Re: [PATCH v11 1/3] dt-bindings: PCI: intel: Add YAML schemas for the PCIe RC controller

[Rob Herring <robh@kernel.org>]

On Sun, Dec 8, 2019 at 9:20 PM Dilip Kota <eswara.kota@linux.intel.com> wrote:
>
> Add YAML schemas for PCIe RC controller on Intel Gateway SoCs
> which is Synopsys DesignWare based PCIe core.
>
> Signed-off-by: Dilip Kota <eswara.kota@linux.intel.com>
> Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
> Reviewed-by: Andrew Murray <andrew.murray@arm.com>
> Reviewed-by: Rob Herring <robh@kernel.org>
> ---
>  .../devicetree/bindings/pci/intel-gw-pcie.yaml     | 138 +++++++++++++++++++++
>  1 file changed, 138 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/pci/intel-gw-pcie.yaml
>
> diff --git a/Documentation/devicetree/bindings/pci/intel-gw-pcie.yaml b/Documentation/devicetree/bindings/pci/intel-gw-pcie.yaml
> new file mode 100644
> index 000000000000..db605d8a387d
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/pci/intel-gw-pcie.yaml
> @@ -0,0 +1,138 @@
> +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/pci/intel-gw-pcie.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: PCIe RC controller on Intel Gateway SoCs
> +
> +maintainers:
> +  - Dilip Kota <eswara.kota@linux.intel.com>
> +
> +properties:
> +  compatible:
> +    items:
> +      - const: intel,lgm-pcie
> +      - const: snps,dw-pcie
> +
> +  device_type:
> +    const: pci
> +
> +  "#address-cells":
> +    const: 3
> +
> +  "#size-cells":
> +    const: 2
> +
> +  reg:
> +    items:
> +      - description: Controller control and status registers.
> +      - description: PCIe configuration registers.
> +      - description: Controller application registers.
> +
> +  reg-names:
> +    items:
> +      - const: dbi
> +      - const: config
> +      - const: app
> +
> +  ranges:
> +    maxItems: 1
> +
> +  resets:
> +    maxItems: 1
> +
> +  clocks:
> +    maxItems: 1
> +
> +  phys:
> +    maxItems: 1
> +
> +  phy-names:
> +    const: pcie
> +
> +  reset-gpios:
> +    maxItems: 1
> +
> +  linux,pci-domain: true
> +
> +  num-lanes:
> +    maximum: 2
> +    description: Number of lanes to use for this port.
> +
> +  '#interrupt-cells':
> +    const: 1
> +
> +  interrupt-map-mask:
> +    description: Standard PCI IRQ mapping properties.
> +
> +  interrupt-map:
> +    description: Standard PCI IRQ mapping properties.
> +
> +  max-link-speed:
> +    description: Specify PCI Gen for link capability.
> +    allOf:
> +      - $ref: /schemas/types.yaml#/definitions/uint32
> +      - enum: [ 1, 2, 3, 4 ]
> +      - default: 1
> +
> +  bus-range:
> +    description: Range of bus numbers associated with this controller.
> +
> +  reset-assert-ms:
> +    description: |
> +      Delay after asserting reset to the PCIe device.
> +    maximum: 500
> +    default: 100
> +
> +required:
> +  - compatible
> +  - device_type
> +  - "#address-cells"
> +  - "#size-cells"
> +  - reg
> +  - reg-names
> +  - ranges
> +  - resets
> +  - clocks
> +  - phys
> +  - phy-names
> +  - reset-gpios
> +  - '#interrupt-cells'
> +  - interrupt-map
> +  - interrupt-map-mask
> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/gpio/gpio.h>
> +    #include <dt-bindings/clock/intel,lgm-clk.h>

I guess this is applied now as the example fails to build in
linux-next as this header is missing.

At this point I'd settle for just 'make dt_binding_check' passing on
linux-next even though it should pass on maintainer trees too.
However, it doesn't appear the clock driver with this header is close
to being merged. The binding was sent on Aug 28 and not to the DT list
so I hadn't seen it. Given that, I'd suggest a follow-up patch to
remove the header dependency here. Just change LGM_GCLK_PCIE10 to the
value.

> +    pcie10: pcie@d0e00000 {
> +      compatible = "intel,lgm-pcie", "snps,dw-pcie";
> +      device_type = "pci";
> +      #address-cells = <3>;
> +      #size-cells = <2>;
> +      reg = <0xd0e00000 0x1000>,
> +            <0xd2000000 0x800000>,
> +            <0xd0a41000 0x1000>;
> +      reg-names = "dbi", "config", "app";
> +      linux,pci-domain = <0>;
> +      max-link-speed = <4>;
> +      bus-range = <0x00 0x08>;
> +      interrupt-parent = <&ioapic1>;
> +      #interrupt-cells = <1>;
> +      interrupt-map-mask = <0 0 0 0x7>;
> +      interrupt-map = <0 0 0 1 &ioapic1 27 1>,
> +                      <0 0 0 2 &ioapic1 28 1>,
> +                      <0 0 0 3 &ioapic1 29 1>,
> +                      <0 0 0 4 &ioapic1 30 1>;
> +      ranges = <0x02000000 0 0xd4000000 0xd4000000 0 0x04000000>;
> +      resets = <&rcu0 0x50 0>;
> +      clocks = <&cgu0 LGM_GCLK_PCIE10>;
> +      phys = <&cb0phy0>;
> +      phy-names = "pcie";
> +      reset-assert-ms = <500>;
> +      reset-gpios = <&gpio0 3 GPIO_ACTIVE_LOW>;
> +      num-lanes = <2>;
> +    };
> --
> 2.11.0
>