Linux-Serial Archive on
 help / color / Atom feed
From: Rajendra Nayak <>
To: Bjorn Andersson <>
	Greg Kroah-Hartman <>,
	Akash Asthana <>,
Subject: Re: [PATCH v6 1/6] tty: serial: qcom_geni_serial: Use OPP API to set clk/perf state
Date: Tue, 30 Jun 2020 17:46:52 +0530
Message-ID: <> (raw)
In-Reply-To: <20200625050808.GW128451@builder.lan>

On 6/25/2020 10:38 AM, Bjorn Andersson wrote:
> On Mon 15 Jun 05:02 PDT 2020, Rajendra Nayak wrote:
>> geni serial needs to express a perforamnce state requirement on CX
>> powerdomain depending on the frequency of the clock rates.
>> Use OPP table from DT to register with OPP framework and use
>> dev_pm_opp_set_rate() to set the clk/perf state.
>> Signed-off-by: Rajendra Nayak <>
>> Reviewed-by: Matthias Kaehlcke <>
>> Cc: Greg Kroah-Hartman <>
>> Cc: Akash Asthana <>
>> Cc:
> Picked up patch 1 and 2 through the qcom tree.

thanks Bjorn

> As Mark requested, please don't lump together patches that doesn't
> actually depend on each other in the same series - it's quite confusing
> to know what to pick and not.

Sorry for the confusion, I will try and split them into driver specific patches henceforth.
For this series though, I see that you have merged the entire ICC series for
QUP and QSPI into for-next of the qcom tree.
In which case it perhaps makes sense for you to pull in the QSPI change from this series
as well? i.e PATCH 6/6.
If so, I will rebase the patch on your for-next and resend (Its already Ack'ed by Mark)


QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation

  reply index

Thread overview: 6+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
     [not found] <>
2020-06-15 12:02 ` Rajendra Nayak
2020-06-25  5:08   ` Bjorn Andersson
2020-06-30 12:16     ` Rajendra Nayak [this message]
2020-06-29 23:17   ` Stephen Boyd
2020-06-30  3:01     ` Rajendra Nayak
2020-06-30  3:05       ` Viresh Kumar

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \ \ \ \ \ \ \ \ \ \ \ \ \ \ \ \

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-Serial Archive on

Archives are clonable:
	git clone --mirror linux-serial/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-serial linux-serial/ \
	public-inbox-index linux-serial

Example config snippet for mirrors

Newsgroup available over NNTP:

AGPL code for this site: git clone