[PATCH 1/1] serial: stm32: add no_console_suspend support

[PATCH 1/1] serial: stm32: add no_console_suspend support

[Erwan Le Ray]

In order to display console messages in low power mode, console pins
must be kept active after suspend call.

---
Initial patch "serial: stm32: add support for no_console_suspend" was part
of "STM32 usart power improvement" series, but as dependancy to
console_suspend pinctl state has been removed to fit with Rob comment [1],
this patch has no more dependancy with any other patch of this series.

[1] https://lkml.org/lkml/2019/7/9/451

Signed-off-by: Erwan Le Ray <erwan.leray@st.com>

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 9cfcf355567a..5afd29162f6c 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -1425,7 +1425,18 @@ static int __maybe_unused stm32_serial_suspend(struct device *dev)
 	else
 		stm32_serial_enable_wakeup(port, false);
 
-	pinctrl_pm_select_sleep_state(dev);
+	/*
+	 * When "no_console_suspend" is enabled, keep the pinctrl default state
+	 * and rely on bootloader stage to restore this state upon resume.
+	 * Otherwise, apply the idle or sleep states depending on wakeup
+	 * capabilities.
+	 */
+	if (console_suspend_enabled || !uart_console(port)) {
+		if (device_may_wakeup(dev))
+			pinctrl_pm_select_idle_state(dev);
+		else
+			pinctrl_pm_select_sleep_state(dev);
+	}
 
 	return 0;
 }
-- 
2.17.1