[PATCH AUTOSEL 4.19 08/11] firmware: arm_scmi: Fix possible scmi_linux_errmap buffer overflow

[PATCH AUTOSEL 4.19 08/11] firmware: arm_scmi: Fix possible scmi_linux_errmap buffer overflow

[Sasha Levin]

From: Sudeep Holla <sudeep.holla@arm.com>

[ Upstream commit 7a691f16ccad05d770f813d9c4b4337a30c6d63f ]

The scmi_linux_errmap buffer access index is supposed to depend on the
array size to prevent element out of bounds access. It uses SCMI_ERR_MAX
to check bounds but that can mismatch with the array size. It also
changes the success into -EIO though scmi_linux_errmap is never used in
case of success, it is expected to work for success case too.

It is slightly confusing code as the negative of the error code
is used as index to the buffer. Fix it by negating it at the start and
make it more readable.

Link: https://lore.kernel.org/r/20210707135028.1869642-1-sudeep.holla@arm.com
Reported-by: kernel test robot <lkp@intel.com>
Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Reviewed-by: Cristian Marussi <cristian.marussi@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/firmware/arm_scmi/driver.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c
index effc4c17e0fb..081fbe28da4b 100644
--- a/drivers/firmware/arm_scmi/driver.c
+++ b/drivers/firmware/arm_scmi/driver.c
@@ -48,7 +48,6 @@ enum scmi_error_codes {
 	SCMI_ERR_GENERIC = -8,	/* Generic Error */
 	SCMI_ERR_HARDWARE = -9,	/* Hardware Error */
 	SCMI_ERR_PROTOCOL = -10,/* Protocol Error */
-	SCMI_ERR_MAX
 };
 
 /* List of all SCMI devices active in system */
@@ -168,8 +167,10 @@ static const int scmi_linux_errmap[] = {
 
 static inline int scmi_to_linux_errno(int errno)
 {
-	if (errno < SCMI_SUCCESS && errno > SCMI_ERR_MAX)
-		return scmi_linux_errmap[-errno];
+	int err_idx = -errno;
+
+	if (err_idx >= SCMI_SUCCESS && err_idx < ARRAY_SIZE(scmi_linux_errmap))
+		return scmi_linux_errmap[err_idx];
 	return -EIO;
 }
 
-- 
2.30.2


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

[PATCH AUTOSEL 4.19 09/11] firmware: arm_scmi: Fix range check for the maximum number of pending messages

[Sasha Levin]

From: Cristian Marussi <cristian.marussi@arm.com>

[ Upstream commit bdb8742dc6f7c599c3d61959234fe4c23638727b ]

SCMI message headers carry a sequence number and such field is sized to
allow for MSG_TOKEN_MAX distinct numbers; moreover zero is not really an
acceptable maximum number of pending in-flight messages.

Fix accordingly the checks performed on the value exported by transports
in scmi_desc.max_msg

Link: https://lore.kernel.org/r/20210712141833.6628-3-cristian.marussi@arm.com
Reported-by: Vincent Guittot <vincent.guittot@linaro.org>
Signed-off-by: Cristian Marussi <cristian.marussi@arm.com>
[sudeep.holla: updated the patch title and error message]
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/firmware/arm_scmi/driver.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c
index 081fbe28da4b..af5139eb96b5 100644
--- a/drivers/firmware/arm_scmi/driver.c
+++ b/drivers/firmware/arm_scmi/driver.c
@@ -629,8 +629,9 @@ static int scmi_xfer_info_init(struct scmi_info *sinfo)
 	struct scmi_xfers_info *info = &sinfo->minfo;
 
 	/* Pre-allocated messages, no more than what hdr.seq can support */
-	if (WARN_ON(desc->max_msg >= MSG_TOKEN_MAX)) {
-		dev_err(dev, "Maximum message of %d exceeds supported %ld\n",
+	if (WARN_ON(!desc->max_msg || desc->max_msg > MSG_TOKEN_MAX)) {
+		dev_err(dev,
+			"Invalid maximum messages %d, not in range [1 - %lu]\n",
 			desc->max_msg, MSG_TOKEN_MAX);
 		return -EINVAL;
 	}
-- 
2.30.2


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

[PATCH AUTOSEL 4.19 11/11] ARM: dts: versatile: Fix up interrupt controller node names

[Sasha Levin]

From: Sudeep Holla <sudeep.holla@arm.com>

[ Upstream commit 82a1c67554dff610d6be4e1982c425717b3c6a23 ]

Once the new schema interrupt-controller/arm,vic.yaml is added, we get
the below warnings:

        arch/arm/boot/dts/versatile-ab.dt.yaml:
        intc@10140000: $nodename:0: 'intc@10140000' does not match
        '^interrupt-controller(@[0-9a-f,]+)*$'

	arch/arm/boot/dts/versatile-ab.dt.yaml:
	intc@10140000: 'clear-mask' does not match any of the regexes

Fix the node names for the interrupt controller to conform
to the standard node name interrupt-controller@.. Also drop invalid
clear-mask property.

Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20210701132118.759454-1-sudeep.holla@arm.com'
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 arch/arm/boot/dts/versatile-ab.dts | 5 ++---
 arch/arm/boot/dts/versatile-pb.dts | 2 +-
 2 files changed, 3 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/versatile-ab.dts b/arch/arm/boot/dts/versatile-ab.dts
index 6f4f60ba5429..990b7ef1800e 100644
--- a/arch/arm/boot/dts/versatile-ab.dts
+++ b/arch/arm/boot/dts/versatile-ab.dts
@@ -192,16 +192,15 @@ amba {
 		#size-cells = <1>;
 		ranges;
 
-		vic: intc@10140000 {
+		vic: interrupt-controller@10140000 {
 			compatible = "arm,versatile-vic";
 			interrupt-controller;
 			#interrupt-cells = <1>;
 			reg = <0x10140000 0x1000>;
-			clear-mask = <0xffffffff>;
 			valid-mask = <0xffffffff>;
 		};
 
-		sic: intc@10003000 {
+		sic: interrupt-controller@10003000 {
 			compatible = "arm,versatile-sic";
 			interrupt-controller;
 			#interrupt-cells = <1>;
diff --git a/arch/arm/boot/dts/versatile-pb.dts b/arch/arm/boot/dts/versatile-pb.dts
index 06a0fdf24026..e7e751a858d8 100644
--- a/arch/arm/boot/dts/versatile-pb.dts
+++ b/arch/arm/boot/dts/versatile-pb.dts
@@ -7,7 +7,7 @@ / {
 
 	amba {
 		/* The Versatile PB is using more SIC IRQ lines than the AB */
-		sic: intc@10003000 {
+		sic: interrupt-controller@10003000 {
 			clear-mask = <0xffffffff>;
 			/*
 			 * Valid interrupt lines mask according to
-- 
2.30.2


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel