[PATCH] usb: dwc3: omap: improve extcon initialization

[PATCH] usb: dwc3: omap: improve extcon initialization

[Marcel Hamer]

When extcon is used in combination with dwc3, it is assumed that the dwc3
registers are untouched and as such are only configured if VBUS is valid
or ID is tied to ground.

In case VBUS is not valid or ID is floating, the registers are not
configured as such during driver initialization, causing a wrong
default state during boot.

If the registers are not in a default state, because they are for
instance touched by a boot loader, this can cause for a kernel error.

Signed-off-by: Marcel Hamer <marcel@solidxs.se>
---
 drivers/usb/dwc3/dwc3-omap.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/drivers/usb/dwc3/dwc3-omap.c b/drivers/usb/dwc3/dwc3-omap.c
index 3db17806e92e..e196673f5c64 100644
--- a/drivers/usb/dwc3/dwc3-omap.c
+++ b/drivers/usb/dwc3/dwc3-omap.c
@@ -437,8 +437,13 @@ static int dwc3_omap_extcon_register(struct dwc3_omap *omap)
 
 		if (extcon_get_state(edev, EXTCON_USB) == true)
 			dwc3_omap_set_mailbox(omap, OMAP_DWC3_VBUS_VALID);
+		else
+			dwc3_omap_set_mailbox(omap, OMAP_DWC3_VBUS_OFF);
+
 		if (extcon_get_state(edev, EXTCON_USB_HOST) == true)
 			dwc3_omap_set_mailbox(omap, OMAP_DWC3_ID_GROUND);
+		else
+			dwc3_omap_set_mailbox(omap, OMAP_DWC3_ID_FLOAT);
 
 		omap->edev = edev;
 	}
-- 
2.25.1