From: Marc Zyngier <maz@kernel.org>
To: Zenghui Yu <yuzenghui@huawei.com>
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>,
Jason Cooper <jason@lakedaemon.net>,
kvm@vger.kernel.org, Suzuki K Poulose <suzuki.poulose@arm.com>,
linux-kernel@vger.kernel.org, Eric Auger <eric.auger@redhat.com>,
Robert Richter <rrichter@marvell.com>,
James Morse <james.morse@arm.com>,
Julien Thierry <julien.thierry.kdev@gmail.com>,
Thomas Gleixner <tglx@linutronix.de>,
kvmarm@lists.cs.columbia.edu,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH v4 06/20] irqchip/gic-v4.1: Add initial SGI configuration
Date: Tue, 18 Feb 2020 09:46:10 +0000 [thread overview]
Message-ID: <4a64bf17c015cb10e62d9c1a1ff64db5@kernel.org> (raw)
In-Reply-To: <e47baffb-83a5-57d7-1721-eaee28aaaabf@huawei.com>
Hi Zenghui,
On 2020-02-18 07:25, Zenghui Yu wrote:
> Hi Marc,
[...]
>> static void its_sgi_irq_domain_deactivate(struct irq_domain
>> *domain,
>> struct irq_data *d)
>> {
>> - /* Nothing to do */
>> + struct its_vpe *vpe = irq_data_get_irq_chip_data(d);
>> +
>> + vpe->sgi_config[d->hwirq].enabled = false;
>> + its_configure_sgi(d, true);
>
> The spec says, when C==1, VSGI clears the pending state of the vSGI,
> leaving the configuration unchanged. So should we first clear the
> pending state and then disable vSGI (let E==0)?
Right you are again. We need two commands, not just one (the pseudocode
is
pretty explicit).
Thanks,
M.
--
Jazz is not dead. It just smells funny...
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2020-02-18 9:46 UTC|newest]
Thread overview: 47+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-02-14 14:57 [PATCH v4 00/20] irqchip/gic-v4: GICv4.1 architecture support Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 01/20] irqchip/gic-v4.1: Skip absent CPUs while iterating over redistributors Marc Zyngier
2020-02-17 9:11 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 02/20] irqchip/gic-v3: Use SGIs without active state if offered Marc Zyngier
2020-02-17 9:18 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 03/20] irqchip/gic-v4.1: Advertise support v4.1 to KVM Marc Zyngier
2020-02-17 9:09 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 04/20] irqchip/gic-v4.1: Map the ITS SGIR register page Marc Zyngier
2020-02-20 3:17 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 05/20] irqchip/gic-v4.1: Plumb skeletal VSGI irqchip Marc Zyngier
2020-02-20 3:21 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 06/20] irqchip/gic-v4.1: Add initial SGI configuration Marc Zyngier
2020-02-18 7:25 ` Zenghui Yu
2020-02-18 9:46 ` Marc Zyngier [this message]
2020-02-20 3:25 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 07/20] irqchip/gic-v4.1: Plumb mask/unmask SGI callbacks Marc Zyngier
2020-02-20 3:32 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 08/20] irqchip/gic-v4.1: Plumb get/set_irqchip_state " Marc Zyngier
2020-02-18 7:00 ` Zenghui Yu
2020-02-18 9:27 ` Marc Zyngier
2020-02-18 15:31 ` Marc Zyngier
2020-02-19 11:50 ` Zenghui Yu
2020-02-19 15:18 ` Zenghui Yu
2020-02-20 3:11 ` Zenghui Yu
2020-02-28 19:37 ` Marc Zyngier
2020-03-01 19:00 ` Marc Zyngier
2020-03-02 8:18 ` Zenghui Yu
2020-03-02 12:09 ` Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 09/20] irqchip/gic-v4.1: Plumb set_vcpu_affinity " Marc Zyngier
2020-02-20 3:37 ` Zenghui Yu
2020-02-28 19:00 ` Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 10/20] irqchip/gic-v4.1: Move doorbell management to the GICv4 abstraction layer Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 11/20] irqchip/gic-v4.1: Add VSGI allocation/teardown Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 12/20] irqchip/gic-v4.1: Add VSGI property setup Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 13/20] irqchip/gic-v4.1: Eagerly vmap vPEs Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 14/20] KVM: arm64: GICv4.1: Let doorbells be auto-enabled Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 15/20] KVM: arm64: GICv4.1: Add direct injection capability to SGI registers Marc Zyngier
2020-02-18 8:46 ` Zenghui Yu
2020-02-18 9:41 ` Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 16/20] KVM: arm64: GICv4.1: Allow SGIs to switch between HW and SW interrupts Marc Zyngier
2020-02-20 3:55 ` Zenghui Yu
2020-02-28 19:16 ` Marc Zyngier
2020-03-02 2:40 ` Zenghui Yu
2020-02-14 14:57 ` [PATCH v4 17/20] KVM: arm64: GICv4.1: Plumb SGI implementation selection in the distributor Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 18/20] KVM: arm64: GICv4.1: Reload VLPI configuration on distributor enable/disable Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 19/20] KVM: arm64: GICv4.1: Allow non-trapping WFI when using HW SGIs Marc Zyngier
2020-02-14 14:57 ` [PATCH v4 20/20] KVM: arm64: GICv4.1: Expose HW-based SGIs in debugfs Marc Zyngier
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4a64bf17c015cb10e62d9c1a1ff64db5@kernel.org \
--to=maz@kernel.org \
--cc=eric.auger@redhat.com \
--cc=james.morse@arm.com \
--cc=jason@lakedaemon.net \
--cc=julien.thierry.kdev@gmail.com \
--cc=kvm@vger.kernel.org \
--cc=kvmarm@lists.cs.columbia.edu \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=lorenzo.pieralisi@arm.com \
--cc=rrichter@marvell.com \
--cc=suzuki.poulose@arm.com \
--cc=tglx@linutronix.de \
--cc=yuzenghui@huawei.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).