* [PATCH v3] Add some DT nodes for Mediatek MT2701
@ 2017-01-17 9:24 Erin Lo
2017-01-17 9:24 ` [PATCH v3] arm: dts: mt2701: Add thermal device node Erin Lo
0 siblings, 1 reply; 3+ messages in thread
From: Erin Lo @ 2017-01-17 9:24 UTC (permalink / raw)
To: Matthias Brugger
Cc: srv_heupstream, devicetree, linux-arm-kernel, linux-kernel,
linux-mediatek
This patch series based on v4.10-rc2, include MT2701 spi/nand/auxadc/thermal controller DT nodes.
Dependent on "Add clock and power domain DT nodes for Mediatek MT2701"[1].
Change in v3:
1. Since some patches in v2 have been applied to v4.10-next/dts32, they were not included in v3 series.
2. Remove iommu DT nodes since it will be sent with its driver patch series later.
3. Remove ethernet DT nodes since it will be sent with its driver patch series later.
4. Modify thermal resets pin define from hard code to name.
Change in v2:
1. Add spi/auxadc pin setting
2. Add ethernet node and pin setting
3. Add thermal controller node
[1] http://lists.infradead.org/pipermail/linux-mediatek/2016-December/007637.html
Dawei Chien (1):
arm: dts: mt2701: Add thermal device node.
arch/arm/boot/dts/mt2701.dtsi | 43 +++++++++++++++++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)
--
1.9.1
^ permalink raw reply [flat|nested] 3+ messages in thread
* [PATCH v3] arm: dts: mt2701: Add thermal device node.
2017-01-17 9:24 [PATCH v3] Add some DT nodes for Mediatek MT2701 Erin Lo
@ 2017-01-17 9:24 ` Erin Lo
2017-01-24 10:26 ` Matthias Brugger
0 siblings, 1 reply; 3+ messages in thread
From: Erin Lo @ 2017-01-17 9:24 UTC (permalink / raw)
To: Matthias Brugger
Cc: srv_heupstream, devicetree, linux-arm-kernel, linux-kernel,
linux-mediatek, Dawei Chien, Erin Lo
From: Dawei Chien <dawei.chien@mediatek.com>
Add thermal controller device nodes for MT2701.
Signed-off-by: Dawei Chien <dawei.chien@mediatek.com>
Signed-off-by: Erin Lo <erin.lo@mediatek.com>
---
arch/arm/boot/dts/mt2701.dtsi | 43 +++++++++++++++++++++++++++++++++++++++++++
1 file changed, 43 insertions(+)
diff --git a/arch/arm/boot/dts/mt2701.dtsi b/arch/arm/boot/dts/mt2701.dtsi
index 4cfec57..26a88cb 100644
--- a/arch/arm/boot/dts/mt2701.dtsi
+++ b/arch/arm/boot/dts/mt2701.dtsi
@@ -89,6 +89,36 @@
clock-output-names = "rtc32k";
};
+ thermal-zones {
+ cpu_thermal: cpu_thermal {
+ polling-delay-passive = <1000>; /* milliseconds */
+ polling-delay = <1000>; /* milliseconds */
+
+ thermal-sensors = <&thermal 0>;
+ sustainable-power = <1000>;
+
+ trips {
+ threshold: trip-point@0 {
+ temperature = <68000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+
+ target: trip-point@1 {
+ temperature = <85000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+
+ cpu_crit: cpu_crit@0 {
+ temperature = <115000>;
+ hysteresis = <2000>;
+ type = "critical";
+ };
+ };
+ };
+ };
+
timer {
compatible = "arm,armv7-timer";
interrupt-parent = <&gic>;
@@ -270,6 +300,19 @@
status = "disabled";
};
+ thermal: thermal@1100b000 {
+ #thermal-sensor-cells = <0>;
+ compatible = "mediatek,mt2701-thermal";
+ reg = <0 0x1100b000 0 0x1000>;
+ interrupts = <GIC_SPI 70 IRQ_TYPE_LEVEL_LOW>;
+ clocks = <&pericfg CLK_PERI_THERM>, <&pericfg CLK_PERI_AUXADC>;
+ clock-names = "therm", "auxadc";
+ resets = <&pericfg MT2701_PERI_THERM_SW_RST>;
+ reset-names = "therm";
+ mediatek,auxadc = <&auxadc>;
+ mediatek,apmixedsys = <&apmixedsys>;
+ };
+
nandc: nfi@1100d000 {
compatible = "mediatek,mt2701-nfc";
reg = <0 0x1100d000 0 0x1000>;
--
1.9.1
^ permalink raw reply related [flat|nested] 3+ messages in thread
* Re: [PATCH v3] arm: dts: mt2701: Add thermal device node.
