* ETHTOOL set speed support for VNIC_VF Device
@ 2021-03-08 23:07 Bobby Jones
0 siblings, 0 replies; only message in thread
From: Bobby Jones @ 2021-03-08 23:07 UTC (permalink / raw)
To: Sunil Goutham, moderated list:ARM/FREESCALE IMX / MXC ARM ARCHITECTURE
Hi Sunil,
I'm working with a CN8030 based board trying to utilize ethtool's set
speed functionality. Looking at nicvf_ethtool.c in the 5.11.2 kernel I
can see that the ethtool_ops struct defines get_link_ksettings() but
not set_link_ksettings() which is what I'm assuming would be needed
here to use ethtool to set speed/duplex.
Is there a particular reason why eth_set_ksettings was not implemented here?
Is there code somewhere that implements it?
If not, any suggestions on what would need to be done to implement it
myself? I'm relatively new to kernel development but I'm happy to
learn.
Thank you,
Bobby Jones
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2021-03-08 23:09 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2021-03-08 23:07 ETHTOOL set speed support for VNIC_VF Device Bobby Jones
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).