* Re: [PATCH] loop: Call loop_config_discard() only after new config is applied.
2020-03-31 11:41 [PATCH] loop: Call loop_config_discard() only after new config is applied Martijn Coenen
@ 2020-04-14 8:13 ` Martijn Coenen
2020-04-14 8:16 ` Christoph Hellwig
` (2 subsequent siblings)
3 siblings, 0 replies; 6+ messages in thread
From: Martijn Coenen @ 2020-04-14 8:13 UTC (permalink / raw)
To: Jens Axboe, Christoph Hellwig
Cc: Ming Lei, Bart Van Assche, Chaitanya Kulkarni, linux-block, LKML,
kernel-team
Folks, any thoughts about this one?
Thanks,
Martijn
On Tue, Mar 31, 2020 at 1:41 PM Martijn Coenen <maco@android.com> wrote:
>
> loop_set_status() calls loop_config_discard() to configure discard for
> the loop device; however, the discard configuration depends on whether
> the loop device uses encryption, and when we call it the encryption
> configuration has not been updated yet. Move the call down so we apply
> the correct discard configuration based on the new configuration.
>
> Signed-off-by: Martijn Coenen <maco@android.com>
> ---
> drivers/block/loop.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/block/loop.c b/drivers/block/loop.c
> index 739b372a5112..7c9dcb6007a6 100644
> --- a/drivers/block/loop.c
> +++ b/drivers/block/loop.c
> @@ -1312,8 +1312,6 @@ loop_set_status(struct loop_device *lo, const struct loop_info64 *info)
> }
> }
>
> - loop_config_discard(lo);
> -
> memcpy(lo->lo_file_name, info->lo_file_name, LO_NAME_SIZE);
> memcpy(lo->lo_crypt_name, info->lo_crypt_name, LO_NAME_SIZE);
> lo->lo_file_name[LO_NAME_SIZE-1] = 0;
> @@ -1337,6 +1335,8 @@ loop_set_status(struct loop_device *lo, const struct loop_info64 *info)
> lo->lo_key_owner = uid;
> }
>
> + loop_config_discard(lo);
> +
> /* update dio if lo_offset or transfer is changed */
> __loop_update_dio(lo, lo->use_dio);
>
> --
> 2.26.0.rc2.310.g2932bb562d-goog
>
^ permalink raw reply [flat|nested] 6+ messages in thread
* Re: [PATCH] loop: Call loop_config_discard() only after new config is applied.
2020-03-31 11:41 [PATCH] loop: Call loop_config_discard() only after new config is applied Martijn Coenen
2020-04-14 8:13 ` Martijn Coenen
@ 2020-04-14 8:16 ` Christoph Hellwig
2020-04-17 0:19 ` Bob Liu
2020-04-18 15:46 ` Bart Van Assche
3 siblings, 0 replies; 6+ messages in thread
From: Christoph Hellwig @ 2020-04-14 8:16 UTC (permalink / raw)
To: Martijn Coenen
Cc: axboe, hch, ming.lei, bvanassche, Chaitanya.Kulkarni,
linux-block, linux-kernel, kernel-team
On Tue, Mar 31, 2020 at 01:41:16PM +0200, Martijn Coenen wrote:
> loop_set_status() calls loop_config_discard() to configure discard for
> the loop device; however, the discard configuration depends on whether
> the loop device uses encryption, and when we call it the encryption
> configuration has not been updated yet. Move the call down so we apply
> the correct discard configuration based on the new configuration.
>
> Signed-off-by: Martijn Coenen <maco@android.com>
Looks good,
Reviewed-by: Christoph Hellwig <hch@lst.de>
^ permalink raw reply [flat|nested] 6+ messages in thread
* Re: [PATCH] loop: Call loop_config_discard() only after new config is applied.
