Re: [PATCH v2] thermal/drivers/sun8i: Fix some error handling paths in sun8i_ths_probe()

["Ondřej Jirman" <megi@xff.cz>]

Hi Maxime,

On Mon, May 15, 2023 at 01:54:41PM +0200, Maxime Ripard wrote:
> Hi,
> 
> On Sun, May 14, 2023 at 08:46:05PM +0200, Christophe JAILLET wrote:
> > Should an error occur after calling sun8i_ths_resource_init() in the probe
> > function, some resources need to be released, as already done in the
> > .remove() function.
> > 
> > Switch to the devm_clk_get_enabled() helper and add a new devm_action to
> > turn sun8i_ths_resource_init() into a fully managed function.
> > 
> > Move the place where reset_control_deassert() is called so that the
> > recommended order of reset release/clock enable steps is kept.
> > A64 manual states that:
> > 
> > 	3.3.6.4. Gating and reset
> > 
> > 	Make sure that the reset signal has been released before the release of
> > 	module clock gating;
> > 
> > This fixes the issue and removes some LoC at the same time.
> 
> It should really be three different patches:
>  - One to fix the resource release, that can be backported to stable
>    releases
>  - One to switch to devm_clk_get_enabled
>  - and one to change the order of clock enable vs reset deassertion

The order was correct before this patch. I don't think an incorrect order
should be intorduced, even if temporarily between two patches.

regards,
	o.

> Maxime