[PATCH AUTOSEL 5.12 45/63] scsi: ufs: ufs-mediatek: Fix power down spec violation

[PATCH AUTOSEL 5.12 45/63] scsi: ufs: ufs-mediatek: Fix power down spec violation

[Sasha Levin]

From: Peter Wang <peter.wang@mediatek.com>

[ Upstream commit c625b80b9d00f3546722cd77527f9697c8c4c911 ]

As per spec, e.g. JESD220E chapter 7.2, while powering off the UFS device,
RST_N signal should be between VSS(Ground) and VCCQ/VCCQ2. The power down
sequence after fixing:

Power down:

 1. Assert RST_N low

 2. Turn-off VCC

 3. Turn-off VCCQ/VCCQ2

Link: https://lore.kernel.org/r/1620813706-25331-1-git-send-email-peter.wang@mediatek.com
Reviewed-by: Stanley Chu <stanley.chu@mediatek.com>
Signed-off-by: Peter Wang <peter.wang@mediatek.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/scsi/ufs/ufs-mediatek.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/scsi/ufs/ufs-mediatek.c b/drivers/scsi/ufs/ufs-mediatek.c
index a981f261b304..aee3cfc7142a 100644
--- a/drivers/scsi/ufs/ufs-mediatek.c
+++ b/drivers/scsi/ufs/ufs-mediatek.c
@@ -922,6 +922,7 @@ static void ufs_mtk_vreg_set_lpm(struct ufs_hba *hba, bool lpm)
 static int ufs_mtk_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 {
 	int err;
+	struct arm_smccc_res res;
 
 	if (ufshcd_is_link_hibern8(hba)) {
 		err = ufs_mtk_link_set_lpm(hba);
@@ -941,6 +942,9 @@ static int ufs_mtk_suspend(struct ufs_hba *hba, enum ufs_pm_op pm_op)
 			goto fail;
 	}
 
+	if (ufshcd_is_link_off(hba))
+		ufs_mtk_device_reset_ctrl(0, res);
+
 	return 0;
 fail:
 	/*
-- 
2.30.2

[PATCH AUTOSEL 5.12 46/63] scsi: BusLogic: Fix 64-bit system enumeration error for Buslogic

[Sasha Levin]

From: Matt Wang <wwentao@vmware.com>

[ Upstream commit 56f396146af278135c0ff958c79b5ee1bd22453d ]

Commit 391e2f25601e ("[SCSI] BusLogic: Port driver to 64-bit")
introduced a serious issue for 64-bit systems.  With this commit,
64-bit kernel will enumerate 8*15 non-existing disks.  This is caused
by the broken CCB structure.  The change from u32 data to void *data
increased CCB length on 64-bit system, which introduced an extra 4
byte offset of the CDB.  This leads to incorrect response to INQUIRY
commands during enumeration.

Fix disk enumeration failure by reverting the portion of the commit
above which switched the data pointer from u32 to void.

Link: https://lore.kernel.org/r/C325637F-1166-4340-8F0F-3BCCD59D4D54@vmware.com
Acked-by: Khalid Aziz <khalid@gonehiking.org>
Signed-off-by: Matt Wang <wwentao@vmware.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/scsi/BusLogic.c | 6 +++---
 drivers/scsi/BusLogic.h | 2 +-
 2 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/scsi/BusLogic.c b/drivers/scsi/BusLogic.c
index ccb061ab0a0a..7231de2767a9 100644
--- a/drivers/scsi/BusLogic.c
+++ b/drivers/scsi/BusLogic.c
@@ -3078,11 +3078,11 @@ static int blogic_qcmd_lck(struct scsi_cmnd *command,
 		ccb->opcode = BLOGIC_INITIATOR_CCB_SG;
 		ccb->datalen = count * sizeof(struct blogic_sg_seg);
 		if (blogic_multimaster_type(adapter))
-			ccb->data = (void *)((unsigned int) ccb->dma_handle +
+			ccb->data = (unsigned int) ccb->dma_handle +
 					((unsigned long) &ccb->sglist -
-					(unsigned long) ccb));
+					(unsigned long) ccb);
 		else
-			ccb->data = ccb->sglist;
+			ccb->data = virt_to_32bit_virt(ccb->sglist);
 
 		scsi_for_each_sg(command, sg, count, i) {
 			ccb->sglist[i].segbytes = sg_dma_len(sg);
diff --git a/drivers/scsi/BusLogic.h b/drivers/scsi/BusLogic.h
index 6182cc8a0344..e081ad47d1cf 100644
--- a/drivers/scsi/BusLogic.h
+++ b/drivers/scsi/BusLogic.h
@@ -814,7 +814,7 @@ struct blogic_ccb {
 	unsigned char cdblen;				/* Byte 2 */
 	unsigned char sense_datalen;			/* Byte 3 */
 	u32 datalen;					/* Bytes 4-7 */
-	void *data;					/* Bytes 8-11 */
+	u32 data;					/* Bytes 8-11 */
 	unsigned char:8;				/* Byte 12 */
 	unsigned char:8;				/* Byte 13 */
 	enum blogic_adapter_status adapter_status;	/* Byte 14 */
-- 
2.30.2

[PATCH AUTOSEL 5.12 48/63] scsi: pm80xx: Fix drives missing during rmmod/insmod loop

[Sasha Levin]

From: Ajish Koshy <ajish.koshy@microchip.com>

[ Upstream commit d1acd81bd6eb685aa9fef25624fb36d297f6404e ]

When driver is loaded after rmmod some drives are not showing up during
discovery.

