Re: [PATCH -v2] Staging: iio: Fixed a punctuation and a spelling mistake.

[Andy Shevchenko <andy.shevchenko@gmail.com>]

On Wed, Jul 29, 2020 at 11:12 AM Ankit Baluni
<b18007@students.iitmandi.ac.in> wrote:
>
> Added a missing comma and changed 'it it useful' to 'it is useful'.

Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>

> Signed-off-by: Ankit Baluni <b18007@students.iitmandi.ac.in>
> ---
> Changes in -v2:
>         -Remove space before ':' in subject line.
>
>  drivers/staging/iio/Documentation/overview.txt | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/staging/iio/Documentation/overview.txt b/drivers/staging/iio/Documentation/overview.txt
> index ebdc64f451d7..00409d5dab4e 100644
> --- a/drivers/staging/iio/Documentation/overview.txt
> +++ b/drivers/staging/iio/Documentation/overview.txt
> @@ -9,7 +9,7 @@ The aim is to fill the gap between the somewhat similar hwmon and
>  input subsystems.  Hwmon is very much directed at low sample rate
>  sensors used in applications such as fan speed control and temperature
>  measurement.  Input is, as its name suggests focused on input
> -devices. In some cases there is considerable overlap between these and
> +devices. In some cases, there is considerable overlap between these and
>  IIO.
>
>  A typical device falling into this category would be connected via SPI
> @@ -38,7 +38,7 @@ series and Analog Devices ADXL345 accelerometers.  Each buffer supports
>  polling to establish when data is available.
>
>  * Trigger and software buffer support. In many data analysis
> -applications it it useful to be able to capture data based on some
> +applications it is useful to be able to capture data based on some
>  external signal (trigger).  These triggers might be a data ready
>  signal, a gpio line connected to some external system or an on
>  processor periodic interrupt.  A single trigger may initialize data
> --
> 2.25.1
>


-- 
With Best Regards,
Andy Shevchenko