2020-03-31 11:41 [PATCH] loop: Call loop_config_discard() only after new config is applied Martijn Coenen
2020-04-14 8:13 ` Martijn Coenen
2020-04-14 8:16 ` Christoph Hellwig
@ 2020-04-17 0:19 ` Bob Liu
2020-04-18 15:46 ` Bart Van Assche
3 siblings, 0 replies; 6+ messages in thread
From: Bob Liu @ 2020-04-17 0:19 UTC (permalink / raw)
To: Martijn Coenen, axboe, hch
Cc: ming.lei, bvanassche, Chaitanya.Kulkarni, linux-block,
linux-kernel, kernel-team
On 3/31/20 7:41 PM, Martijn Coenen wrote:
> loop_set_status() calls loop_config_discard() to configure discard for
> the loop device; however, the discard configuration depends on whether
> the loop device uses encryption, and when we call it the encryption
> configuration has not been updated yet. Move the call down so we apply
> the correct discard configuration based on the new configuration.
>
> Signed-off-by: Martijn Coenen <maco@android.com>
Looks fine to me.
Reviewed-by: Bob Liu <bob.liu@oracle.com>
> ---
> drivers/block/loop.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/block/loop.c b/drivers/block/loop.c
> index 739b372a5112..7c9dcb6007a6 100644
> --- a/drivers/block/loop.c
> +++ b/drivers/block/loop.c
> @@ -1312,8 +1312,6 @@ loop_set_status(struct loop_device *lo, const struct loop_info64 *info)
> }
> }
>
> - loop_config_discard(lo);
> -
> memcpy(lo->lo_file_name, info->lo_file_name, LO_NAME_SIZE);
> memcpy(lo->lo_crypt_name, info->lo_crypt_name, LO_NAME_SIZE);
> lo->lo_file_name[LO_NAME_SIZE-1] = 0;
> @@ -1337,6 +1335,8 @@ loop_set_status(struct loop_device *lo, const struct loop_info64 *info)
> lo->lo_key_owner = uid;
> }
>
> + loop_config_discard(lo);
> +
> /* update dio if lo_offset or transfer is changed */
> __loop_update_dio(lo, lo->use_dio);
>
>
^ permalink raw reply [flat|nested] 6+ messages in thread
* Re: [PATCH] loop: Call loop_config_discard() only after new config is applied.
2020-03-31 11:41 [PATCH] loop: Call loop_config_discard() only after new config is applied Martijn Coenen
` (2 preceding siblings ...)
2020-04-17 0:19 ` Bob Liu
@ 2020-04-18 15:46 ` Bart Van Assche
2020-05-04 19:32 ` Martijn Coenen
3 siblings, 1 reply; 6+ messages in thread
From: Bart Van Assche @ 2020-04-18 15:46 UTC (permalink / raw)
To: Martijn Coenen, axboe, hch
Cc: ming.lei, Chaitanya.Kulkarni, linux-block, linux-kernel, kernel-team
On 2020-03-31 04:41, Martijn Coenen wrote:
> loop_set_status() calls loop_config_discard() to configure discard for
> the loop device; however, the discard configuration depends on whether
> the loop device uses encryption, and when we call it the encryption
> configuration has not been updated yet. Move the call down so we apply
> the correct discard configuration based on the new configuration.
Reviewed-by: Bart Van Assche <bvanassche@acm.org>
^ permalink raw reply [flat|nested] 6+ messages in thread
* Re: [PATCH] loop: Call loop_config_discard() only after new config is applied.
2020-04-18 15:46 ` Bart Van Assche
@ 2020-05-04 19:32 ` Martijn Coenen
0 siblings, 0 replies; 6+ messages in thread
From: Martijn Coenen @ 2020-05-04 19:32 UTC (permalink / raw)
To: Jens Axboe
Cc: Christoph Hellwig, Ming Lei, Chaitanya Kulkarni, linux-block,
LKML, kernel-team, Bart Van Assche
Hi Jens,
Are you ok with this one? One of my later series depends on it, but so
far I've kept it separate because it's a bug fix.
Thanks,
Martijn
On Sat, Apr 18, 2020 at 5:46 PM Bart Van Assche <bvanassche@acm.org> wrote:
>
> On 2020-03-31 04:41, Martijn Coenen wrote:
> > loop_set_status() calls loop_config_discard() to configure discard for
> > the loop device; however, the discard configuration depends on whether
> > the loop device uses encryption, and when we call it the encryption
> > configuration has not been updated yet. Move the call down so we apply
> > the correct discard configuration based on the new configuration.
>
> Reviewed-by: Bart Van Assche <bvanassche@acm.org>
^ permalink raw reply [flat|nested] 6+ messages in thread