Re: [PATCH v12 1/7] dt-bindings: sun6i-dsi: Document A64 MIPI-DSI controller

[Jagan Teki <jagan@amarulasolutions.com>]

On Tue, Dec 17, 2019 at 12:04 AM Maxime Ripard <mripard@kernel.org> wrote:
>
> On Mon, Dec 16, 2019 at 10:29:08PM +0530, Jagan Teki wrote:
> > On Mon, Dec 16, 2019 at 4:50 PM Maxime Ripard <mripard@kernel.org> wrote:
> > >
> > > On Mon, Dec 16, 2019 at 04:37:20PM +0530, Jagan Teki wrote:
> > > > On Wed, Dec 4, 2019 at 7:06 PM Maxime Ripard <mripard@kernel.org> wrote:
> > > > >
> > > > > On Tue, Dec 03, 2019 at 07:18:10PM +0530, Jagan Teki wrote:
> > > > > > The MIPI DSI controller in Allwinner A64 is similar to A33.
> > > > > >
> > > > > > But unlike A33, A64 doesn't have DSI_SCLK gating so it is valid
> > > > > > to have separate compatible for A64 on the same driver.
> > > > > >
> > > > > > DSI_SCLK uses mod clock-names on dt-bindings, so the same
> > > > > > is not required for A64.
> > > > > >
> > > > > > On that note
> > > > > > - A64 require minimum of 1 clock like the bus clock
> > > > > > - A33 require minimum of 2 clocks like both bus, mod clocks
> > > > > >
> > > > > > So, update dt-bindings so-that it can document both A33,
> > > > > > A64 bindings requirements.
> > > > > >
> > > > > > Reviewed-by: Rob Herring <robh@kernel.org>
> > > > > > Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
> > > > > > ---
> > > > > > Changes for v12:
> > > > > > - Use 'enum' instead of oneOf+const
> > > > > >
> > > > > >  .../display/allwinner,sun6i-a31-mipi-dsi.yaml | 20 +++++++++++++++++--
> > > > > >  1 file changed, 18 insertions(+), 2 deletions(-)
> > > > > >
> > > > > > diff --git a/Documentation/devicetree/bindings/display/allwinner,sun6i-a31-mipi-dsi.yaml b/Documentation/devicetree/bindings/display/allwinner,sun6i-a31-mipi-dsi.yaml
> > > > > > index dafc0980c4fa..b91446475f35 100644
> > > > > > --- a/Documentation/devicetree/bindings/display/allwinner,sun6i-a31-mipi-dsi.yaml
> > > > > > +++ b/Documentation/devicetree/bindings/display/allwinner,sun6i-a31-mipi-dsi.yaml
> > > > > > @@ -15,7 +15,9 @@ properties:
> > > > > >    "#size-cells": true
> > > > > >
> > > > > >    compatible:
> > > > > > -    const: allwinner,sun6i-a31-mipi-dsi
> > > > > > +    enum:
> > > > > > +      - allwinner,sun6i-a31-mipi-dsi
> > > > > > +      - allwinner,sun50i-a64-mipi-dsi
> > > > > >
> > > > > >    reg:
> > > > > >      maxItems: 1
> > > > > > @@ -24,6 +26,8 @@ properties:
> > > > > >      maxItems: 1
> > > > > >
> > > > > >    clocks:
> > > > > > +    minItems: 1
> > > > > > +    maxItems: 2
> > > > > >      items:
> > > > > >        - description: Bus Clock
> > > > > >        - description: Module Clock
> > > > > > @@ -63,13 +67,25 @@ required:
> > > > > >    - reg
> > > > > >    - interrupts
> > > > > >    - clocks
> > > > > > -  - clock-names
> > > > > >    - phys
> > > > > >    - phy-names
> > > > > >    - resets
> > > > > >    - vcc-dsi-supply
> > > > > >    - port
> > > > > >
> > > > > > +allOf:
> > > > > > +  - if:
> > > > > > +      properties:
> > > > > > +         compatible:
> > > > > > +           contains:
> > > > > > +             const: allwinner,sun6i-a31-mipi-dsi
> > > > > > +      then:
> > > > > > +        properties:
> > > > > > +          clocks:
> > > > > > +            minItems: 2
> > > > > > +        required:
> > > > > > +          - clock-names
> > > > > > +
> > > > >
> > > > > Your else condition should check that the number of clocks items is 1
> > > > > on the A64
> > > >
> > > > But the minItems mentioned as 1 in clocks, which is unchanged number
> > > > by default. doesn't it sufficient?
> > >
> > > In the main schema, it's said that the clocks property can have one or
> > > two elements (to cover the A31 case that has one, and the A64 case
> > > that has 2).
> > >
> > > This is fine.
> > >
> > > Later on, you enforce that the A64 has two elements, and this is fine
> > > too.
> >
> > Actually A31 case has 2 and A64 case has 1.
> >
> > >
> > > However, you never check that on the A31 you only have one clock, and
> > > you could very well have two and no one would notice.
> >
> > I did check A31 case for 2 but not in A64. this is what you mean? so
> > adding A64 check like below would fine?
> >
> > allOf:
> >   - if:
> >       properties:
> >          compatible:
> >            contains:
> >              const: allwinner,sun6i-a31-mipi-dsi
>
> You need a new line here

I couldn't see new line before then: in example schema -
https://elixir.bootlin.com/linux/v5.5-rc2/source/Documentation/devicetree/bindings/example-schema.yaml#L208
May be a new changes for this ML or so?

>
> >       then:
>
> This is the wrong level of indentation, it needs to be at the same level than if

True, I have seen it in example schema.

>
> >         properties:
> >           clocks:
> >             minItems: 2
>
> Newline
>
> >         required:
> >           - clock-names
>
> Newline
>
> >   - if:
> >       properties:
> >          compatible:
> >            contains:
> >              const: allwinner,sun50i-a64-mipi-dsi
> >       then:
> >         properties:
> >           clocks:
> >             minItems: 1
>
> (and same thing here).
>
> But yeah, otherwise that's what I meant

Thanks for the detailed review.

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel