* [GIT PULL] Qualcomm ARM64 DT updates for v5.8
@ 2020-05-19 5:25 Bjorn Andersson
0 siblings, 0 replies; only message in thread
From: Bjorn Andersson @ 2020-05-19 5:25 UTC (permalink / raw)
To: arm, soc
Cc: linux-arm-msm, linux-arm-kernel, Andy Gross, Arnd Bergmann,
Olof Johansson, Kevin Hilman, Bryan O'Donoghue,
Stephan Gerhold, Amit Kucheria, Loic Poulain, Sibi Sankar,
Douglas Anderson, Robert Foss, Sandeep Maheswaram, Alex Elder,
Alexey Minnekhanov, Maulik Shah, Michael Srba,
Sai Prakash Ranjan, Sharat Masetty, Ulf Hansson, Craig Tatlor,
Evan Green, Jonathan Marek, Krishna Manikandan,
Matthias Kaehlcke, Mike Leach, Rajendra Nayak, Rajeshwari,
Sivaprakash Murugesan
The following changes since commit 8f3d9f354286745c751374f5f1fcafee6b3f3136:
Linux 5.7-rc1 (2020-04-12 12:35:55 -0700)
are available in the Git repository at:
https://git.kernel.org/pub/scm/linux/kernel/git/qcom/linux.git tags/qcom-arm64-for-5.8
for you to fetch changes up to 7d2f29e49477aa51339e719cf73f0945c39c8a9e:
arm64: dts: qcom: sc7180: Correct the pdc interrupt ranges (2020-05-18 20:08:35 -0700)
----------------------------------------------------------------
Qualcomm ARM64 DT updates for v5.8
For SDM845 this defines the IPA network accelerator and the CCI camera
control bus, it defines the required UFS reset and adds WiFi for the
Lenovo Yoga C630 and defines GPIO pin names and adds OV8856 and OC7251
camera nodes for DB845c.
For SC7180 it adds GPU support, defines the modem remoteproc, adds the
IPA network accelerator, Coresight and ETM support, adds cpuidle low
power states and updates the CPUs' compatible.
For SM8250 it adds regulators from the PM8150, PM8150L and PM8009 and
adds voltage corners, it defines the nodes for UFS PHY and controller
and finally corrects a typo in the PDC node to make SPMI functional.
For MSM8916 I2C1 and I2C5 are defined, a node for the CCI camera control
interface bus is added and Coresight is disabled by default to match
some product configurations. The Samsung A3U gained display support and
Samsung A5U gained touchscreen support.
MSM8996 now property describes the power supply chain for the GPU, the
CCI camera control interface bus is added and the DB820c has the
regulators of the secondary PMIC defined.
For QCS404 USB PHYs and controllers are defined and wired up for the
EVB.
SDM630/SDM660 platform support is added and the Xiaomi Redmi Note 7
defined.
It also contains a number of changes throughout to improve DT binding
compliance.