SATA drives are directly attached to the controller connected phys.  During
device discovery, the IDENTIFY command (qc timeout (cmd 0xec)) is timing out
during revalidation. This will trigger abort from host side and controller
successfully aborts the command and returns success. Post this successful
abort response ATA library decides to mark the disk as NODEV.

To overcome this, inside pm8001_scan_start() after phy_start() call, add get
start response and wait for few milliseconds to trigger next phy start.
This millisecond delay will give sufficient time for the controller state
machine to accept next phy start.

Link: https://lore.kernel.org/r/20210505120103.24497-1-ajish.koshy@microchip.com
Signed-off-by: Ajish Koshy <ajish.koshy@microchip.com>
Signed-off-by: Viswas G <viswas.g@microchip.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/scsi/pm8001/pm8001_hwi.c  | 10 ++++++----
 drivers/scsi/pm8001/pm8001_init.c |  2 +-
 drivers/scsi/pm8001/pm8001_sas.c  |  7 ++++++-
 drivers/scsi/pm8001/pm80xx_hwi.c  | 12 ++++++------
 4 files changed, 19 insertions(+), 12 deletions(-)

diff --git a/drivers/scsi/pm8001/pm8001_hwi.c b/drivers/scsi/pm8001/pm8001_hwi.c
index 1b1a57f46989..c2a38a172904 100644
--- a/drivers/scsi/pm8001/pm8001_hwi.c
+++ b/drivers/scsi/pm8001/pm8001_hwi.c
@@ -3709,11 +3709,13 @@ static int mpi_hw_event(struct pm8001_hba_info *pm8001_ha, void* piomb)
 	case HW_EVENT_PHY_START_STATUS:
 		pm8001_dbg(pm8001_ha, MSG, "HW_EVENT_PHY_START_STATUS status = %x\n",
 			   status);
-		if (status == 0) {
+		if (status == 0)
 			phy->phy_state = 1;
-			if (pm8001_ha->flags == PM8001F_RUN_TIME &&
-					phy->enable_completion != NULL)
-				complete(phy->enable_completion);
+
+		if (pm8001_ha->flags == PM8001F_RUN_TIME &&
+				phy->enable_completion != NULL) {
+			complete(phy->enable_completion);
+			phy->enable_completion = NULL;
 		}
 		break;
 	case HW_EVENT_SAS_PHY_UP:
diff --git a/drivers/scsi/pm8001/pm8001_init.c b/drivers/scsi/pm8001/pm8001_init.c
index bd626ef876da..4f3ec2bba8c9 100644
--- a/drivers/scsi/pm8001/pm8001_init.c
+++ b/drivers/scsi/pm8001/pm8001_init.c
@@ -1144,8 +1144,8 @@ static int pm8001_pci_probe(struct pci_dev *pdev,
 		goto err_out_shost;
 	}
 	list_add_tail(&pm8001_ha->list, &hba_list);
-	scsi_scan_host(pm8001_ha->shost);
 	pm8001_ha->flags = PM8001F_RUN_TIME;
+	scsi_scan_host(pm8001_ha->shost);
 	return 0;
 
 err_out_shost:
diff --git a/drivers/scsi/pm8001/pm8001_sas.c b/drivers/scsi/pm8001/pm8001_sas.c
index a98d4496ff8b..0a637609504e 100644
--- a/drivers/scsi/pm8001/pm8001_sas.c
+++ b/drivers/scsi/pm8001/pm8001_sas.c
@@ -264,12 +264,17 @@ void pm8001_scan_start(struct Scsi_Host *shost)
 	int i;
 	struct pm8001_hba_info *pm8001_ha;
 	struct sas_ha_struct *sha = SHOST_TO_SAS_HA(shost);
+	DECLARE_COMPLETION_ONSTACK(completion);
 	pm8001_ha = sha->lldd_ha;
 	/* SAS_RE_INITIALIZATION not available in SPCv/ve */
 	if (pm8001_ha->chip_id == chip_8001)
 		PM8001_CHIP_DISP->sas_re_init_req(pm8001_ha);
-	for (i = 0; i < pm8001_ha->chip->n_phy; ++i)
+	for (i = 0; i < pm8001_ha->chip->n_phy; ++i) {
+		pm8001_ha->phy[i].enable_completion = &completion;
 		PM8001_CHIP_DISP->phy_start_req(pm8001_ha, i);
+		wait_for_completion(&completion);
+		msleep(300);
+	}
 }
 
 int pm8001_scan_finished(struct Scsi_Host *shost, unsigned long time)
diff --git a/drivers/scsi/pm8001/pm80xx_hwi.c b/drivers/scsi/pm8001/pm80xx_hwi.c
index c6b0834e3806..5de7adfabd57 100644
--- a/drivers/scsi/pm8001/pm80xx_hwi.c
+++ b/drivers/scsi/pm8001/pm80xx_hwi.c
@@ -3485,13 +3485,13 @@ static int mpi_phy_start_resp(struct pm8001_hba_info *pm8001_ha, void *piomb)
 	pm8001_dbg(pm8001_ha, INIT,
 		   "phy start resp status:0x%x, phyid:0x%x\n",
 		   status, phy_id);
-	if (status == 0) {
+	if (status == 0)
 		phy->phy_state = PHY_LINK_DOWN;
-		if (pm8001_ha->flags == PM8001F_RUN_TIME &&
-				phy->enable_completion != NULL) {
-			complete(phy->enable_completion);
-			phy->enable_completion = NULL;
-		}
+
+	if (pm8001_ha->flags == PM8001F_RUN_TIME &&
+			phy->enable_completion != NULL) {
+		complete(phy->enable_completion);
+		phy->enable_completion = NULL;
 	}
 	return 0;
 
-- 
2.30.2