[PATCH] phy: tegra: Select USB_COMMON for usb_get_maximum_speed()

[PATCH] phy: tegra: Select USB_COMMON for usb_get_maximum_speed()

[Thierry Reding]

From: Thierry Reding <treding@nvidia.com>

The usb_get_maximum_speed() function is part of the usb-common module,
so enable it by selecting the corresponding Kconfig symbol.

While at it, also make sure to depend on USB_SUPPORT because USB_PHY
requires that. This can lead to Kconfig conflicts if USB_SUPPORT is not
enabled while attempting to enable PHY_TEGRA_XUSB.

Reported-by: kbuild test robot <lkp@intel.com>
Suggested-by: Nathan Chancellor <natechancellor@gmail.com>
Signed-off-by: Thierry Reding <treding@nvidia.com>
---
Hi Greg,

sending this directly to you since it fixes a build issue introduced in
the pull request that you merged last week, so it needs to be applied on
top of that.

Thierry

 drivers/phy/tegra/Kconfig | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/phy/tegra/Kconfig b/drivers/phy/tegra/Kconfig
index a208aca4ba7b..c591c958f1eb 100644
--- a/drivers/phy/tegra/Kconfig
+++ b/drivers/phy/tegra/Kconfig
@@ -1,7 +1,8 @@
 # SPDX-License-Identifier: GPL-2.0-only
 config PHY_TEGRA_XUSB
 	tristate "NVIDIA Tegra XUSB pad controller driver"
-	depends on ARCH_TEGRA
+	depends on ARCH_TEGRA && USB_SUPPORT
+	select USB_COMMON
 	select USB_CONN_GPIO
 	select USB_PHY
 	help
-- 
2.24.1