----------------------------------------------------------------
Alex Elder (2):
arm64: dts: sdm845: add IPA iommus property
arm64: dts: qcom: sc7180: add IPA information
Alexey Minnekhanov (2):
dt-bindings: arm: qcom: Add sdm630 and sdm660 SoCs
arm64: dts: qcom: Add Xiaomi Redmi Note 7 (lavender)
Amit Kucheria (5):
dt-bindings: arm: cpus: Add kryo468 compatible
arm64: dts: qcom: sc7180: Fix cpu compatible
arm64: dts: qcom: msm8916: remove unit name for thermal trip points
arm64: dts: qcom: msm8996: remove unit name for thermal trip points
arm64: dts: qcom: msm8998: remove unit name for thermal trip points
Bjorn Andersson (9):
arm64: dts: qcom: qcs404: Add USB devices and PHYs
arm64: dts: qcom: sm8250: Add rpmhpd node
arm64: dts: qcom: sm8250: Fix PDC compatible and reg
arm64: dts: qcom: db820c: Add pmi8994 RPM regulators
arm64: dts: qcom: db820c: Fix invalid pm8994 supplies
arm64: dts: qcom: c630: Add WiFi node
arm64: dts: qcom: c630: Specify UFS device reset
arm64: dts: qcom: msm8996: Make GPU node control GPU_GX GDSC
arm64: dts: qcom: sc7180: Fix ETMv4 power management patch
Bryan O'Donoghue (7):
arm64: dts: qcom: qcs404-evb: Define VBUS pins
arm64: dts: qcom: qcs404-evb: Define USB ID pin
arm64: dts: qcom: qcs404-evb: Describe external VBUS regulator
arm64: dts: qcom: qcs404-evb: Raise vreg_l12_3p3 minimum voltage
arm64: dts: qcom: qcs404-evb: Enable USB controllers
arm64: dts: qcom: sm8250-mtp: Add pm8150, pm8150l and pm8009
arm64: dts: qcom: sm8250: Add UFS controller and PHY
Craig Tatlor (1):
arm64: dts: qcom: Add SDM660 SoC support
Douglas Anderson (3):
arm64: dts: qcom: sc7180: Swap order of gpucc and sdhc_2
arm64: dts: sdm845: Add "no-hpd" to sn65dsi86 on cheza
arm64: dts: qcom: sc7180: Add "no-map" to cmd_db reserved area
Evan Green (1):
arm64: dts: qcom: sc7180: Include interconnect definitions
Jonathan Marek (1):
arm64: dts: qcom: fix pm8150 gpio interrupts
Krishna Manikandan (1):
arm64: dts: qcom: sc7180: modify assigned clocks for sc7180 target
Loic Poulain (4):
arm64: dts: qcom: msm8916: Add i2c-qcom-cci node
arm64: dts: qcom: apq8016-sbc: Add CCI/Sensor nodes
arm64: dts: msm8996: Fix CSI IRQ types
arch: arm64: dts: msm8996: Add CCI node
Matthias Kaehlcke (1):
arm64: dts: qcom: sc7180: Add interconnect paths for the video codec
Maulik Shah (2):
arm64: dts: qcom: sc7180: Add cpuidle low power states
arm64: dts: qcom: sc7180: Correct the pdc interrupt ranges
Michael Srba (2):
arm64: dts: qcom: msm8916: Disable coresight by default
arm64: dts: qcom: msm8916-samsung-a3u: add nodes for display panel
Mike Leach (1):
arm64: dts: qcom: msm8916: Add CTI options
Rajendra Nayak (1):
arm64: dts: qcom: db820c: Add vdd_gfx and tie it into mmcc
Rajeshwari (1):
arm64: dts: qcom: sc7180: Changed polling mode in Thermal-zones node
Robert Foss (3):
arm64: dts: qcom: sdm845: Add i2c-qcom-cci node
arm64: dts: qcom: sdm845-db845c: Add pm_8998 gpio names
arm64: dts: qcom: sdm845-db845c: Add ov8856 & ov7251 camera nodes
Sai Prakash Ranjan (2):
arm64: dts: qcom: sc7180: Add Coresight support
arm64: dts: qcom: sc7180: Support ETMv4 power management
Sandeep Maheswaram (3):
arm64: dts: qcom: sdm845: Add generic QUSB2 V2 Phy compatible
arm64: dts: qcom: sc7180: Add generic QUSB2 V2 Phy compatible
arm64: dts: qcom: sc7180: Update QUSB2 V2 Phy params for SC7180 IDP device
Sharat Masetty (2):
dt-bindings: arm-smmu: Add sc7180 compatible string