2017-01-17 9:24 ` [PATCH v3] arm: dts: mt2701: Add thermal device node Erin Lo
@ 2017-01-24 10:26 ` Matthias Brugger
0 siblings, 0 replies; 3+ messages in thread
From: Matthias Brugger @ 2017-01-24 10:26 UTC (permalink / raw)
To: Erin Lo
Cc: srv_heupstream, devicetree, linux-arm-kernel, linux-kernel,
linux-mediatek, Dawei Chien
On 01/17/2017 10:24 AM, Erin Lo wrote:
> From: Dawei Chien <dawei.chien@mediatek.com>
>
> Add thermal controller device nodes for MT2701.
>
> Signed-off-by: Dawei Chien <dawei.chien@mediatek.com>
> Signed-off-by: Erin Lo <erin.lo@mediatek.com>
> ---
> arch/arm/boot/dts/mt2701.dtsi | 43 +++++++++++++++++++++++++++++++++++++++++++
> 1 file changed, 43 insertions(+)
>
Applied, thanks
> diff --git a/arch/arm/boot/dts/mt2701.dtsi b/arch/arm/boot/dts/mt2701.dtsi
> index 4cfec57..26a88cb 100644
> --- a/arch/arm/boot/dts/mt2701.dtsi
> +++ b/arch/arm/boot/dts/mt2701.dtsi
> @@ -89,6 +89,36 @@
> clock-output-names = "rtc32k";
> };
>
> + thermal-zones {
> + cpu_thermal: cpu_thermal {
> + polling-delay-passive = <1000>; /* milliseconds */
> + polling-delay = <1000>; /* milliseconds */
> +
> + thermal-sensors = <&thermal 0>;
> + sustainable-power = <1000>;
> +
> + trips {
> + threshold: trip-point@0 {
> + temperature = <68000>;
> + hysteresis = <2000>;
> + type = "passive";
> + };
> +
> + target: trip-point@1 {
> + temperature = <85000>;
> + hysteresis = <2000>;
> + type = "passive";
> + };
> +
> + cpu_crit: cpu_crit@0 {
> + temperature = <115000>;
> + hysteresis = <2000>;
> + type = "critical";
> + };
> + };
> + };
> + };
> +
> timer {
> compatible = "arm,armv7-timer";
> interrupt-parent = <&gic>;
> @@ -270,6 +300,19 @@
> status = "disabled";
> };
>
> + thermal: thermal@1100b000 {
> + #thermal-sensor-cells = <0>;
> + compatible = "mediatek,mt2701-thermal";
> + reg = <0 0x1100b000 0 0x1000>;
> + interrupts = <GIC_SPI 70 IRQ_TYPE_LEVEL_LOW>;
> + clocks = <&pericfg CLK_PERI_THERM>, <&pericfg CLK_PERI_AUXADC>;
> + clock-names = "therm", "auxadc";
> + resets = <&pericfg MT2701_PERI_THERM_SW_RST>;
> + reset-names = "therm";
> + mediatek,auxadc = <&auxadc>;
> + mediatek,apmixedsys = <&apmixedsys>;
> + };
> +
> nandc: nfi@1100d000 {
> compatible = "mediatek,mt2701-nfc";
> reg = <0 0x1100d000 0 0x1000>;
>
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2017-01-24 10:26 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2017-01-17 9:24 [PATCH v3] Add some DT nodes for Mediatek MT2701 Erin Lo
2017-01-17 9:24 ` [PATCH v3] arm: dts: mt2701: Add thermal device node Erin Lo
2017-01-24 10:26 ` Matthias Brugger
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).