linux-pm.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Hector Martin <marcan@marcan.st>
To: Marc Zyngier <maz@kernel.org>
Cc: "Rafael J. Wysocki" <rafael@kernel.org>,
	Viresh Kumar <viresh.kumar@linaro.org>,
	Matthias Brugger <matthias.bgg@gmail.com>,
	Sven Peter <sven@svenpeter.dev>,
	Alyssa Rosenzweig <alyssa@rosenzweig.io>,
	Rob Herring <robh+dt@kernel.org>,
	Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
	Stephen Boyd <sboyd@kernel.org>,
	Ulf Hansson <ulf.hansson@linaro.org>,
	Mark Kettenis <mark.kettenis@xs4all.nl>,
	asahi@lists.linux.dev, linux-arm-kernel@lists.infradead.org,
	linux-pm@vger.kernel.org, devicetree@vger.kernel.org,
	linux-kernel@vger.kernel.org
Subject: Re: [PATCH v3 4/5] cpufreq: apple-soc: Add new driver to control Apple SoC CPU P-states
Date: Thu, 10 Nov 2022 00:39:37 +0900	[thread overview]
Message-ID: <cb0466ae-7a6c-20c8-4e90-e4b9b3432e72@marcan.st> (raw)
In-Reply-To: <86v8nop5ts.wl-maz@kernel.org>

On 09/11/2022 23.20, Marc Zyngier wrote:
> On Wed, 09 Nov 2022 12:13:33 +0000,
> Hector Martin <marcan@marcan.st> wrote:
>>
>> On 24/10/2022 17.27, Marc Zyngier wrote:
>>> On Mon, 24 Oct 2022 05:39:24 +0100,
>>> Hector Martin <marcan@marcan.st> wrote:
>>>>
>>>> This driver implements CPU frequency scaling for Apple Silicon SoCs,
>>>> including M1 (t8103), M1 Max/Pro/Ultra (t600x), and M2 (t8112).
>>>>
>>>> Each CPU cluster has its own register set, and frequency management is
>>>> fully automated by the hardware; the driver only has to write one
>>>> register. There is boost frequency support, but the hardware will only
>>>> allow their use if only a subset of cores in a cluster are in
>>>> non-deep-idle. Since we don't support deep idle yet, these frequencies
>>>> are not achievable, but the driver supports them. They will remain
>>>> disabled in the device tree until deep idle is implemented, to avoid
>>>> confusing users.
>>>>
>>>> This driver does not yet implement the memory controller performance
>>>> state tuning that usually accompanies higher CPU p-states. This will be
>>>> done in a future patch.
>>>>
>>>> Signed-off-by: Hector Martin <marcan@marcan.st>
>>>> ---
>>>>  drivers/cpufreq/Kconfig.arm          |   9 +
>>>>  drivers/cpufreq/Makefile             |   1 +
>>>>  drivers/cpufreq/apple-soc-cpufreq.c  | 352 +++++++++++++++++++++++++++
>>>>  drivers/cpufreq/cpufreq-dt-platdev.c |   2 +
>>>>  4 files changed, 364 insertions(+)
>>>>  create mode 100644 drivers/cpufreq/apple-soc-cpufreq.c
>>>>
>>>
>>> [...]
>>>
>>>> +static struct freq_attr *apple_soc_cpufreq_hw_attr[] = {
>>>> +	&cpufreq_freq_attr_scaling_available_freqs,
>>>> +	NULL,
>>>> +	NULL,
>>>
>>> nit: extra NULL?
>>
>> That slot gets filled in later if boost is enabled, hence the need for
>> an extra terminating NULL in that case.
> 
> Right. Consider placing a comment next to the first NULL so that
> someone else doesn't consider it useless and accidentally removes
> it...
> 

Good point, done :)

- Hector

  reply	other threads:[~2022-11-09 15:39 UTC|newest]

Thread overview: 29+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2022-10-24  4:39 [PATCH v3 0/5] Apple SoC cpufreq driver Hector Martin
2022-10-24  4:39 ` [PATCH v3 1/5] MAINTAINERS: Add entries for " Hector Martin
2022-10-24  4:39 ` [PATCH v3 2/5] dt-bindings: cpufreq: apple,soc-cpufreq: Add binding for Apple SoC cpufreq Hector Martin
2022-10-25 16:01   ` Krzysztof Kozlowski
2022-10-25 17:22     ` Hector Martin
2022-10-25 18:56       ` Krzysztof Kozlowski
2022-10-26  4:18         ` Hector Martin
2022-10-26 14:13           ` Krzysztof Kozlowski
2022-10-25 23:12       ` Rob Herring
2022-10-26  4:26         ` Hector Martin
2022-10-24  4:39 ` [PATCH v3 3/5] cpufreq: Generalize of_perf_domain_get_sharing_cpumask phandle format Hector Martin
2022-11-02  5:37   ` Viresh Kumar
2022-10-24  4:39 ` [PATCH v3 4/5] cpufreq: apple-soc: Add new driver to control Apple SoC CPU P-states Hector Martin
2022-10-24  8:27   ` Marc Zyngier
2022-11-09 12:13     ` Hector Martin
2022-11-09 14:20       ` Marc Zyngier
2022-11-09 15:39         ` Hector Martin [this message]
2022-11-01 15:16   ` Ulf Hansson
2022-11-01 18:17     ` Hector Martin
2022-11-14 19:49       ` Ulf Hansson
2022-11-02  6:18   ` Viresh Kumar
2022-11-09 12:36     ` Hector Martin
2022-11-14  6:51       ` Viresh Kumar
2022-11-14  6:57         ` Hector Martin
2022-11-14  7:03           ` Viresh Kumar
2022-11-14 11:06             ` Hector Martin
2022-10-24  4:39 ` [PATCH v3 5/5] arm64: dts: apple: Add CPU topology & cpufreq nodes for t8103 Hector Martin
2022-10-25 16:02   ` Krzysztof Kozlowski
2022-10-24  8:28 ` [PATCH v3 0/5] Apple SoC cpufreq driver Marc Zyngier

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=cb0466ae-7a6c-20c8-4e90-e4b9b3432e72@marcan.st \
    --to=marcan@marcan.st \
    --cc=alyssa@rosenzweig.io \
    --cc=asahi@lists.linux.dev \
    --cc=devicetree@vger.kernel.org \
    --cc=krzysztof.kozlowski+dt@linaro.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pm@vger.kernel.org \
    --cc=mark.kettenis@xs4all.nl \
    --cc=matthias.bgg@gmail.com \
    --cc=maz@kernel.org \
    --cc=rafael@kernel.org \
    --cc=robh+dt@kernel.org \
    --cc=sboyd@kernel.org \
    --cc=sven@svenpeter.dev \
    --cc=ulf.hansson@linaro.org \
    --cc=viresh.kumar@linaro.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).