arm64: dts: qcom: sc7180: Add A618 gpu dt blob
Sibi Sankar (4):
arm64: dts: qcom: sdm845: Add SoC compatible to MTP
arm64: dts: qcom: sc7180: Update reserved memory map
arm64: dts: qcom: sc7180: Add Q6V5 MSS node
arm64: dts: qcom: sc7180: Update Q6V5 MSS node
Sivaprakash Murugesan (1):
arm64: dts: ipq8074: qcom: Re-arrange dts nodes based on address
Stephan Gerhold (7):
arm64: dts: qcom: msm8916: Add blsp_i2c1
arm64: dts: qcom: msm8916: Add blsp_i2c5
arm64: dts: qcom: msm8916-samsung-a2015: Add touchscreen regulator
arm64: dts: qcom: msm8916-samsung-a5u: Add touchscreen
arm64: dts: qcom: msm8916: avoid using _ in node names
arm64: dts: qcom: msm8916: move gpu opp table to gpu node
arm64: dts: qcom: apq8016-sbc: merge -pins.dtsi into main .dtsi
Ulf Hansson (2):
arm64: dts: qcom: msm8916: Conform to the domain-idle-state binding
arm64: dts: qcom: msm8916: Conform to the nodename pattern PSCI subnodes
Documentation/devicetree/bindings/arm/cpus.yaml | 1 +
Documentation/devicetree/bindings/arm/qcom.yaml | 7 +
.../devicetree/bindings/iommu/arm,smmu.yaml | 1 +
arch/arm64/boot/dts/qcom/Makefile | 1 +
.../arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi | 74 --
arch/arm64/boot/dts/qcom/apq8016-sbc-soc-pins.dtsi | 89 --
arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi | 257 +++++-
arch/arm64/boot/dts/qcom/apq8096-db820c.dtsi | 53 +-
arch/arm64/boot/dts/qcom/ipq8074-hk01.dts | 112 ++-
arch/arm64/boot/dts/qcom/ipq8074.dtsi | 474 +++++-----
.../boot/dts/qcom/msm8916-longcheer-l8150.dts | 25 +-
arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 221 +++--
.../dts/qcom/msm8916-samsung-a2015-common.dtsi | 98 ++-
.../boot/dts/qcom/msm8916-samsung-a3u-eur.dts | 54 ++
.../boot/dts/qcom/msm8916-samsung-a5u-eur.dts | 35 +
arch/arm64/boot/dts/qcom/msm8916.dtsi | 228 ++++-
arch/arm64/boot/dts/qcom/msm8996.dtsi | 87 +-
arch/arm64/boot/dts/qcom/msm8998.dtsi | 38 +-
arch/arm64/boot/dts/qcom/pm8150.dtsi | 14 +-
arch/arm64/boot/dts/qcom/pm8150b.dtsi | 14 +-
arch/arm64/boot/dts/qcom/pm8150l.dtsi | 14 +-
arch/arm64/boot/dts/qcom/pmi8994.dtsi | 6 +
arch/arm64/boot/dts/qcom/qcs404-evb.dtsi | 85 +-
arch/arm64/boot/dts/qcom/qcs404.dtsi | 100 +++
arch/arm64/boot/dts/qcom/sc7180-idp.dts | 66 +-
arch/arm64/boot/dts/qcom/sc7180.dtsi | 955 +++++++++++++++++++--
.../arm64/boot/dts/qcom/sdm660-xiaomi-lavender.dts | 46 +
arch/arm64/boot/dts/qcom/sdm660.dtsi | 372 ++++++++
arch/arm64/boot/dts/qcom/sdm845-cheza.dtsi | 2 +
arch/arm64/boot/dts/qcom/sdm845-db845c.dts | 210 +++++
arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 2 +-
arch/arm64/boot/dts/qcom/sdm845.dtsi | 98 ++-
.../boot/dts/qcom/sdm850-lenovo-yoga-c630.dts | 13 +
arch/arm64/boot/dts/qcom/sm8250-mtp.dts | 351 ++++++++
arch/arm64/boot/dts/qcom/sm8250.dtsi | 126 ++-
35 files changed, 3528 insertions(+), 801 deletions(-)
delete mode 100644 arch/arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi
delete mode 100644 arch/arm64/boot/dts/qcom/apq8016-sbc-soc-pins.dtsi
create mode 100644 arch/arm64/boot/dts/qcom/sdm660-xiaomi-lavender.dts
create mode 100644 arch/arm64/boot/dts/qcom/sdm660.dtsi
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2020-05-19 5:26 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2020-05-19 5:25 [GIT PULL] Qualcomm ARM64 DT updates for v5.8 Bjorn Andersson
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).