Linux-Wireless Archive on lore.kernel.org
 help / Atom feed
* [PATCH] brcm80211: remove set but not used variables 'phybw40, maxtargetpwr'
@ 2018-12-20  3:55 YueHaibing
  2019-01-10 11:31 ` [PATCH] brcmsmac: " Kalle Valo
  0 siblings, 1 reply; 2+ messages in thread
From: YueHaibing @ 2018-12-20  3:55 UTC (permalink / raw)
  To: arend.vanspriel, franky.lin, hante.meuleman, chi-hsien.lin,
	wright.feng, plaes, kvalo
  Cc: linux-kernel, netdev, brcm80211-dev-list.pdl, brcm80211-dev-list,
	linux-wireless, YueHaibing

Fixes gcc '-Wunused-but-set-variable' warning:

drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:1202:5: warning: variable 'phybw40' set but not used [-Wunused-but-set-variable]
drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:4625:5: warning: variable 'phybw40' set but not used [-Wunused-but-set-variable]
drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:4834:5: warning: variable 'phybw40' set but not used [-Wunused-but-set-variable]

drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:3085:17: warning: variable 'maxtargetpwr' set but not used [-Wunused-but-set-variable]
drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:4215:17: warning: variable 'maxtargetpwr' set but not used [-Wunused-but-set-variable]

Signed-off-by: YueHaibing <yuehaibing@huawei.com>
---
 .../net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c  | 13 ++-----------
 1 file changed, 2 insertions(+), 11 deletions(-)

diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c
index e78a93a..c6e107f 100644
--- a/drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c
@@ -1199,8 +1199,6 @@ wlc_lcnphy_rx_iq_est(struct brcms_phy *pi,
 {
 	int wait_count = 0;
 	bool result = true;
-	u8 phybw40;
-	phybw40 = CHSPEC_IS40(pi->radio_chanspec);
 
 	mod_phy_reg(pi, 0x6da, (0x1 << 5), (1) << 5);
 
@@ -3082,7 +3080,7 @@ static void wlc_lcnphy_tx_pwr_ctrl_init(struct brcms_phy_pub *ppi)
 	u8 bbmult;
 	struct phytbl_info tab;
 	s32 a1, b0, b1;
-	s32 tssi, pwr, maxtargetpwr, mintargetpwr;
+	s32 tssi, pwr, mintargetpwr;
 	bool suspend;
 	struct brcms_phy *pi = container_of(ppi, struct brcms_phy, pubpi_ro);
 
@@ -3119,7 +3117,6 @@ static void wlc_lcnphy_tx_pwr_ctrl_init(struct brcms_phy_pub *ppi)
 		b0 = pi->txpa_2g[0];
 		b1 = pi->txpa_2g[1];
 		a1 = pi->txpa_2g[2];
-		maxtargetpwr = wlc_lcnphy_tssi2dbm(10, a1, b0, b1);
 		mintargetpwr = wlc_lcnphy_tssi2dbm(125, a1, b0, b1);
 
 		tab.tbl_id = LCNPHY_TBL_ID_TXPWRCTL;
@@ -4212,7 +4209,7 @@ static void wlc_lcnphy_periodic_cal(struct brcms_phy *pi)
 	s8 index;
 	struct phytbl_info tab;
 	s32 a1, b0, b1;
-	s32 tssi, pwr, maxtargetpwr, mintargetpwr;
+	s32 tssi, pwr, mintargetpwr;
 	struct brcms_phy_lcnphy *pi_lcn = pi->u.pi_lcnphy;
 
 	pi->phy_lastcal = pi->sh->now;
@@ -4249,7 +4246,6 @@ static void wlc_lcnphy_periodic_cal(struct brcms_phy *pi)
 		b0 = pi->txpa_2g[0];
 		b1 = pi->txpa_2g[1];
 		a1 = pi->txpa_2g[2];
-		maxtargetpwr = wlc_lcnphy_tssi2dbm(10, a1, b0, b1);
 		mintargetpwr = wlc_lcnphy_tssi2dbm(125, a1, b0, b1);
 
 		tab.tbl_id = LCNPHY_TBL_ID_TXPWRCTL;
@@ -4622,13 +4618,10 @@ static void wlc_lcnphy_radio_init(struct brcms_phy *pi)
 static void wlc_lcnphy_tbl_init(struct brcms_phy *pi)
 {
 	uint idx;
-	u8 phybw40;
 	struct phytbl_info tab;
 	const struct phytbl_info *tb;
 	u32 val;
 
