From: Johannes Berg <johannes@sipsolutions.net>
To: Alexander Wetzel <alexander@wetzel-home.de>
Cc: linux-wireless@vger.kernel.org
Subject: Re: [RFC PATCH v3 08/12] iwlwifi: dvm - EXT_KEY_ID A-MPDU API update
Date: Fri, 15 Feb 2019 12:54:15 +0100 [thread overview]
Message-ID: <63fecadcf3f38f24b547143d9d53b3454adc417a.camel@sipsolutions.net> (raw)
In-Reply-To: <20190210210620.31181-9-alexander@wetzel-home.de>
On Sun, 2019-02-10 at 22:06 +0100, Alexander Wetzel wrote:
> When using Extended Key ID mac80211 drops @IEEE80211_TX_CTL_AMPDU for
> the last packet which can be added to a A-MPDU in preparation.
>
> Don't throw a warning and just handle the frame as if
> @IEEE80211_TX_CTL_AMPDU would have been set.
>
> Signed-off-by: Alexander Wetzel <alexander@wetzel-home.de>
> ---
>
> I cold not figure out so far how to make sure the card will not mix
> A-MPDU frames. Looks like that is handled fully in the HW and I didn't
> find any interface to influence it. (It even may work already, I have
> some problems to capture A-MPDU frames with A-MPDU information intact
> and the topic was pretty low on the list so far. After all it works...)
You can't really do that, as far as I can tell, unfortunately. So this
might be better in a "compat on steroids" mode?
johannes
next prev parent reply other threads:[~2019-02-15 11:54 UTC|newest]
Thread overview: 54+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-10 21:06 [RFC PATCH v3 00/12] Draft for Extended Key ID support Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 01/12] mac80211: Optimize tailroom_needed update checks Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 02/12] nl80211/cfg80211: Extended Key ID support Alexander Wetzel
2019-02-15 10:52 ` Johannes Berg
2019-02-17 19:19 ` Alexander Wetzel
2019-02-22 8:30 ` Johannes Berg
2019-02-22 23:04 ` Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 03/12] mac80211: IEEE 802.11 " Alexander Wetzel
2019-02-15 11:06 ` Johannes Berg
2019-02-19 20:58 ` Alexander Wetzel
2019-02-21 19:47 ` Alexander Wetzel
2019-02-22 8:41 ` Johannes Berg
2019-02-23 21:02 ` Alexander Wetzel
2019-03-01 20:43 ` Alexander Wetzel
2019-02-23 17:26 ` Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 04/12] mac80211: Compatibility " Alexander Wetzel
2019-02-15 11:09 ` Johannes Berg
2019-02-21 20:07 ` Alexander Wetzel
2019-02-22 8:53 ` Johannes Berg
2019-02-23 22:50 ` Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 05/12] mac80211: Mark A-MPDU keyid borders for drivers Alexander Wetzel
2019-02-15 11:50 ` Johannes Berg
2019-02-21 21:20 ` Alexander Wetzel
2019-02-22 8:51 ` Johannes Berg
2019-02-23 21:47 ` Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 06/12] mac80211_hwsim: Ext Key ID support (NATIVE) Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 07/12] iwlwifi: Extended " Alexander Wetzel
2019-02-15 11:52 ` Johannes Berg
2019-02-22 20:50 ` Alexander Wetzel
2019-02-22 21:06 ` Johannes Berg
2019-02-24 13:04 ` Alexander Wetzel
2019-04-08 20:10 ` Johannes Berg
2019-04-10 20:46 ` Alexander Wetzel
2019-04-12 9:51 ` Johannes Berg
2019-04-14 16:12 ` Alexander Wetzel
2019-04-15 8:44 ` Johannes Berg
2019-04-15 20:09 ` Alexander Wetzel
2019-04-16 9:31 ` Johannes Berg
2019-04-16 18:28 ` Alexander Wetzel
2019-04-16 19:11 ` Johannes Berg
2019-04-16 21:32 ` Alexander Wetzel
2019-04-12 11:19 ` Johannes Berg
2019-02-10 21:06 ` [RFC PATCH v3 08/12] iwlwifi: dvm - EXT_KEY_ID A-MPDU API update Alexander Wetzel
2019-02-15 11:54 ` Johannes Berg [this message]
2019-02-22 21:15 ` Alexander Wetzel
2019-02-22 21:20 ` Johannes Berg
2019-02-10 21:06 ` [RFC PATCH v3 09/12] ath: Basic Extended Key ID support (COMPAT+NATIVE) Alexander Wetzel
2019-02-13 11:05 ` Kalle Valo
2019-02-13 23:15 ` Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 10/12] ath5k: ath_key_config() API compatibility update Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 11/12] ath9k: Extended Key ID support (COMPAT) Alexander Wetzel
2019-02-10 21:06 ` [RFC PATCH v3 12/12] ath9k: EXT_KEY_ID A-MPDU API update Alexander Wetzel
2019-02-15 11:10 ` [RFC PATCH v3 00/12] Draft for Extended Key ID support Johannes Berg
2019-02-21 20:44 ` Alexander Wetzel
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=63fecadcf3f38f24b547143d9d53b3454adc417a.camel@sipsolutions.net \
--to=johannes@sipsolutions.net \
--cc=alexander@wetzel-home.de \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).