[PATCH v7 4/6] staging: media: wave5: Add TODO file

[PATCH v7 4/6] staging: media: wave5: Add TODO file

[Nas Chung]

Add a TODO file listing all that is need for destaging.

Signed-off-by: Robert Beckett <bob.beckett@collabora.com>
Signed-off-by: Dafna Hirschfeld <dafna.hirschfeld@collabora.com>
Signed-off-by: Nas Chung <nas.chung@chipsnmedia.com>
---
 drivers/staging/media/wave5/TODO | 34 ++++++++++++++++++++++++++++++++
 1 file changed, 34 insertions(+)
 create mode 100644 drivers/staging/media/wave5/TODO

diff --git a/drivers/staging/media/wave5/TODO b/drivers/staging/media/wave5/TODO
new file mode 100644
index 000000000000..070a1171b211
--- /dev/null
+++ b/drivers/staging/media/wave5/TODO
@@ -0,0 +1,34 @@
+* Mutli-stream Test
+
+* Loop Test
+
+* Handle interrupts better
+
+  Currently the interrupt handling uses an unusual design employing a kfifo to
+  transfer irq status to irq thread. This was done as a work around for dropped
+  interrupts seen with IRQF_ONESHOT based handling.
+
+  This needs further investigation and fixing properly, with the aid of
+  C&M and StarFive engineers.
+
+* appropreate error handling:
+allocation failure, mutex acquire failure etc.
+
+* remove all unused struct fields
+
+* change struct fields to 'bool' type or bitfield when appropreate
+Likely good candidates are fields named '*_enable' , '*_on'
+
+* handle vdi_allocate_dma_memory failure , each function has to clean after itself
+
+* make sure that 'u32', 's32' etc. are only used when reading/writing hw
+and change s32 to u32 when s32 is not required
+
+* power management handling - add (runtime_)suspen/resume cb where the clock is enabled
+
+* fix checkpatch issues (mostly fixes , only left to fix MACRO_ARG_REUSE, LONG_LINE)
+
+* revise logic of wave5_vpu_(dec/enc)_register_framebuffer
+
+* check if the  normal kernel endianness/__swab32 routines are sufficient. (instead of the ones
+  implemented in the driver
-- 
2.30.2