-	phybw40 = CHSPEC_IS40(pi->radio_chanspec);
-
 	for (idx = 0; idx < dot11lcnphytbl_info_sz_rev0; idx++)
 		wlc_lcnphy_write_table(pi, &dot11lcnphytbl_info_rev0[idx]);
 
@@ -4831,9 +4824,7 @@ static void wlc_lcnphy_baseband_init(struct brcms_phy *pi)
 
 void wlc_phy_init_lcnphy(struct brcms_phy *pi)
 {
-	u8 phybw40;
 	struct brcms_phy_lcnphy *pi_lcn = pi->u.pi_lcnphy;
-	phybw40 = CHSPEC_IS40(pi->radio_chanspec);
 
 	pi_lcn->lcnphy_cal_counter = 0;
 	pi_lcn->lcnphy_cal_temper = pi_lcn->lcnphy_rawtempsense;
-- 
2.7.0



^ permalink raw reply	[flat|nested] 2+ messages in thread

* Re: [PATCH] brcmsmac: remove set but not used variables 'phybw40, maxtargetpwr'
  2018-12-20  3:55 [PATCH] brcm80211: remove set but not used variables 'phybw40, maxtargetpwr' YueHaibing
@ 2019-01-10 11:31 ` " Kalle Valo
  0 siblings, 0 replies; 2+ messages in thread
From: Kalle Valo @ 2019-01-10 11:31 UTC (permalink / raw)
  To: YueHaibing
  Cc: arend.vanspriel, franky.lin, hante.meuleman, chi-hsien.lin,
	wright.feng, plaes, linux-kernel, netdev, brcm80211-dev-list.pdl,
	brcm80211-dev-list, linux-wireless, YueHaibing

YueHaibing <yuehaibing@huawei.com> wrote:

> Fixes gcc '-Wunused-but-set-variable' warning:
> 
> drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:1202:5: warning: variable 'phybw40' set but not used [-Wunused-but-set-variable]
> drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:4625:5: warning: variable 'phybw40' set but not used [-Wunused-but-set-variable]
> drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:4834:5: warning: variable 'phybw40' set but not used [-Wunused-but-set-variable]
> 
> drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:3085:17: warning: variable 'maxtargetpwr' set but not used [-Wunused-but-set-variable]
> drivers/net/wireless/broadcom/brcm80211/brcmsmac/phy/phy_lcn.c:4215:17: warning: variable 'maxtargetpwr' set but not used [-Wunused-but-set-variable]
> 
> Signed-off-by: YueHaibing <yuehaibing@huawei.com>

Patch applied to wireless-drivers-next.git, thanks.

6375d40322f0 brcmsmac: remove set but not used variables 'phybw40, maxtargetpwr'

-- 
https://patchwork.kernel.org/patch/10738529/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches


^ permalink raw reply	[flat|nested] 2+ messages in thread

end of thread, back to index

Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2018-12-20  3:55 [PATCH] brcm80211: remove set but not used variables 'phybw40, maxtargetpwr' YueHaibing
2019-01-10 11:31 ` [PATCH] brcmsmac: " Kalle Valo

Linux-Wireless Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-wireless/0 linux-wireless/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-wireless linux-wireless/ https://lore.kernel.org/linux-wireless \
		linux-wireless@vger.kernel.org linux-wireless@archiver.kernel.org
	public-inbox-index linux-wireless


Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-wireless


AGPL code for this site: git clone https://public-inbox.org/ public-inbox