PATCH 00/12] Bring suspend to RAM support to PCIe Aardvark driver Miquel Raynal
2018-11-23 14:18 ` [PATCH 01/12] PCI: aardvark: configure more registers in the configuration helper Miquel Raynal
2018-11-23 14:18 ` [PATCH 02/12] PCI: aardvark: add reset GPIO support Miquel Raynal
2018-11-23 14:18 ` [PATCH 03/12] PCI: aardvark: add PHY support Miquel Raynal
2018-11-23 14:18 ` [PATCH 04/12] PCI: aardvark: add clock support Miquel Raynal
2018-11-23 14:18 ` Miquel Raynal [this message]
2018-12-03 10:27   ` [PATCH 05/12] PCI: aardvark: add suspend to RAM support Lorenzo Pieralisi
2018-12-03 15:38     ` Miquel Raynal
2018-12-03 17:18       ` Lorenzo Pieralisi
2018-12-03 19:19         ` Stephen Boyd
2018-12-03 22:00       ` Rafael J. Wysocki
2018-12-03 22:18         ` Miquel Raynal
2018-12-04  9:45         ` Lorenzo Pieralisi
2018-12-04 21:42           ` Rafael J. Wysocki
2018-12-05 11:00             ` Lorenzo Pieralisi
2018-12-11 14:16             ` Lorenzo Pieralisi
2018-12-13  9:00               ` Stephen Boyd
2018-12-13 10:53                 ` Lorenzo Pieralisi
2018-12-13 14:30                   ` Miquel Raynal
2018-12-13 14:52                     ` Lorenzo Pieralisi
2018-12-13 21:50                     ` Rafael J. Wysocki
2018-12-17 14:54                       ` Miquel Raynal
2018-12-18 10:54                         ` Rafael J. Wysocki
2018-12-18 14:14                           ` Miquel Raynal
2018-11-23 14:18 ` [PATCH 06/12] dt-bindings: PCI: aardvark: describe the reset-gpios property Miquel Raynal
2018-12-11 21:44   ` Rob Herring
2018-11-23 14:18 ` [PATCH 07/12] dt-bindings: PCI: aardvark: describe the clocks property Miquel Raynal
2018-12-11 21:44   ` Rob Herring
2018-11-23 14:18 ` [PATCH 08/12] dt-bindings: PCI: aardvark: describe the PHY property Miquel Raynal
2018-12-11 21:44   ` Rob Herring
2018-11-23 14:18 ` [PATCH 09/12] ARM64: dts: marvell: armada-37xx: declare PCIe reset pin Miquel Raynal
2018-11-23 14:18 ` [PATCH 10/12] ARM64: dts: marvell: armada-3720-espressobin: declare PCIe reset GPIO Miquel Raynal
2018-11-23 14:18 ` [PATCH 11/12] ARM64: dts: marvell: armada-37xx: declare PCIe clock Miquel Raynal
2018-11-23 14:18 ` [PATCH 12/12] ARM64: dts: marvell: armada-3720-espressobin: declare PCIe PHY Miquel Raynal
2018-11-26 14:50 ` [PATCH 00/12] Bring suspend to RAM support to PCIe Aardvark driver Bjorn Helgaas
2018-11-30 13:12   ` Miquel Raynal

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20181123141831.8214-6-miquel.raynal@bootlin.com \
    --to=miquel.raynal@bootlin.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).