[PATCH 0/1]

[PATCH 0/1]

[Bastian Germann]

Pinebook uses RTL8723CS for WiFi and bluetooth. Enable it in the device tree.
This was part of a patch series adding RTL8723CS Bluetooth support to btrtl.

Vasily Khoruzhick (1):
  arm64: allwinner: a64: enable Bluetooth on Pinebook

 .../boot/dts/allwinner/sun50i-a64-pinebook.dts      | 13 +++++++++++++
 1 file changed, 13 insertions(+)

-- 
2.37.2


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

[PATCH 1/1] arm64: allwinner: a64: enable Bluetooth on Pinebook

[Bastian Germann]

From: Vasily Khoruzhick <anarsoul@gmail.com>

Pinebook has an RTL8723CS WiFi + BT chip. BT is connected to UART1
and uses PL5 as device wake GPIO and PL6 as host wake GPIO.
The I2C controlling signals are connected to R_I2C bus.

Enable it in the device tree.

Signed-off-by: Vasily Khoruzhick <anarsoul@gmail.com>
Signed-off-by: Bastian Germann <bage@debian.org>
---
 .../boot/dts/allwinner/sun50i-a64-pinebook.dts      | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
index 620cb3ef5f6c..19ba87c411ed 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
@@ -406,6 +406,19 @@ &uart0 {
 	status = "okay";
 };
 
+&uart1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
+	uart-has-rtscts;
+	status = "okay";
+
+	bluetooth {
+		compatible = "realtek,rtl8723cs-bt";
+		device-wake-gpios = <&r_pio 0 5 GPIO_ACTIVE_LOW>; /* PL5 */
+		host-wake-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
+	};
+};
+
 &usb_otg {
 	dr_mode = "host";
 };
-- 
2.37.2


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Re: [PATCH 1/1] arm64: allwinner: a64: enable Bluetooth on Pinebook

[Bastian Germann]

On 08.10.22 at 01:45 Bastian Germann wrote:
> Pinebook has an RTL8723CS WiFi + BT chip. BT is connected to UART1
> and uses PL5 as device wake GPIO and PL6 as host wake GPIO.
> The I2C controlling signals are connected to R_I2C bus.
> 
> Enable it in the device tree.

Hey,

Any chance you have a look at this patch? It has been a month and it was the third time the patch hit the list.
If there is something wrong with it I would appreciate a comment.

Thanks,
Bastian


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Re: [PATCH 1/1] arm64: allwinner: a64: enable Bluetooth on Pinebook

[Samuel Holland]

Hi Bastian,

Please make sure you include the sunxi platform maintainers (as reported
by get_maintainers.pl) when sending your patch, so it gets in our inboxes.

Subject prefix should be "arm64: dts: allwinner: a64:" (with "dts:").

On 10/7/22 18:45, Bastian Germann wrote:
> From: Vasily Khoruzhick <anarsoul@gmail.com>
> 
> Pinebook has an RTL8723CS WiFi + BT chip. BT is connected to UART1
> and uses PL5 as device wake GPIO and PL6 as host wake GPIO.
> The I2C controlling signals are connected to R_I2C bus.

Please remove this sentence; it doesn't make sense. The RTL8723CS does
not have any I2C connection.

> Enable it in the device tree.
> 
> Signed-off-by: Vasily Khoruzhick <anarsoul@gmail.com>
> Signed-off-by: Bastian Germann <bage@debian.org>
> ---
>  .../boot/dts/allwinner/sun50i-a64-pinebook.dts      | 13 +++++++++++++
>  1 file changed, 13 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> index 620cb3ef5f6c..19ba87c411ed 100644
> --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pinebook.dts
> @@ -406,6 +406,19 @@ &uart0 {
>  	status = "okay";
>  };
>  
> +&uart1 {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
> +	uart-has-rtscts;
> +	status = "okay";
> +
> +	bluetooth {
> +		compatible = "realtek,rtl8723cs-bt";
> +		device-wake-gpios = <&r_pio 0 5 GPIO_ACTIVE_LOW>; /* PL5 */

You also need:

		enable-gpios = <&r_pio 0 4 GPIO_ACTIVE_HIGH>; /* PL4 */

(this is BT-RST-N in the schematic).

The rest looks good to me.

Regards,
Samuel

> +		host-wake-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
> +	};
> +};
> +
>  &usb_otg {
>  	dr_mode = "host";
>  };


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel